AFTER SALES SUPPORT
7
and do not allow persons unfamiliar with the
power tool or these instructions to operate the
power tool. Power tools are dangerous in the
hands of untrained users.
e. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tools operation. If damaged, have the power tool
repaired before use. Many accidents are caused
by poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc.
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed. Use of the power
tool for operations different from those intended
could result in a hazardous situation.
Important!
When using the equipment, a few safety
precautions must be observed to avoid injuries
and damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the warning signs on the machine
(Fig. 13)
1. Important. Read the operating instructions.
2. Important. Hot parts. Keep your distance.
3. Important. Switch off the engine before refuelling.
4. Important. Never operate in non-ventilated rooms.
2. Special safety instructions
• No changes may be made to the generator.
• Only original parts may be used for maintenance
and accessories.
• Important: Danger of poisoning, do not inhale
emissions.
• Children are to be kept away from the generator.
• Important: Risk of burns. Do not touch the exhaust
system or drive unit.
• Wear suitable ear protection when in the vicinity
of the equipment.
• Important: Petrol and petrol fumes are highly
combustible or explosive.
• Never operate the generator in non-ventilated
roomsorinthevicinityofeasilyinammable
substances. When operating the generator in
rooms with good ventilation , the exhaust gases
must be channeled directly outdoors through an
exhaust hose.
• Important: Toxic exhaust gases can escape
despitetheexhausthose.Duetothere
hazard, never direct the exhaust hose towards
inammablematerials.
• Risk of explosion: Never operate the generator in
rooms with combustible materials.
• The speed preset by the manufacturer is not
allowed to be changed. The generator or
connected equipment may be damaged.
• Secure the generator against shifting and toppling
during transport.
• Place the generator at least 1m away from buildings
and the equipment connected to it.
• Place the generator in a secure, level position.
• Do not turn, tip or change the generators position
while it is working.
• Always switch off the engine when transporting
and refuelling the generator.
• Make sure that when you refuel the generator no
fuel is spilt on the engine or exhaust pipe.
• Never operate the generator in rain or snow.
• Never touch the generator with wet hands.
• Guard against electric danger. When working
outdoors, use only extension cables that are
approved for outdoor use and which are marked
accordingly (H07RN..).
• The overall length of the extension cables used
may not exceed 50 m for 1.5 mm2and 100 m for
2.5 mm2.
• No changes may be made to the settings of the
motor or generator.
• Repairs and adjustment work may only be carried
out by authorized trained personnel.
• Do not refuel or empty the tank near open lights,
reorsparks.Donotsmoke!
• Do not touch any mechanically driven or hot parts.
Do not remove the safety guards.
• Do not expose the tools to damp or dust.
• Permissible ambient temperature – 10 to + 40°
C, max. altitude above sea level 1000 m, relative
humidity: 90 % (non-condensing)
• The generator is driven by a combustion engine,
which produces heat in the area of the exhaust (on
the opposite side of the sockets) and the exhaust
outlet. You should therefore keep clear of these
surfaces because of risk of skin burns.
• The values quoted in the technical data for sound
power level (LWA) and sound pressure level
(LpA) are emission values and not necessarily
reliable workplace values. As there is a correlation
between emission and immission levels, the
values are not a reliable basis for deciding on any
additional precautions which may be needed.
Factorsinuencingtheactualuserimmissionlevel
include the properties of the work area, other
sound sources etc., the number of machines and
other processes in the vicinity, as well as the time
span in which the operator is subjected to the
noise. Also, the permitted immission level can
vary from country to country. Nevertheless, with
this information the user is able to make a better
assessment of the dangers and risks involved.
• Never use a faulty or damaged electrical equipment
(this also applies to extension cables and plug
connections).
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
andinstructionsmayresultinanelectricshock,re
and/or serious injury.
