OPERATION
This cordless stereo headphone system has been designed for general home use only. It is not
designed for commercial or industrial use.
Initial set up
Unwind the 12VDC 200mA AC power pack lead fully and plug the power pack into a suitable
electrical wall socket, 230-240V ~.
Plug the AC power pack DC output supply plug into the DC input socket on the rear of the
transmitter.
Remove the cover and install two rechargeable batteries into the right headphone unit, taking note
that only NiCd rechargeable batteries may be used and of the battery installation instruction details
inside. Plug the short recharge lead from the transmitter into the headphone charge socket.
Switch the power ON at the wall and the Headphones to the OFF position while charging. Leave on
charge for 24 hours before initial use to ensure batteries are at full charge. Red light will illuminate
on transmitter when charging in process. When charging is complete, headphones are ready for use.
Use
Unplug the charger cable from the headphones.
Connect the transmitter audio input lead (long lead) into a suitable audio output jack (use one of the
supplied adaptors if required). Ensure that the transmitter has an input signal from the music source,
a green light on the transmitter will indicate that it is receiving signal and is transmitting.
Turn the headphones on and adjust the tune control until a clear signal is received, a green light on
the transmitter will indicate that it is transmitting.
Adjust the volume on the headphones to suit.
When finished ensure that the headphones are turned off and plugged back into the charger lead of
the transmitter to recharge the batteries before storing or reuse.
Interference
If you receive interference/static through the headphone set this can be eliminated by adjusting the
transmitter frequency on the rear of the transmitter (frequency adjust) and re-tuning the headphone
to the new frequency.
ELECTRICAL SAFETY
When using electric equipment always observe safety regulations where applicable to reduce the
risk of fire, electric shock and personal injury.
Always check that the power supply corresponds to the voltage on the rating plate.
Supply cord and plug.
Always fully unwind any cord to avoid overheating. Never allow any supply cord to come in
contact with hot objects. Do not carry the equipment by the cord. Disconnect by first switching off
the mains outlet, grasping the adaptor and pulling it out gently.
If the adaptor or adaptor supply cord is damaged, it must be replaced by the manufacturer, its
service agent or a similarly qualified person in order to avoid a hazard. Only use authorised
replacement parts.
Children.
Caution. Keep out of reach of children.
This appliance is not intended for use by young children or infirm persons without supervision.
Young children must be supervised to ensure that they do not play with the equipment..
Water.
For your safety do not immerse any part of this equipment in water.
Do not use with wet hands or use in damp situations
Handling..
Do not drop the product as this may cause damage or damage internal components. Do not use this
equipment if it has been damaged in any way, immersed in water, the adaptor or supply cord is
damaged or the operation is faulty. Contact with any damaged equipment could result in electric
shock.
Batteries.
Only use the rechargeable NiCd batteries as supplied, seek professional assistance if unsure as to
which batteries are acceptable for use as replacements.
