Teknik Barrister Home 3 Drawer Chest 5418702 Bedienungsanleitung

NOTE: THIS INSTRUCTION

BOOKLET CONTAINS IMPORTANT

SAFETY INFORMATION.

PLEASE READ AND KEEP FOR

FUTURE REFERENCE.

Barrister Home 3 Drawer Chest

Barrister Home Collection | Model 5418702

For things 'n such.

Teknik

www.teknikoffice.co.uk

Table of Contents Assembly Tools Required

5-18

19-21

22-24

25-26

Part Identiﬁcation

Hardware Identiﬁcation

Assembly Steps

Français

Español

Safety

Warranty

Hammer

Not actual size

No. 2 Phillips Screwdriver

Tip Shown Actual Size

Skip the power trip.

This time.

Pae 2

Short Screwdriver

Use of a TV that is too heavy or lare is hazardous. A TV that is too

heavy will create a risk of a tip-over that can cause severe injury

or death. A TV that is too lare for the available space miht be

accidentally pushed or bumped o the furniture, or subject to tip-over.

• Check the size and weiht of your TV. Compare it to the diaram to

the riht – before you begin assembly!

• This Sauder unit is desined for use with televisions weihin less

than 50 pounds. Never use with a TV that weihs more.

• The size of the television, front-to-back and side-to-side, must ﬁt

within the space deﬁned in the diaram.

• Never place the front ede of the TV past the front ede of the TV

support shelf (or stop moldin – if equipped)

• Never allow the sides of the TV to extend past the side edes of

the TV support surface.

• If the TV has a CRT picture tube, the picture tube cone may extend

past the rear of the support shelf.

• Be sure to apply the warnin label as instructed in the last assembly

step. The label provides important safety related information.

WARNING

50 lbs.

16-3/4"

36-1/2"

Tape Measure

Part Identiﬁcation

åWhile not all parts are labeled, some of the parts will have a label or an inked letter on the ede

to help distinuish similar parts from each other. Use this part identiﬁcation to help identify similar parts.

A RIGHT END (1)

B LEFT END (1)

C TOP (1)

D BOTTOM (1)

E BACK (1)

F BRACE (2)

G BASE (1)

H DRAWER FRONT (3)

I RIGHT BASE (1)

J LEFT BASE (1)

K FRONT MOLDING (1)

N RIGHT MOLDING (1)

O LEFT MOLDING (1)

D26 DRAWER RIGHT SIDE (3)

D27 DRAWER LEFT SIDE (3)

D189 DRAWER BACK (3)

D994 DRAWER BOTTOM (3)

M64 DRAWER BRACE (3)

Now you know

our ABCs.

Pae 3

M64

D994

D26

D27

D189

Hardware Identiﬁcation

åScrews are shown actual size. You may receive extra hardware with your unit.

Pae 4

WARNING

Never use this furniture with a TV that is

too large or too heavy. Severe injury or

death can occur.The TV and furniture

will be unstable and may tip.

-The TV must less than 50 lbs.

-The base of the TV must be able to sit

completely on this shelf.

Refer to instruction book for complete

safety information.

Note: This is a permanent label. Do not

try to remove. Surface will be damaged.

08/05 2 6 9 2 2 0 269220

WARNING LABEL - 1

(Refer to Step 13 for proper

location and application)

35AA UNIVERSAL CABINET RAIL - 6 35AC DRAWER RIGHT - 3 35AD DRAWER LEFT - 3

METAL BRACKET - 7

BLACK 9/16" LARGE HEAD SCREW - 14

SILVER 1-1/8" FLAT HEAD SCREW - 7

10S

BLACK 1-1/4" FLAT HEAD SCREW - 4

BLACK 7/8" MACHINE SCREW - 12

37S

3S GOLD 5/16" FLAT HEAD SCREW - 24

METAL PIN - 4

MOLDING

CONNECTOR - 2

19F

10A SLIDE CAM - 6

NAIL - 30

HIDDEN CAM - 15

1F CAM DOWEL - 15

30S BLACK 1-9/16" FLAT HEAD SCREW - 15

KNOB - 12

71K

Step 1

å Assemble your unit on a carpeted ﬂoor or on the empty

carton to avoid scratchin your unit or the ﬂoor.

å Push ﬁfteen HIDDEN CAMS (1F) into the ENDS (A and B),

BOTTOM (D), BRACES (F), and DRAWER BRACES (M64).

Then, insert the metal end of a CAM DOWEL (2F) into

each HIDDEN CAM.

Pae 5

Arrow

(15 used)

Arrow

Do not tihten the HIDDEN CAMS in this step.

Insert the metal end of the CAM

DOWEL into the HIDDEN CAM.

Arrow

M64

Step 2

Pae 6

å Fasten the UNIVERSAL CABINET RAILS* (35AA) to the

ENDS (A and B). Use twelve GOLD 5/16" FLAT HEAD

SCREWS (3S) throuh holes #1 and #3.

å *patent pendin lide system

GOLD 5/16" FLAT HEAD SCREW

(12 used in this step)

Glide end

Finished ede

Surface with

HIDDEN CAMS

Surface with

HIDDEN CAMS

Finished ede

Remember:

Rihty tihty.

Lefty loosey.

å Tap two MOLDING CONNECTORS (19F) into the notches

in the MOLDINGS (K, N, and O).

Step 3

Pae 7

Use your hammer to tap the MOLDING CONNECTORS (19F) into the notches in the MOLDINGS.

Flat end

19F

Unﬁnished surface

Step 4

å Fasten the TOP (C) to the MOLDINGS (K, N, and O). Use

seven SILVER 1-1/8" FLAT HEAD SCREWS (10S).

å NOTE: Do not overtihten the SCREWS into the TOP.

Finished surface

Surface

with holes

Finished surface

SILVER 1-1/8" FLAT HEAD SCREW

(7 used in this step)

10S

Do not overtihten

the SCREWS (10S).

Lon curved ede

Pae 8

StepStep 5

å Fasten the RIGHT END (A) to the RIGHT MOLDING (N).

Tihten two HIDDEN CAMS.

å NOTE: The foam support needs to be at least 1-1/4" thick.

Pae 9

Finished ede

Surface

with

HIDDEN

CAMS

Do not stand the unit upriht without the

BACK fastened. The unit may collapse.

Caution

Start Tighten

Arrow

Minimum

190 derees

Caution

Risk of damae or

injury. HIDDEN CAMS

must be completely

tihtened. HIDDEN

CAMS that are not

completely tihtened

may loosen, and parts

may separate. To

completely tihten:

Arrow

Maximum

210 derees

For support, place

packin foam and

maazines here.

1-1/4" thick

Step

å Insert four METAL PINS (1R) into the ends of the BRACES (F).

å Fasten the BRACES (F) to the RIGHT END (A). Tihten two

HIDDEN CAMS.

å NOTE: Be sure the METAL PINS in the BRACES insert into

the holes in the RIGHT END.

Step 6

Pae 10

Surface with HIDDEN CAMS

(4 used)

Arrow

Minimum

190 derees

Maximum

210 derees

Ede with HIDDEN CAMS

Foam support

Inhaltsverzeichnis

Andere Teknik Inneneinrichtung Handbücher

Teknik

Teknik Barrister Home Lift Up 5420329 Bedienungsanleitung

Teknik

Teknik 5420649 Bedienungsanleitung

Teknik

Teknik Hudson Chunky Desk 5425833 Bedienungsanleitung

Teknik

Teknik Craft 5421407 Bedienungsanleitung

Teknik

Teknik Hampstead Park Narrow Bookcase 5420283 Bedienungsanleitung

Teknik

Teknik Hudson 5425709 Bedienungsanleitung

Teknik

Teknik Boulevard Cafe Desk 5420701 Bedienungsanleitung

Teknik

Teknik City Centre 5427120 Bedienungsanleitung

Teknik

Teknik 5431916 Bedienungsanleitung

Teknik

Teknik Trestle 5410421 Bedienungsanleitung

Teknik

Teknik 5420276 Bedienungsanleitung

Teknik

Teknik Hudson 5425825 Bedienungsanleitung

Teknik

Teknik 5418269 Bedienungsanleitung

Teknik

Teknik 5426484 Bedienungsanleitung

Teknik

Teknik 5414142 Bedienungsanleitung

Teknik

Teknik Elstree L-Shaped Desk 5426914 Bedienungsanleitung

Teknik

Teknik Boutique Style Desk Bedienungsanleitung

Teknik

Teknik Chunky 4 Shelf Bookcase 5422095 Bedienungsanleitung

Teknik

Teknik Hudson Elm finish 5427457 Bedienungsanleitung

Teknik

Teknik City Centre 5426059 Bedienungsanleitung

Teknik

Teknik Credenza 5421317 Bedienungsanleitung

Teknik

Teknik Essentials L-Shaped Desk 5425092 Bedienungsanleitung

Teknik

Teknik 5427030 Bedienungsanleitung

Teknik

Teknik 5431262 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung