INSTALLATION
Plug the AC/DC adaptor to an AC household outlet, and then plug the DC jack to the back of the unit.
Your clock radio is ready to work for you.
BACKUP BATTERY INSTALLATION
Your clock radio requires one CR2032 lithium battery (not included) to provide backup power to the
clock in the event of a temporary power interruption.
1. Place your unit face down on a flat surface.
2. Slide and remove the battery cover at the bottom of your unit.
3. Insert one new CR2032 lithium battery into the battery compartment with the “+” side facing
up as indicated.
SETTING THE ALARMS
1. Press
AL 1.2 once, the
A1 LED and the hour digits flash. Press
or to set the alarm 1
hour. (hold to advance rapidly).
2. Press
AL 1.2 again to adjust minutes. Press
or to set the alarm 1 minutes. (hold to
advance rapidly).
3. Press AL 1.2 again, LED displays “OFF” (alarm off). To select wake to sound sources, press
or to select :-
rd = wake-by-radio
bu = wake-by-buzzer
OFF = alarm off
4. Press
AL 1.2 again, the A2 LED and the hour digits flash. Press or to set the alarm 2
hour. Repeat step 2) and 3) to set alarm 2.
5. Press
AL1.2again or no button is pressed in around 10 seconds to exit alarm setting mode.
When wake-by-radio or wake-by-buzzer is selected, the related alarm is turned on, indicated
by appearance of the
A1
and / or the A2 LED on the left side of the display.
Note: Alarm function can only be operated at AC mode only.
5
STOP AND RESET THE ALARM TO COME ON THE NEXT DAY
When alarm 1 or 2 is sounding, the related
A1 or A2
LED flashes. Press the RADIO/ SLEEP or AL
1.2once to stop the alarm and reset it to come on the following day. After that, A1
or
A2 icon stays
on the display.
SNOOZE OPERATION (default snooze duration is 5 minutes)
When alarm is sounding, press once, the alarm will be silenced and come on again after
the set snooze duration.
Note: If your second alarm activates while the first alarm is sounding or it is in the snooze mode, the
second alarm overrides the first alarm (the first alarm is reset to come on the next day).
USING THE HI-LO DIMMER
Press to adjust the brightness (HI/ LO/OFF) of the LED display. This can only be done
when the radio is off or the unit is not sounding.
SETTING UP THE FM ANTENNA
Extend the FM wire antenna fully and vary the direction for the best FM reception. Do not strip, alter
or attach to other antennas.
