3.1 -Mounting
To establish a healthy communication between the coordinator and the devices, pay attention for
following conditions:
•Choosing a proper communication channel will make the communication between the devices
more stable. Channel selection can be made automatically or manually. If manual selection is
to be made, initially all transmissions in the environment must be detected with the RF-
analyzer and according to this, relatively the most available channel must be preferred. See
programming section for manual channel selection.
•The environmental factors such as high voltage lines, structural elements such as columns and
beams, big metal objects, computers, network lines, other cable lines, etc. may interrupt the
connection between the devices. Devices should be mounted at a distance of at least 2 meters
from such factors.
•There must be at least 2 meters of distance from each wireless device.
•If possible, it must be mounted at least 2 meters high from and parallelly to the ground. The
antenna must remain at an angle of 90 degrees to the ground.
•It must be operated under the proper ambient conditions indicated in technical specifications.
Otherwise, the operating performance will be affected.
•A suitable location must be preferred by considering the communication distance.
Communication distance can be seen in technical specifications.
Figure 1 - Open the Cover
The mounting holes of the module are located under the module cover. To access those, the cover
must be opened by gently pushing through the holes on the right side of the module by using a flathead
screwdriver.
3.1.1 -Cable Holes
The holes must be prepared before wall mounting. For this, holes must be open on the round points
marked on the product housing. Before open the holes, the electronic cards must be removed. The
tabs holding the cards must be pulled gently to remove the cards.
Once the electronic cards are removed, a gentle pressure must be applied behind the point to be
broken open to leave a space underneath by using a thick screwdriver to break open the holes. The
cards can be reinstalled and fixed after this procedure.
