Tektronix MTX100 Bedienungsanleitung

Service Manual

MTX100

MPEG Recorder & Player

070-A835-52

This document applies for product serial number

J310101 and above.

Warning

The servicing instructions are for use by qualified

personnel only. To avoid personal injury, do not

perform any servicing unless you are qualified to

do so. Refer to all safety summaries prior to

performing service.

www.tektronix.com

Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication supercedes

that in all previously published material. Specifications and price change privileges reserved.

Tektronix, Inc., P.O. Box 500, Beaverton, OR 97077

TEKTRONIX and TEK are registered trademarks of Tektronix, Inc.

WARRANTY

Tektronix warrants that the products that it manufactures and sells will be free from defects in materials and workmanship

for a period of one (1) year from the date of shipment. If a product proves defective during this warranty period, Tektronix,

at its option, either will repair the defective product without charge for parts and labor, or will provide a replacement in

exchange for the defective product.

In order to obtain service under this warranty, Customer must notify Tektronix of the defect before the expiration of the

warranty period and make suitable arrangements for the performance of service. Customer shall be responsible for

packaging and shipping the defective product to the service center designated by Tektronix, with shipping charges prepaid.

Tektronix shall pay for the return of the product to Customer if the shipment is to a location within the country in which the

Tektronix service center is located. Customer shall be responsible for paying all shipping charges, duties, taxes, and any

other charges for products returned to any other locations.

This warranty shall not apply to any defect, failure or damage caused by improper use or improper or inadequate

maintenance and care. Tektronix shall not be obligated to furnish service under this warranty a) to repair damage resulting

from attempts by personnel other than Tektronix representatives to install, repair or service the product; b) to repair

damage resulting from improper use or connection to incompatible equipment; c) to repair any damage or malfunction

caused by the use of non-Tektronix supplies; or d) to service a product that has been modified or integrated with other

products when the effect of such modification or integration increases the time or difficulty of servicing the product.

THIS WARRANTY IS GIVEN BY TEKTRONIX IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR

IMPLIED. TEKTRONIX AND ITS VENDORS DISCLAIM ANY IMPLIED WARRANTIES OF

MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. TEKTRONIX’ RESPONSIBILITY TO

REPAIR OR REPLACE DEFECTIVE PRODUCTS IS THE SOLE AND EXCLUSIVE REMEDY PROVIDED TO

THE CUSTOMER FOR BREACH OF THIS WARRANTY. TEKTRONIX AND ITS VENDORS WILL NOT BE

LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES IRRESPECTIVE

OF WHETHER TEKTRONIX OR THE VENDOR HAS ADVANCE NOTICE OF THE POSSIBILITY OF SUCH

DAMAGES.

MTX100 MPEG Recorder & Player Service Manual i

Table of Contents

General Safety Summary vii...................................

Service Safety Summary ix....................................

Preface xi...................................................

Manual Structure xi................................................

Manual Conventions xii..............................................

Finding Other Information xii.........................................

Contacting Tektronix xiii.............................................

Introduction xv..............................................

Performance Check Interval xv........................................

Strategy for Servicing xv.............................................

Tektronix Service Offerings xvi........................................

Specifications

Product Overview 1-1.........................................

Specifications 1-3.............................................

Performance Conditions 1-3...........................................

Functional Specifications 1-3..........................................

Electrical Specifications 1-4...........................................

Mechanical (Physical) Characteristics 1-17................................

Environment Characteristics 1-17.......................................

Certifications and Compliances 1-18.....................................

Operating Information

Installation 2-1...............................................

Supplying Operating Power 2-1........................................

Operating Environment 2-3...........................................

Applying and Interrupting Power 2-4....................................

Repackaging Instructions 2-5..........................................

Installed Options 2-6.................................................

Operating Instructions 2-7.....................................

Display Elements 2-7................................................

Basic Menu Operation 2-9............................................

About the Data Output Source 2-12......................................

Table of Contents

ii MTX100 MPEG Recorder & Player Service Manual

Theory of Operation

A10 Main Board 3-1.................................................

A20 PCI Back Plane Board 3-2........................................

A30 Front Panel Board 3-2............................................

A35 Power Switch Board 3-2..........................................

A100 ASI Interface Module (Option 01) 3-3..............................

A110 Universal Parallel/Serial Interface Module (Option 02) 3-4.............

A120 BNC Serial Interface Module (Option 03) 3-4........................

A130 DHEI Interface Module (Option 04) 3-5............................

A140 IEEE 1394 Interface Module (Option 05) 3-6........................

A160 SMPTE310M/ASI Interface Module (Option 06) 3-8..................

Performance Verification

Equipment and Test Signals Required 4-1................................

Procedures 4-3......................................................

Adjustment Procedures

Maintenance

Related Maintenance Procedures 6-1....................................

Preparation 6-2.....................................................

Inspection and Cleaning 6-4...........................................

Removal and Installation Procedures 6-9.........................

Preparation 6-9.....................................................

Access Procedure 6-17................................................

Procedures for External Modules 6-18....................................

Procedure for Board Modules 6-22......................................

Procedure for Internal Modules 6-27.....................................

Procedure for Rear Panel Modules 6-36...................................

Troubleshooting 6-39...........................................

Troubleshooting Trees 6-39............................................

Using the Recovery Discs 6-47...................................

Reinstalling Windows 2000 6-47........................................

Reinstalling the MTX100 Application 6-49................................

Selecting the Serial Interface Standard 6-51........................

Setting the Jumpers 6-51...............................................

Options

Option 01 Description 7-1............................................

Option 02 Description 7-1............................................

Option 03 Description 7-1............................................

Option 04 Description 7-1............................................

Option D1 Description 7-1............................................

Table of Contents

MTX100 MPEG Recorder & Player Service Manual iii

Electrical Parts List

Diagrams

Diagrams 9-1.................................................

Diagrams of the Optional Modules 9-7...........................

A100 ASI Interface Module (Option 01) 9-7..............................

A110 Universal Parallel/Serial Interface Module (Option 02) 9-8.............

A120 BNC Serial Interface Module (Option 03) 9-9........................

A130 DHEI Interface Module (Option 04) 9-10............................

A140 IEEE1394/ASI Interface Module (Option 05) 9-11.....................

A160 SMPTE310M/ASI Interface Module (Option 06) 9-12..................

Mechanical Parts List

Parts Ordering Information 10-1.........................................

Using the Replaceable Parts List 10-2....................................

Table of Contents

iv MTX100 MPEG Recorder & Player Service Manual

List of Figures

Figure 1-1: Timing diagram of the DVB-SPI, universal parallel/serial, and

BNC serial interfaces 1-16...................................

Figure 2-1: Rear panel power connector 2-4.......................

Figure 2-2: Front panel ON/STBY switch 2-5......................

Figure 2-3: Elements of the Play screen 2-8........................

Figure 2-4: Front panel showing the menu controls 2-9..............

Figure 2-5: Display states of the menu commands 2-10...............

Figure 2-6: 10 key Pad 2-11......................................

Figure 4-1: Equipment connection for verifying the internal clock frequency

4-4

Figure 4-2: Equipment connections for verifying the external clock/refer-

ence input 4-5.............................................

Figure 4-3: Equipment connection for verifying the external trigger input.

4-8

Figure 4-4: Initial equipment connection for verifying the SPI interface . . .

4-10

Figure 4-5: Second equipment connection for verifying the SPI interface . .

4-13

Figure 4-6: Initial equipment connection for verifying the ASI interface. . .

4-15

Figure 4-7: Second equipment connections for verifying the ASI interface .

4-17

Figure 4-8: Third equipment connection for verifying the ASI interface . . .

4-18

Figure 4-9: Fourth equipment connection for verifying the ASI interface . .

4-20

Figure 4-10: Initial equipment connection for verifying the universal

parallel/serial interface 4-22..................................

Figure 4-11: Second equipment connection for verifying the Universal

parallel/serial interface 4-25..................................

Figure 4-12: Third equipment connection for verifying the universal

parallel/serial interface 4-31..................................

Figure 4-13: Equipment connection for verifying the EVENT output 4-33

Figure 4-14: Initial equipment connection for verifying the BNC serial

interface 4-34..............................................

Figure 4-15: Second equipment connection for verifying the BNC serial

interface 4-36..............................................

Table of Contents

MTX100 MPEG Recorder & Player Service Manual v

Figure 4-16: Third equipment connections for verifying the BNC interface.

4-40

Figure 4-17: Initial equipment connection for verifying the DHEI interface

4-42

Figure 4-18: Second equipment connection for verifying the DHEI interface

4-44

Figure 4-19: Third equipment connection for verifying the DHEI interface.

4-47

Figure 4-20: IEEE1394/ASI interface test initial hookup 4-49.........

Figure 4-21: ASI interface Play operation test 4-51..................

Figure 4-22: ASI interface Record operation test 4-52................

Figure 4-23: ASI interface recorded files check 4-53.................

Figure 4-24: IEEE1394 interface test 4-55..........................

Figure 4-25: Initial equipment connection for verifying the SMPTE310M

interface 4-57..............................................

Figure 4-26: SMPTE310M/ASI interface test 4-59...................

Figure 4-27: SMPTE310M/ASI interface Record operation test 4-60...

Figure 4-28: ASI interface recorded files check 4-62.................

Figure 4-29: SMPTE310M/8VSB interface test 4-64.................

Figure 4-30: SMPTE 310M/8VSB interface Record operation test 4-65.

Figure 4-31: 8VSB interface recorded files check 4-67................

Figure 6-1: MTX100 orientation 6-12.............................

Figure 6-2: External modules 6-13................................

Figure 6-3: Board modules 6-14..................................

Figure 6-4: Internal modules 6-15................................

Figure 6-5: Rear panel modules 6-16..............................

Figure 6-6: Guide to removal procedures 6-17......................

Figure 6-7: Cabinet and protective cover removal 6-19...............

Figure 6-8: Front-panel unit removal 6-20.........................

Figure 6-9: Disassembly of front-panel assembly 6-22................

Figure 6-10: CPU board, A10 Main board, interface module, and A20 PCI

Back Plane board removal 6-25...............................

Figure 6-11: CD-ROM drive removal 6-29.........................

Figure 6-12: Hard disk drive removal 6-30.........................

Figure 6-13: Internal and external fans removal 6-32................

Figure 6-14: 5 V main power supply and A40 AC Distributer board removal

6-34

Figure 6-15: RFI filter removal 6-35..............................

Figure 6-16: Rear panel modules removal 6-37.....................

Figure 6-17: Troubleshooting procedure (1) 6-40....................

Table of Contents

vi MTX100 MPEG Recorder & Player Service Manual

Figure 6-18: Troubleshooting procedure (2) 6-41....................

Figure 6-19: Troubleshooting procedure (3) 6-42....................

Figure 6-20: Troubleshooting procedure (4) 6-43....................

Figure 6-21: Troubleshooting procedure (5) 6-44....................

Figure 6-22: A20 PCI Back Plane board view 6-45..................

Figure 6-23: Location of the JP9 connector 6-51....................

Figure 9-1: MTX100 block diagram 9--3..........................

Figure 9-2: MTX100 interconnect diagram 9--5....................

Figure 9-3: A100 ASI Interface module connections 9-7.............

Figure 9-4: A110 Universal Parallel/Serial Interface module connections. . .

9-8

Figure 9-5: A120 BNC Interface module connections 9-9............

Figure 9-6: A130 DHEI Interface module connections 9-10...........

Figure 9-7: A140 IEEE1394/ASI Interface module connections 9-11....

Figure 9-8: A160 SMPTE310M/ASI Interface module connections 9-12.

Figure 10-1: Cabinet 10-5.......................................

Figure 10-2: Front panel unit 10-7................................

Figure 10-3: Internal modules (1) 10-9............................

Figure 10-4: Internal modules (2) 10-11............................

Figure 10-5: Internal modules (3) 10-13............................

Figure 10-6: CD-ROM unit 10-14..................................

Figure 10-7: Hard Disk Drive unit 10-15............................

Andere Handbücher für MTX100

Inhaltsverzeichnis

Andere Tektronix Drehscheibe Handbücher

Tektronix

Tektronix MTX100B Gebrauchs- und Pflegehandbuch

Beliebte Drehscheibe Handbücher anderer Marken

Gemini

Gemini CDT-05 MKII Bedienungsanleitung

Rotel

Rotel RP-820 Bedienungsanleitung

Shuman

Shuman MC-250BT Bedienungsanleitung

Stanton

Stanton STR8-150 Bedienungsanleitung

Audio Technica

Audio Technica AT-LPW40WN Bedienungsanleitung

Crosley

Crosley McQueen CR7011-GY Bedienungsanleitung

Reloop

Reloop SMP-1 Bedienungsanleitung

auna

auna TT-Classic Plus Bedienungsanleitung

COMO AUDIO

COMO AUDIO Turntable Analog Bedienungsanleitung

Dual

Dual 1009 F Bedienungsanleitung

REED

REED Muse3C Bedienungsanleitung

AXIOMTEK

AXIOMTEK OPS883-H Series Bedienungsanleitung

Pioneer

Pioneer PL-71 Bedienungsanleitung

Vestax

Vestax PDX-a1 Bedienungsanleitung

Denon

Denon DP-400 Bedienungsanleitung

Dual

Dual 504 Bedienungsanleitung

Audio-Techica

Audio-Techica AT-LP60XBT Bedienungsanleitung

Goldring

Goldring G99 Bedienungsanleitung