Tenda TWL5401A Bedienungsanleitung
Copyright Statement
is the registered trademark of Shenzhen Tenda
Technology Co., Ltd. Other trademark or trade name mentioned
herein are the trademark or registered trademark of the company.
Copyright of the whole product as integration, including its
accessories and software, belongs to Shenzhen Tenda
Technology Co., Ltd. Without the permission of Shenzhen Tenda
Technology Co., Ltd, individual or party is not allowed to copy,
plagiarize, imitate or translate it into other languages.
All the photos and product specifications mentioned in this
manual are for references only, as the upgrading of software and
hardware, there will be changes. And if there are changes, Tenda
is not responsible for informing in advance. If you want to know
more about our products information, please visit our website at
www.tenda.cn
Table of Contents
CHAPTER ONE PRODUCTION DESCRIPTION ............ 1
1.1 SPECIFICATION ..........................................................1
1.2 UNPACKING ...............................................................2
CHAPTER TWO INSTALLATION .................................... 3
2.1 BEFORE INSTALLATION ...............................................3
2.2 STEPS FOR HARDWARE INSTALLATION.........................3
CHAPTER THREE CONFIGURATION GUIDE............... 5
3.1 LOG IN......................................................................5
3.2 FAST INSTALLATION GUIDE .........................................6
3.3 STATUS .....................................................................9
3.4 LAN SETTING............................................................9
CHAPTER FOUR LAN SETTING.................................. 11
4.1 BASIC SETTING ........................................................11
4.2 MODE SETTING .......................................................12
4.3 ACCESS FILTER .......................................................20
CHAPTER FIVE SYSTEM TOOLS................................ 22
5.1 CHANGE PASSWORD................................................22
5.2 FIRMWARE UPGRADE ...............................................22
5.3 REBOOT ..................................................................23
5.4 RESTORE FACTORY .................................................24
5.5 RESTORE/BACKUP...................................................25
5.6 EXIT........................................................................25
5.7 HELP ......................................................................26
54Mbps Wireless Long Range Wireless AP
1
Chapter One Production Description
Thanks for purchasing Tenda product TWL5401A Long range wireless AP.
TWL5401A is compliant with international standard of IEEE802.11b/g, with
five working modes of Wireless AP, Repeater, Point to Point (PTP), Point to
Multi Point (PMP) and Client.
TWL5401A is easy in configuration, you are able to finish the configuration
easily with references to the manual and you are able to enjoy your Internet
visiting. Before you install TWL5401A, please read this manual carefully so
that you are able to have better utility of all the function of the product.
1.1 Specification
zCompliant with IEEE 802.11g, IEEE 802.11b, IEEE 802.11e (QoS)
and 802.11i
zSupport Wireless AP Mode, Repeater Mode, P2P Mode, PMP Mode,
Client Mode
zHighest speed at 54Mbps, 54/48/36/24/18/12/9/6M or 11/5.5/2/1M
multi-speed auto negotiation
zCATEGORY 5 far-distance power supply technology (PoE, Power over
Ethernet)
zProvides 1 10/100M Auto-Negotiation LAN port connectible to your
LAN
zOffer higher penetrating power than normal 11b or 11g product, Max
out door transmission distance of 30 KM/18 miles (changeable
according to antenna and environment)
zSupport Web-Management, English Configuration Interface, Simple
Configuration Wizard
zSupport xDSL/Cable MODEM, Broadband Fixed IP, Broadband
Dynamic IP access
zSupport 64/128 Bit WEP, WPA-PSK and WPA2 encryption protocol
zSupport 802.11b/802.11g auto/manual configuration modes
zSupport Auto MDI/MDIX on all ports
zSupport Browser of Netscape 6.1 , IE 5.5 or above
zSupport 32 Groups of MAC address authorized access
54Mbps Wireless Long Range Wireless AP
2
Wireless LAN is usually deployed in an already-planned environment. In
this environment, every access point is equipped in a fixed location. Every
location has its covering area, the access point offers wireless connectivity
to user’s in the covered area.
1.2Unpacking
1. TWL5401A wireless AP one units
2. CD one piece (user’s manual, installation guide included)
3. Installation Guide
4. Power cord
5. Power Adapter
6. POE power supplier
7. Cable of 30 meters 1 piece
8. Cable of 1 meter 1 piece
9. Cable connectible to the earth
10. Antenn and Singal Scanner
11. Cable for Antenna and Signal Scanner
12. Arrester
13. Antenna
14. Brackets and screws
15. Screwdriver
16. RJ45 Connectors for cable
Note：The above list is for references only, actual package depends on
shipment.
54Mbps Wireless Long Range Wireless AP
3
Chapter Two Installation
2.1 Before Installation
zTo inspect the location for installing the equipment: Please decide the
quantity of the equipments to be installed, and select the location for
installing the equipment. For example, top of building, or other high
buildings. And marked each location in chart, and distribute channels
for each machine.
zTo configure on the device: To configure IP address, channels, and
SSID
zTo select location: Please install the equipment in the select location,
fix it, and connect the cable and power lines, and adjust the direction of
the antenna
zTo test in the location: To check if the covering rage and strength of
signal is satisfactory. You could adjust the location of the equipment
according to the test result.
2.2 Steps for Hardware Installation
Please install with references to the figure below for hardware installation:
54Mbps Wireless Long Range Wireless AP
Figure for hardware installation
Please pay attention to the following when installing hardware:
zTo connect the cable: Please connect the cable to the RJ45 port of the
TWL5401A properly, and then please tighten the cap.
zTo connect the Antenna: Please connect the antenna to the antenna
port of the TWL5401A properly and then tighten the cap
zTo install the Antenna: Please refer to the guide for installing Antenna
zTo have proper anti-water protection to all the ports connected, for
example, you could use Anti-water adhesive plaster to wrap the ports
connected
zPlease make sure that all the equipments are connected to the earth
properly, and please tighten the installation of TWL5401A on the
location
Warning: If you require to re-make the RJ45 connectors, please make use
that it is fully compliant with the TIA/EIA-568B international standard,
otherwise, if the RJ45 connectors are not made properly, it would cause the
wrong connection between the power cord and the data line, and this would
cause damages to the equipment. For all the results caused by the wrong
connection between cables or line, the end users or the installer should be
responsible for it.
4
54Mbps Wireless Long Range Wireless AP
Chapter Three Configuration Guide
3.1 Log In
It is recommended that you should connect to TWL5401A with wired
connection and have configuration on TWL5401A. Because the default IP
address of TWL5401A is 192.168.0.254, you should configure the IP
address of your NIC as 192.168.0.X (X is a number between 1~253, and IP
address of your NIC should not be the same as the IP address of
TWL5401A or the same as the IP address of other devices in the network.),
and Sub-Net Mask of your NIC should be 255.255.255.0.
After configuration of your NIC, please open the IE browser, enter the IP
address of TWL5401A http://192.168.0.254 in the address bar. And you
would see the following interface for logging in. And you are able to log in as
the administrator of the system. (the factory default user’s name and
password is “admin”). Please refer to the figure below:
Figure 1
Please click “OK” and you would see a welcome interface as shown in
Figure 2.
5
54Mbps Wireless Long Range Wireless AP
Figure 2
Please click “Next” to enter into the interface, we can see the configuration
interface for wireless AP mode. On the menu on the left-hand side, we are
able to select “Status”, “Wizard”, “LAN Setting”, “Radio Setting”, “System
Tools”, “Exit” and “Help”. And in this interface, you could see that TWL5401A
supports five working modes including wireless AP, P2P bridging, P2MP
bridging, wireless repeater and wireless client. Please single click a certain
button and you are able to have the respective function configuration. And
we would introduce the detailed configuration step by step below.
3.2 Fast Installation Guide
Please click “Wizard” on the left-hand-side panel of the interface which
displays on the left-hand-side of the screen the figure as the figure below
does not appears.
Click Next and then enter into the screen of Wizard.
6
54Mbps Wireless Long Range Wireless AP
Figure2
You can select one of the five following working modes: AP, WDS P2P
Bridge, WDS P2MP Bridge, WDS AP Repeater, Client to accommodate the
wireless accesses. We herein take AP for example.
Please Select AP and then click “Next” as Figure 4.
Figure 4
According to the instruction, please fill in below information:
zSSID: Fill in the SSID of the device.
zChannel：Select AP communication channel (Default as 6).
Click “Next” when you finished the configuration above then enter into the
item of Security Setting.
7
Inhaltsverzeichnis
Andere Tenda Drahtloser Zugangspunkt Handbücher
Tenda
Tenda W300A Bedienungsanleitung
Tenda
Tenda AX3000 Bedienungsanleitung
Tenda
Tenda teg2124t Bedienungsanleitung
Tenda
Tenda W301A Bedienungsanleitung
Tenda
Tenda teg2124t Bedienungsanleitung
Tenda
Tenda I-WL-O3 Bedienungsanleitung
Tenda
Tenda W301A Bedienungsanleitung
Tenda
Tenda W15-Pro Bedienungsanleitung
Tenda
Tenda PW201A Bedienungsanleitung
Tenda
Tenda 11AC Bedienungsanleitung
Tenda
Tenda AP5V Bedienungsanleitung
Tenda
Tenda i27 Bedienungsanleitung
Tenda
Tenda W301A Bedienungsanleitung
Tenda
Tenda W150M Handbuch
Tenda
Tenda TWL54A+ Bedienungsanleitung
Tenda
Tenda W300A Bedienungsanleitung
Tenda
Tenda WH450A Bedienungsanleitung
Tenda
Tenda W150M Bedienungsanleitung
Tenda
Tenda AP Series Bedienungsanleitung
Tenda
Tenda W302A Bedienungsanleitung
Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken
D-Link
D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung
Ubiquiti
Ubiquiti NanoStation NSM2 Bedienungsanleitung
Cisco
Cisco Aironet 1550 Series Bedienungsanleitung
Aruba
Aruba IAP-335 Bedienungsanleitung
Advantek Networks
Advantek Networks AWN-AP-54MR Bedienungsanleitung
IP-COM
IP-COM AP355 Bedienungsanleitung
Buffalo
Buffalo AirStation WLA-L11G Bedienungsanleitung
EnGenius
EnGenius EnStationACv2 Bedienungsanleitung
D-Link
D-Link DAP-3662 Bedienungsanleitung
xG Technology
xG Technology xMax CN1300 Bedienungsanleitung
Widelink
Widelink ezWave WAP-1100 Series Bedienungsanleitung
Edimax
Edimax CAP1200 Bedienungsanleitung
