VD960AW
AHD/960H Fixed 3.6mm Vandal IR Dome Camera
Troubleshooting
Connecting
Notes:
● The power supply must be installed in a dry location. Only use a
power supply with the proper voltage, current and polarity as
required by this camera.
● During severe weather, it is recommended that the product be
disconnected from the power source to prevent damage from
voltage spikes.
● For proper operation, avoid excessive cable lengths.
● Only use the camera in the proper operating temperature range
of -10º to 115ºF.
● Avoid installing in direct sunlight as this can damage the image sensor.
● Do not mount the camera near any heat source.
CAUTION:
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER OR BACK.
NO USER SERVICABLE PARTS INSIDE.
TO PREVENT ELECTRIC SHOCK AND RISK OF FIRE HAZARDS,
DO NOT USE OTHER THAN SPECIFIED POWER SOURCE.
DC12V
VIDEO
DC12V
Power Supply
Monitor/DVR
VIDEO
POWER
Connection Polarity:
GND VIDEO
OSD CONTROL
UP
DOWN
ENTER - PUSH DOWN
LEFT RIGHT
VD960AW
1. No Picture after providing power
~ Check that the power supply is the proper voltage and polarity.
~ Check all connections to DVR.
~ Check the video signal type.
2. The picture has rolling lines or ripples
~ Check for AC power lines running in close proximity to the camera
or its cabling.
~ Check that all connections are securely connected to the DVR.
3. Innaccurate/changing color balance
~ External lighting sources such as fluorescent lamps can confuse
the image sensor. Move the camera or change the light source
in the monitored area.
4. Blurred or hazy image
~ Check that the camera lens is clean and free of any dirt,
fingerprints, moisture.
~ Check that camera lens has not been adjusted out of its focus range.
~ Check that camera has not been disassembled or missing
any moisture seals.
OSD Menu Settings
960H MODE: Hold “left” key 5 sec. AHD MODE: Hold “right” key 5 sec.
System Menu: Push “depress” joystick 5 sec.
MAIN
MENU
MANUAL/DC
LENS
WHITE BAL
DAY &
NIGHT
NR
SPECIAL
ADJUST
SHUTTER
AGC
SENS-UP
BRIGHTNESS
D-WDR
DEFOG
OFF
BLC:LEVEL/AREA/DEFAULT
HSBLC:SELECT AREA/DISPLAY/BLACK MASK/
LEVEL/MODE/DEFAULT
ATW/ATC→SET/INDOOR/OUTDOOR/MANUAL/AWB
EXT
AUTO D→N(AGC)/D→N(DELAY)/
N→D(AGC)/N→D(DELAY)
D→N(DELAY)/N→D(DELAY)
COLOR
B/W BURST/IR SMART/IR PWM
AUTO, 1/30, 1/60, FLK, 1/240, 1/480, 1/1000
1/2000, 1/5000, 1/10000, 1/50000, X2, X4,
X6, X8, X10, X15, X20, X25, X30
0 – 15
AUTO (X2 - X30)/OFF
0 – 100
OFF/ON
OFF/AUTO
2DNR
3DNR
OFF/LOW/MIDDLE/HIGH
OFF/LOW/MIDDLE/HIGH
CAM TITLE OFF/ON
D-EFFECT
FREEZE/MIRROR/NEG.IMAGE
MOTION SELECT AREA1-4/DISPLAY/SENSITIVITY/
COLOR/TRANS/ALARM/DEFAULT
PRIVACY
OFF/ON
LANGUAGE ENG/CHN1/CHN2/GER/FRA/ITA/
SPA/POL/RUS/POR/NED/TUR
DEFECT
LIVE DPC
WHITE DPC
BLACK DPC
RS485
CAM ID:0-255
ID DISPLAY
BAUDRATE:2400/4800/9600/19200/38400
SHARPNESS
AUTO/OFF
LCD/CRT
MONITOR
LSC
OFF/ON
VIDEO.OUT
PAL/NTSC
