Tennant 7100 Schulungshandbuch

Andere Handbücher für 7100

5

Inhaltsverzeichnis

Andere Tennant Schrubber Handbücher

Tennant

Tennant ec- H2O 5680 Bedienungsanleitung

Tennant

Tennant 510E Schulungshandbuch

Tennant

Tennant i-mop Lite Bedienungsanleitung

Tennant

Tennant IPC PW-H61 Bedienungsanleitung

Tennant

Tennant T17 Series Bedienungsanleitung

Tennant

Tennant 5700 Bedienungsanleitung

Tennant

Tennant T981 Bedienungsanleitung

Tennant

Tennant T1 Bedienungsanleitung

Tennant

Tennant T291 Bedienungsanleitung

Tennant

Tennant T3 Bedienungsanleitung

Tennant

Tennant M17 Series Bedienungsanleitung

Tennant

Tennant 5700 Bedienungsanleitung

Tennant

Tennant 5100 Produkthandbuch

Tennant

Tennant T300e Bedienungsanleitung

Tennant

Tennant t500e Bedienungsanleitung

Tennant

Tennant T7AMR Bedienungsanleitung

Tennant

Tennant 5700XP Schulungshandbuch

Tennant

Tennant LPTB03175 Bedienungsanleitung

Tennant

Tennant T12 Schulungshandbuch

Tennant

Tennant T591 Bedienungsanleitung

Tennant

Tennant 7100 Bedienungsanleitung

Tennant

Tennant 5300 Bedienungsanleitung

Tennant

Tennant LPTE00699 Bedienungsanleitung

Tennant

Tennant 8010 Bedienungsanleitung

Beliebte Schrubber Handbücher anderer Marken

Olympus

Olympus M200H Bedienungsanleitung

Clarke

Clarke BEXT 100H Installations- und Betriebsanleitung

JOHNY VAC

JOHNY VAC JVC70BCT Bedienungsanleitung

RCm

RCm Elan Series Handbuch

Kärcher

Kärcher B 120 W Bedienungsanleitung

Truvox

Truvox Orbis MotorScrubber 20 Bedienungsanleitung

Numatic

Numatic TTB 4045/100 Bedienungsanleitung

U.S. Products

U.S. Products PEX 500-C-TICK Betriebsanleitung

Mclennan

Mclennan C510 Bedienungsanleitung

Columbus

Columbus ARA 66 BM 100 Bedienungsanleitung

Numatic

Numatic TTV 678G / 300T Bedienungsanleitung

American-Lincoln

American-Lincoln 505-945 Bedienungsanleitung

FIORENTINI

FIORENTINI ET 65-75 Bedienungsanleitung

Floorpul

Floorpul ruby 48 blt Benutzerhandbuch

Onyx

Onyx RX-34 Bedienungsanleitung

Dustbane

Dustbane Hurricane 400 Bedienungsanleitung

Sana

Sana EUJ-702 Bedienungsanleitung

REMS

REMS Twist Bedienungsanleitung

IB 340494 (7-01) 1

No. 340494

Machine: 7100

Published: 7-01/00

System: OPTIONS

INSTRUCTION BULLETIN

NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the Parts

List in the appropriate place in your machine manual for future reference.

Retaining the Parts List will make it easier to reorder individual parts and will

save you the cost of ordering an entire kit.

NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.

Installation instructions for kit number 391193

SYNOPSIS / PROBLEM:

This kit contains the parts needed to install/replace the storage bag on the model 7100

scrubber.

Please follow step-by-step instructions.

SPECIAL TOOLS / CONSIDERATIONS: Hand drill, 21/64 [8.33 mm] drill bit, 2 in. hole saw

(Estimated time to complete: 1 hour)

PREPARATION:

(Refer to FIG. 1 and 2)

FOR SAFETY: Before leaving or servicing machine, stop on level surface and set parking

brake. Then turn off machine and remove key.

INSTALLATION:

(Refer to FIG. 1 and 2)

1. Locate and mark the two mounting hole locations, using the rework drawing in figure 1.

(Refer to FIG. 1)

2. Drill two 21/64 [8.33 mm] holes all the way through the marked hole locations.

(Refer to FIG. 1)

3. Using the two new holes as centerpoints, drill two 2 in. holes from the inside of the machine

through the first wall layer. Do not run the hole saw all the way through the machine wall.

The 2 in. hole through the inside wall of the machine will only be used to secure the

mounting hardware. (Refer to FIG. 2)

4. Mount the bag (1) to the rear of the machine with the mounting bag strip (1), hex screws

(3), washers (5) and lock nuts (4). (Refer to FIG. 2)

5. Tighten the bag mounting hardware to 7.6 -- 9.9 Nm (5.4 -- 7 ft lb). (Refer to FIG. 2)

IB 340494 (7-01)2

FIG. 1 -- MOUNTING HOLE LOCATIONS, BAG, STORAGE

BILL OF MATERIALS FOR STORAGE BAG KIT, 391193

TENNANT

Ref. Part No. Description Qty.

1 391258 Bag, power wand 1

2 391243 Strip, mtg, bag 1

3 09011 Screw, hex, M08 X 1.25 X 30, Ss 2

4 08713 Nut, hex, lock M08 X 1.25, NL, Ss 2

5 01685 Washer, flt, 0.31 Ss 4

TENNANT COMPANY

P. O. Box 1452

Minneapolis, MN 55440-1452

IB 340494 (7-01) 3

1

2

5

4

5

Tighten mounting hardware to

7.6 -- 9.9 Nm [5.5 -- 7 ft lb]

Drill 2 in hole through inside layer

only, to access tightening hardware

3

FIG. 2 -- STORAGE BAG INSTALLATION