ATTENTION: LUMINAIRE MUST BE MOUNTED IN ACCORDANCE WITH LOCAL
AND NATIONAL BUILDING CODES
MOUNTING:
1) IT IS REQUIRED TO USE THE PROPER OPTIONAL WEIGHT RATED HARDWARE TO SECURLY
AND SAFELY INSTALL THIS LIGHTING FIXTURE.
2) REMOVE CANOPY FIXTURES COVER AND FLUSH MOUNT TO A SECURE HORIZONTAL
OVERHEAD LOCATION USING HIGH GUAGE SHEET METAL SCREWS THAT ARE PROPERLY
RATED FOR WEIGHT CAPABILITIES. THE 3/4” HOLE IN THE LID OF THE CANOPY CAN ACCEPT
A STANDARD 3/4” NPT TYPE FITTING. PLEASE ADHERE CLOSELY TO ALL HARWARE INSTALLATION
GUIDELINES TO INSURE PROPER SAFETY AND OPERATIONAL FUNCTIONS.
CAUTION: PROPERTY DAMAGE, SERIOUS INJURY, AND OR DEATH MAY OCCUR FROM IMPROPER
INSTALLATION OF THIS LIGHTING FIXTURE.
CAUTION: THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THIS TITAN LED PRODUCT AND OF ANY
HAZARDS INVOLVED.
3) RE-ATTACH THE FIXTURE AT THE HINGES. ONCE THE FIXTURES COVER IS SECURELY MOUNTED
THIS FIXTURE MAY HANG OPEN AT HINGES WHILE MAKING ELECTRICAL CONNECTIONS.
4) CONNECT THE A/C POWER SUPPLY WIRES TO THE LUMINAIRES DRIVER CONNECTION WIRES FOUND
INSIDE THE CANOPY HOUSING WITH THE BLACK WIRE BEING THE A/C LOAD (HOT), THE
WHITE WIRE BEING A/C NEUTRAL AND THE GREEN WIRE BEING A/C GROUND.( See Pic Below )
5) AFTER INSPECTION OF PROPER AND SECURE A/C CONNECTIONS CLOSE FIXTURE AND REPLACE THE
FIXTURES 2 ACCESS SCREWS.
6) YOU CAN NOW RESET THE MAIN POWER CIRCUIT AT THE BREAKER.
YOU CAN NOW POWER ON THE NEW LIGHTS.
7) LOW VOLTAGE 0-10V DIMMING IS AN OPTION BUILT INTO TITAN LEDS DRIVERS (POWER SUP-
PLIES) THESE LOW VOLTAGE DIMMING WIRES ARE COLORED PURPLE (dim +) AND GREY (DIM -)
AND WILL OPERATE WITH 0-10V LOW VOLTAGE DIMMER SYSTEMS ONLY.
8) IF DIMMING CIRCUIT IS NOT TO BE USED, LEAVE THE PURPLE AND GREY WIRE LEADS
SEPERATELY CAPPED AND UNCONNECTED.
INSTALLATION INSTRUCTIONS:
Titan LED Canopy lights have a built in top side pre-cut hole in e Top Cover to accept a Standard 3/4” Pipe
Connection. Properly utilizing this hole with the right adaptors for a thread tight installation helps safety and
increases the lights moisture barrier in typical applications.
0-10v Low Voltage Dimming
Wires are Purple + and Grey -
Titan LED’s Hinged Canopy Fixture Cover Shown Below
Dimensions:
