Tandberg Data BARCODE READER Bedienungsanleitung

Barcode Reader installation instruction

Rev

. 1.01

2U Autoloader 6.4®LTO3

Installing or removing a Barcode

Reader

Table of Contents

•Content of the kit

•Required tools

•Installing a Barcode Reader

•Configuration of the Barcode Reader

•Barcode labels

•Removing a Barcode Reader

Barcode Reader installation instruction

Rev

. 1.01

Content of the kit

1Barcode reader

Required tools

1 Flat-blade screwdriver; small

Installing a Barcode Reader

1. The barcode reader has to be mounted on the rear side of the autoloader, see

figure.

2. Power down the autoloader.

3. Remove the SCSI cable(s) and power cord from the rear panel of the autoloader

and disconnect the power cord from the outlet.

4. Remove the cover plate from the rear panel. Save the screws!!! Save and store

the cover plate; you may use this plate later after removing the barcode reader.

5. Orient the barcode reader in front of the slot. There is only one correct

orientation. Check whether the holes align.

6. Connect the cable to the barcode controller outlet.

7. Attach the barcode reader with the screws (you saved).

8. Reconnect the SCSI cables and power cord to the autoloader.

Barcode Reader installation instruction

Rev

. 1.01

Configuration of the Barcode Reader

1. The barcode reader is controlled through the host software.

2. The Operator Panel does not indicate that a barcode reader had been added.

3. The autoloader and host system will sense the presence of the barcode reader.

4. By the next power up, the barcode reader is enabled for scanning.

Barcode labels

The barcode reader can only operate, if barcode labels are present on the tape

cartridges. Please make sure that only the appropriate barcode labels are used; and

fixed to the cassettes within the indicated margin:

•Labels: Type

•Margin: The label has to fixed within the cassette deepening opposite of the tape

door

Removing a Barcode Reader

1. Power down the autoloader.

2. Remove the SCSI cable(s) and power cable from the rear panel. Then

disconnect the power cable from the outlet.

3. Unscrew the screws that fix the barcode reader to the rear panel.

4. Unplug the barcode reader connector from the controller outlet.

5. Replace the cover panel to the rear panel.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Tandberg Data Netzwerk-Hardware Handbücher

Tandberg Data

Tandberg Data Tape Backup System DLT4000 Bedienungsanleitung

Tandberg Data

Tandberg Data MSERIES Bedienungsanleitung

Tandberg Data

Tandberg Data RDX QuikStation 4 Bedienungs- und Wartungsanleitung

Tandberg Data

Tandberg Data Magnum 224 Bedienungsanleitung

Tandberg Data

Tandberg Data StorageLoader Bedienungsanleitung

Tandberg Data

Tandberg Data Autoloader Tandberg LTO2 Bedienungsanleitung

Tandberg Data

Tandberg Data SUPERLOADER DLT MAGAZINE Bedienungsanleitung

Tandberg Data

Tandberg Data SLR AUTOLOADER - SERVICE AND Installations- und Betriebsanleitung

Tandberg Data

Tandberg Data SUPERLOADER DLT - Bedienungsanleitung

Tandberg Data

Tandberg Data MSERIES RMC USER Bedienungsanleitung

Tandberg Data

Tandberg Data SLR Bedienungsanleitung

Tandberg Data

Tandberg Data RDX QuikStor Bedienungsanleitung

Tandberg Data

Tandberg Data MSERIES FC USER Bedienungsanleitung

Tandberg Data

Tandberg Data SUPERLOADER Bedienungsanleitung

Tandberg Data

Tandberg Data SLR7-140 PROGRAMMER Bedienungsanleitung

Tandberg Data

Tandberg Data MSERIES USER Bedienungsanleitung

Tandberg Data

Tandberg Data RDX QuikStation 4 Bedienungsanleitung

Beliebte Netzwerk-Hardware Handbücher anderer Marken

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Bedienungsanleitung

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Bedienungsanleitung

Yudor

Yudor YDS-16 Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-320L Bedienungsanleitung

Samsung

Samsung ES1642dc Gebrauchsanweisung

Honeywell Home

Honeywell Home LTEM-PV Montageanleitung

evertz

evertz 7700 Series Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-343 Bedienungsanleitung

Asante

Asante AsanteBridge 1012 Bedienungsanleitung

FireBrick

FireBrick FB2700 Bedienungsanleitung

Audiovox Electronics

Audiovox Electronics ARWH2T Bedienungsanleitung

ADC

ADC DSX-1 Handbuch

NetComm

NetComm NF2 Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 5620 Bedienungsanleitung

Dell EMC

Dell EMC XC6420 Series Bedienungsanleitung

Lanner

Lanner NCA-1020A Bedienungsanleitung

Allied Telesis

Allied Telesis AT-TN121-A Bedienungsanleitung

Arista

Arista CCA-ETM-Q12 Bedienungsanleitung