- 03 -
SERVICE
Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
ELECTRICAL INFORMATION
ELECTRICAL SAFETY
EXTENSION CORDS
WARNING!
Always remove the power cord plug from the electrical outlet when making adjustments,
changing parts, cleaning or maintaining the tool.
Grounded tools require a three wire extension cord. Double insulated tools can use either a two
or three wire extension cord.
As the distance from the supply outlet increases, you must use a heavier gauge extension cord.
Using extension cords with inadequately sized wire cause a serious drop in voltage, resulting
in loss of power and possible tool damage. (See Table A below.)
The smaller the gauge number of the wire, the greater the capacity of the cord. For example, a
14 gauge cord can carry a higher current than a 16 gauge cord. (See Table A below.)
When using more than one extension cord to make up the total length, make sure each cord
contains at least the minimum wire size required. (See Table A below.)
If you are using one extension cord for more than one tool, add the nameplate amperes and
use the sum to determine the required minimum cord size. (See Table A below.)
If you are using an extension cord outdoors, make sure it is marked with the suffix “W- A” (“W”
1.
2.
3.
4.
5.
6.
Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any
adapter plugs with grounded power tools. Unmodified plugs and matching outlets will reduce
risk of electrical shock.
Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators.
There is an increased risk of electrical shock if your body is grounded.
Do not expose power tool to rain or wet conditions. Water entering a power tool will increase
the risk of electrical shock.
Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges, or moving parts. Damaged or tangled cords
increase the risk of electrical shock.
When operating a power tool outdoors, use one that is suitable for outdoor use. This will reduce
the risk of electrical shock.
If operating a power tool in a damp location is unavoidable, use a Ground Fault Circuit
Interupter (GFCI) protected supply. Use of a GFCI reduces the risk of electric shock.
1.
2.
3.
4.
5.
6.
Store power tools out of the reach of children and do not allow untrained persons to operate the
power tool. Tools are dangerous in the hands of untrained users.
Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and
any other condition that may affect the power tools operation. If damaged, have the power tool
repaired before using. Poorly maintained tools can cause accidents.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less likely to bind and easier to control.
Use the power tool, accessories, tool bits, etc. in accordance with these instructions and in a
manner intended for the particular type of power tool taking into account the working conditions
and the work performed. Use of the power tool for operations different from those intended
could result in a hazardous situation.
5.
6.
7.
