Model 861 Quick Setup
1801 SE Commerce Avenue Tel 360-723-5360 [email protected]Battle Ground, WA 98604, USA Fax 360-723-5368 www.telemark.comMADE IN USA4CONFIGURING THE 861 SYSTEM, see the 861 manual for more detailsFull manual is found on the included USB drive in pdf form1. Setup – Display: Parameters affecting the display 2. Setup – Utility: Miscellaneous parameters such as, crystal frequency, sound volumes, date and time 3. Setup – Source: number of pockets, shutter, indexer, source voltage, etc. 4. Setup – Sensor: number of crystals, shutter, indexer, etc. 5. Setup – Inputs: Setup of user defined inputs and system defined inputs. User defined inputs are used to trigger outputs and actions. System defined inputs are automatically created by the 861 for source and sensor selection feedback. After the inputs are created the D connector pins can be changed if needed. Setup outputs and actions may need to be changed after materials and processes are defined because they can be used in condition strings 6. Setup – Outputs: User defined outputs and system defined outputs. User defined outputs can be triggered by condition strings. System defined outputs are automatically created by the 861 for source and sensor selection and shutter control. After the outputs are created the D connector pins can be changed if needed. 7. Setup – Actions: 16 internal user programmable actions can be used to provide special functions upon the true evaluation of a condition string. These functions may be such things as terminating a deposit on an input from an optical monitor or sounding an alarm when certain events are true.
DEFINE MATERIALS AND PROCESSES, see the 861 manual for more details
1. Materials: Parameters affecting the deposition of each material: density, impedance, source#, pocket#, sensor#, etc. 2. Process: Describes the layers of a process. Once a material has been created in the 861 then it can be added to a process layer and given a thickness. There can be up to 99 layers per process.
5Typical process profile of one layer defined by material settings0100%PowerTime
Start “Soak Rise”Start “Soak Hold”Start “Predeposit Rise”Start “Predeposit Hold”Start “Establish Rate”Start “Deposit #1” (Open Shutter)Start “Rate Ramp #1”End “Rate Ramp #1”End deposit (Close Shutter)Start “Ramp To Idle”Start “Idle”
Idle4 possible ramps
End LayerStart Layer
