10
SMART WIFI THERMOSTAT
EN
C - INSTALLATION
Make sure the temperature sensor is plugged in and
in pairing mode. In pairing mode, the temperature
sensor’s screen should be ashing. If this is not the
case, press and hold the “reset” button at the rear
of the temperature sensor for 3 seconds.
Next, press COMMENCER LA CONFIGURATION
(START SETUP).
Select your 2.4 GHz WiFi network (note: your
smartphone must be connected to the WiFi network
to which the module will be connected), enter your
network password and press SUIVANT (NEXT).
Please wait while the pairing procedure takes
place. This stage can last several minutes.
IMPORTANT: The network compatibility of this
device is 2.4 GHz WiFi - WPA/WPA2. Not compatible
with 5 GHz WiFi or with WEP encryption.
Please check the WiFi settings of your router
or contact your Internet service provider if you
experience connection difculties. In case of failure,
check the module’s Wi-Fi range. To do so, connect
it close to your Wi-Fi network. Check your network
password and check that you are on 2.4GHz WiFi.
Then perform a reset and restart the procedure.
Your Thomson temperature sensor has been paired
successfully. You can name it and press TERMINER
(FINISH).
Your temperature sensor is now operational and
appears in your dashboard. Wait until the icons
change from grey to black (indicating conrmation
of connection to your WiFi network). Your
temperature sensor is now ready to use.
