TimeTec Smart Gateway Camera Bedienungsanleitung
www.i-timetec.com
User Guide
SMART GATEWAY CAMERA
HIGH-PERFORMANCE MOTION DETECT CAMERA
2
www.i-timetec.com
Smart Gateway Camera
INTRODUCTION
Smart Gateway Camera is an integration that consisted of main chip and
exposed interface. Support APP control, real time monitoring, cloud in-
tercom, cloud storage, aim to provide nice experience of video inter-
com.
INSTRUCTION DESCRIPTION
IR sensor Light up at dark environment
Indicator Green LED means network connected;
Red means unconnected
Microphone Voice input
Speaker Voice output
Power supply Micro USB 5V
RESET Long press 5s, restore to factory
setting and reboot
TF card slot Support local storage (Max 128G)
3
www.i-timetec.com
Smart Gateway Camera
1. Type 1 Desktop installation
Take off the protective film of poster, and stick it the button of cam-
era correctly as below shown;
Take off the rest protective film, and stick the camera at clean and
glaze surface, as below shown.
2. Type 2 Ceiling installation
Stick the positioning tool at special surface;
Choose any two points, as shown below, and drill holes accordingly;
lnsert tubes into holes and fix;
Align tubes and camera, then fix them together with screws, shown
as below.
INSTALLATION
4
www.i-timetec.com
Smart Gateway Camera
Step 1 • CONNECT DEVICE
Power up: connect camera to power supply with adaptor.
Once get power, indicator will turn on, and comes with voice prompt “Initialize
success, please configure WIFI”.
HOW TO USE
5
www.i-timetec.com
Smart Gateway Camera
Step 2 • BONDING DEVICE TO APP
User register: Scan the QR code on packing box to download i-TimeTec APP and
finish registration.
Network connection:
Have the smart phone visit the WIFI which the camera should connect to;
Login APP, follow its guidance and scan camera‘s QR code at its button;
Follow APP‘s guidance to finish network setting until voice prompt
“Configuration success, welcome to use” .
Remark: Make sure the router is fine before have the camera connected to.
Connection success: the indicator turns to green, and it will be online at APP.
Remark: If need to change the WIFI/router, please long press the RESET key 5s, until voice prompt
“ Factory reset success” , then it will reboot and follow voice prompt to do setting again.
6
www.i-timetec.com
Smart Gateway Camera
(1) Q: Prompts up “Camera offline” or “Fail to download video” after connection
A: Make sure the WIFI/router could visit internet; make sure the WIFI was not
changed, if changed, please long press the RESET key 5s, until voice prompt
“Factory reset success “ , then it will reboot and follow voice prompt to do
setting again.
(2) Q: Squeal comes during intercom
A: The squeal is caused by too close distance between camera and phone,
please keep proper distance.
(3) Q: Camera is offline
A: Make sure the WIFI/router is available; mobile already logined the WIFI that
the camera should connect to; enter correct WIFI information; are there too
much devices connect to that WIFI.
(4) Q: Fail to login APP or download video
A: Make sure your phone could visit internet and with high speed, also make
sure “ANJUXIAOBAO” APP is not forbidden to internet.
QA & NOTES
© 2019 Timetec Cloud Sdn Bhd. All rights reserved • 112019
© 2019 Timetec Cloud Sdn Bhd. All rights reserved • 112019
www.i-timetec.com
Inhaltsverzeichnis
Andere TimeTec Sicherheitskamera Handbücher
