Telonics PRE-1000 Preamplifier
6
PB-00xxxx Rev
PRE-1000
P
REAMP
ONTROL
F
UN TIONS
,
J
A KS
,
&
I
NDI ATORS
:
F
RONT
P
ANEL
(
ONTINUED
)
BRO This switch will activate a “Bro” type effect. The LED will light when Bro is
active. The Foot Switch connector on the rear panel will t rn Bro off and on if
the BRO switch is p shed on (in). If either switch is in the off position, the effect
will be off. When the foot switch is not sed, the defa lt is on. (See back panel
Foot Switch)
HU The HU switch will activate a h m red ction circ it to minimize h m from
single coil pick ps. The HU circ it will red ce 60 Hz h m abo t 20dB. The
LED will light when h m eliminator circ it is active.
Reverb Level This level controls how m ch of the internal reverb signal is applied to the
Wet/Dry Fader control. The inp t level to the reverb circ it is affected by the
Input Gain control level. The reverb inp t is a combination of the dry inp t after
the Tone controls and the Post EQ EFX Return signal (rear panel).
WET/DRY Fader This fader controls the amo nt of wet or dry signal sent to the aster Level
control. F ll co nter clockwise is dry, f ll clockwise is wet.
Reverb On This LED indicates if the Foot Switch has disabled the reverb. When the LED is
on, the internal reverb is active and controlled by the Reverb Level control.
When the LED is off, the Foot Switch has disabled the reverb signal. With no
foot switch, the defa lt is on.
AUX / Stereo
INPUT
Use a ¼ inch stereo pl g to inject a dio from a CD or MP3 player for home
practice or live gigs. There are two stereo inp t connectors. Insertion of a pl g
into the front panel inp t connector a to-disconnects rear inp t connector. Use
the A x level control to set m sic level. Can also be sed as a second
effects ret rn.
