TerraTrike Rambler Bedienungsanleitung
Assembly Guide
Pilot’s Handbook
Technical Illustration
&
Parts List
www.TerraTrike.com - 800.945.9910
4460 40th St SE. Grand Rapids, MI 49512 USA
Table of Contents
Assembly Guide - Pg 1 - 12
Pg 1 - Hubmount/Handle bar Installation
Pg 2 - Rear Wheel/Front Wheel Installation
Pg 3 - Brake Installation
Pg 4 - Boom Installation, X-seam setup, Alignment
Pg 5 - Tire Pressure, Alignment Continued
Pg 7 - Rear Derailleur Hanger Alignment, Installation & Adjust-
ment
Pg 8 - Shifter & Brake Cable Installation & Routing
Pg 9 - Seat Clamp, Chain Tube and Chain Installation
Pg 10 - Pedal Installation & Seat Installation
Pg 11 - Reector Installation & Seat Adjustment
Pg 12 - Handlebar Adjustment
Owners Information - Pg 13 - 14
Pg 13 - Welcome!, Unpackaging, Caution/Safety, Riding Tips
Pg 14 - Warranty Information
Technical Information - Pg 15 - 17
Pg 15 - Rambler Technical Drawing (Exploded), Part Numbers
Pg 16 - Rambler Seat Clamp Drawing (Exploded), Part Numbers
Pg 17 - Parts Lists for Technical Drawings
Pg 18 - X-Seam Settings
Pg 19 - 21 - Notes
Pg 22 - Company Information
Assembly Guide
Dark Grey = Installation/Adjustment
1
Washer
Washer
Hubmount
2
Apply grease to grey
bushings to make steer-
ing even smoother.
2
1
Hubmount Installation
Handlebar Installation
Wipe o grease where
handle bars clamp on.
Apply grease to hubmount axle
before sliding it up in to frame!
1
PLEASE NOTE: Make sure you’re greasing bolts before installing them.
Failure to do so can cause “galling” to occur (heat and friction will fuse (weld)
the fasteners together). Adjustment will be impossible and not covered under
warranty.
BEFORE YOU BEGIN ASSEMBLY, INSTALL DECAL PACKET
3
4
1
2
Rear Wheel Installation
Front Wheel Installation
Install axle bolts - tighten to 325 in. lbs.
Apply grease to quick
release skewer before
installing
Apply grease to hubmount
axle before installing wheel
2
Tire Pressure
Tire pressure is indicated on the side-wall of of each tire.
**TIRE PRESSURE SHOULD BE CHECKED BEFORE EACH RIDE.**
51
2
Tighten cap-screw until wheel doesn’t move. This makes brake cailper setup easier.
Loosen cap screw to desired steering resistance when finished.
Brake Caliper Installation & Setup
Proper setup: you should see day-
light on either side of the rotor with
bolt screws tightened down. See
below image for bolt location and
fastener layout.
Hubmount
M6 washers OR Fender stay
Caliper Bolts
3
6
Tie Rod Installation and Wheel Alignment
See Pg 6 for alignment/wheel spacing measurements.
RAMBLER 8 tie rod install above hubmount!!!
1
Temporarily turn to pg 20 for x-seam
setup. Setup boom for X-seam length.
See chart on Pg 19 for Boom length-to-x-
seam measurements.
7
Make rst wheel
parallel to frame.
Measure to center
of bottom bracket.
Boom Installation & Front Derailleur Setup (set stops)
Alignment
INSTALL TIE ROD FIRST
2
Apply a lot of
grease to
clamping
bolts and
tighten
securely!
Torque spec: 60-70 in. lbs.
Hubmount
“L” Bracket (computer
sensor mount)
RIGHT HAND
SIDE OF TRIKE
Hubmount
Loosen Hex nuts to rotate tie rod
Set Derailleur Stops
LEFT HAND
SIDE OF TRIKE
Rotate tie rod to change
wheel alignment after
installing the tie rod
mounting bolts
4
INFLATE TIRES BEFORE ALIGNING TRIKE
7 Cont.
See Next Page for Alignment/wheel spacing measurements
Make Second Wheel Parallel to First Wheel
Demonstration Picture - Measuring Front to Front
Demonstration Picture -
Measuring Back to Back
5
Tire Pressure
Tire pressure is indicated on the side-wall of of each tire.
**TIRE PRESSURE SHOULD BE CHECKED BEFORE EACH RIDE.**
7 Cont.
14 1/16”
or
357mm
29 3/4”
or
759mm
13 15/16 “
or
354mm
Make sure the rst wheel you chose to
align on pg 4 doesn’t move after being
aligned to frame. Do this by tightening the
cap screw in Step 2.
These measurements may vary slightly. Each
tire may have variances in it. It’s important to
make sure, however, each wheel is aligned
properly.
6
Tire Pressure
Tire pressure is indicated on the side-wall of of each tire.
**TIRE PRESSURE SHOULD BE CHECKED BEFORE EACH RIDE.**
8
9
Conrm Derailleur Hanger Alignment & Rear Derailleur Installtion (If Equipped)
Set Rear Derailleur High & Low Stops
7
10
Cable Routing & Installation
Right Hand
Handlebar
Left Hand
Handlebar
8
Inhaltsverzeichnis
Andere TerraTrike Fahrrad Handbücher
TerraTrike
TerraTrike Rover Bedienungsanleitung
TerraTrike
TerraTrike Tour II Bedienungsanleitung
TerraTrike
TerraTrike Sportster Bedienungsanleitung
TerraTrike
TerraTrike Rambler 2020 Handbuch
TerraTrike
TerraTrike Rover Bedienungsanleitung
TerraTrike
TerraTrike E.V.O. with Bosch Active Line Plus Bedienungsanleitung
TerraTrike
TerraTrike EVO Handbuch
TerraTrike
TerraTrike GTS Handbuch
TerraTrike
TerraTrike GranTourismo Handbuch
TerraTrike
TerraTrike SPYDER Handbuch
