TK-STAR TK 2000 Bedienungsanleitung
1
TK-STARGPSTRACKER
USERMANUALTK2000
PR EFA CE
2
Thank you for purchasing the GPS tracker. This manual shows how to operate
the device smoothly and correctly. Make sure to read this manual carefully
before using this product. Please note that specification and information are
subject to changes without prior notice in this manual. Any change will be
integrated in the latest release. The manufacturer assumes not to be
responsible for any errors or omissions in this document.
1. SUMMARY
Working Based on existing GSM/GPRS network and GPS satellites, this
product can locate and monitor any remote targets by SMS or internet. The
most advanced technology of GPS and A-GPS dual positioning.
Content
Specs.
Dim.
50mm x 50mm x 20mm(1.96”*1.96”*0.78”)
Weight
50g
Network
GSM/GPRS
Band
850/900/1800/1900Mhz
GPS sensitivity
-159dBm
GPS accuracy
5m
Time To First Fix
Cold status 45s
Warm status 35s
Hot status 1s
Car charger
12—24V input
5V output
Wall charger
110－220V input
5V output
Battery
Chargeable changeable 3.7V 1000mAh Li-ion battery
Stand by
180hours
Storage Temp.
-40°C to +85°C
Operation Temp.
-20°C to +55°C
Humidity
5%--95% non-condensing
3
LED INDICATOR STATUS
MEANING
Left-GREEN-Continuously lit
No GPRS signal.
Left-GREEN-Flashing
GPRS communication established.
Center-RED-Not lit
Fully charged.
Center-RED-Solid red
Charging.
Right-BLUE-Continuously lit
Searching for GPS signal.
Right-BLUE-Flashing
GPS location successful.
2. INSTALLATION
2. 1 SIM-CARD INSTALLATION
Once the SIM card has been purchased and credit added, unscrew the tracker
using the screwdriver to remove the 4 small screws in each corner.
4
Then, insert the SIM card into the SIM card holder by push the metal piece
forward and lifting it up, Place the SIM-card into the card slot, Press the metal
piece back into its original position and push the metal piece back into place.
If you have purchased a MICRO SIM , you will need to use the Micro SIM adapter
enclosed, like this:
Ensure you place the SIM card with the chip face down and the right way
round, clip the holder into place and re-screw up the unit.
2.2 USE THE GPS DEVICE
Turn on the unit outdoors by pressing the “on/off” button until the indicator
is on.
For first use, please initialize the unit and restore it to default setting.
(Please refer to 3.1 for instruction.)
In 10 or 40 seconds, the unit will begin to work and acquire the GSM
signals as well as the GPS signals. The indicator will keep flashing every
5
3 seconds when the unit has received the signals.
When this unit receives GPS signals normally, you can use it and do any
setting as the instructions of this manual.
2.3 EXPLANATION OF PARAMETERS/CODES IN SMS MESSAGE
1. Google Maps link: This is the link to the Google map showing the position
of the tracker unit.When click the link, if a map is displayed, there is GPS
information for the unit. If there is no may, there is no GPS information for
the tracker.
2. V:A/V: Indicates GPS signal. V:A indicates there is a GPS signal; V:V
indicates there is no GPS signal.
3. 2014-07-29 06:41:43 The date and time stamp when the unit last received
a GPS signal.
4. S: 007km/h: This indicates the last known speed of the unit.
5. Bat:80% The approximate amount of battery charge remaining. The value
is between 1 0%and 100%, with 100% being fully charged.
6. 4109112546: The ID code of tracker device. This number is used for
tracking website and the app.
3. SMS Tracking
1) Call the SIM-card phone number in the device by other cell phone
2) Receive a Google Maps link by SMS to your mobile phone
3) Click on the Google Maps link
4) Now it displays the position of device.
3.1 Command Instruction
6
INSTRUCTION
COMMAND
REPLY
Reboot the device
begin123456
begin ok
Set authorized number
admin123456 phone number
admin ok
Cancel authorized number
noadmin123456 phone number
noadmin ok
Set SOS phone number
sos123456 phone number
sos number ok
Cancel sos number
nosos123456 phone number
nosos ok
SMS Track
G123456#
Google link
Set GMT time zone number
timezone123456 8
Timezone123456 -8
time ok
Sleep by time (default mode-save much
power,tracker will fall asleep in 5
minutes)
sleep123456 time
sleep time ok
Sleep by shock sensor(Suits for
tracking on platform)
sleep123456 shock
Sleep shock ok
No sleep(tracker will continuou working)
sleep123456 off
sleep off ok
Switch to the NO GPRS mode(default
mode)
Nogprs123456
Nogprs ok
Switch to the GPRS mode(for tracking
online )
gprs123456
gprs ok
Status Check
Check123456
IP,APN,GPS,
GSM,status
7
3.2 ONLINE TRACKING
3.2.1 Turn on GPRS function by sending comand “gprs123456 ”to the
tracker, and set the apn for tracker, then online tracking will work .
APN information is from sim card carrier ,every sim card carrier has
different APN information, there are two ways to find APN out: check sim card
carrier on internet or put sim card into own cell phone to find check APN
3.2.2 COMMAND INSTRUCTION TO SET THE ACCES POINT NAME (APN)
3.2.2 START ONLINE TRACKING
Note:must set apn at first
NAME
INSTRU
CTION
COMMAND
REPLY
FOR EXAMPLE
APN
Set new
APN
( old one
will be
replaced)
apn123456 content
apn ok
apn123456 apn
APN user
Set APN
username
apnuser123456 content
apnuser ok
apnuser123456 user
APN password
Set APN
password
apnpasswd123456 content
apnpasswd ok
apnpasswd123456 password
Switch to the
GPRS mode
Open the
GPRS
gprs123456
gprs ok
gprs123456
Set Upload the
frequency
Default
120 seconds
Upload123456 30
Upload ok
Upaload123456 30
8
Platform : 2.tkstargps.net/
IMEI No. : On the back side of cover
Password: 123456
3.2.3 APPLICATIONS FOR ANDROID/iOS
Search “TKSTAR“in the Apple App Store/Google Play
Store or Scan the QR Code to install the applications on
your cell phone.
Select “Log in by IMEI”on the
bottom of screen
Server: 2.tkstargps.net
IMEI : on the back side of cover
Password: 123456
Note:
When the device can't get GPS signal in one minute or in sleep mode, it will reply history
position (V:V ); the device will send real time tacking information until it get GPS
signal (V:A).
Make sure that all the symbol“+”in sms commends is just for quick understanding, which don’t need
to
enter “+” in sms, and “space” means press the space bar button of the cell phone.
When the device location show different with map, there are two kinds of circumstances, 1.Device in
sleep condition, 2 No GPS signal;Solution: Dial SIM Card Number in the Device, if only reply one
9
SMS with "V:V", it means no GPS Signal; If reply one SMS, with "V:A", it means device in sleep
model;
(Note: We advice use Shock Sleep Model when driving)
Inhaltsverzeichnis
Andere TK-STAR GPS Handbücher
TK-STAR
TK-STAR TK905 Bedienungsanleitung
TK-STAR
TK-STAR LK109 Bedienungsanleitung
TK-STAR
TK-STAR QUICK TOUR Bedienungsanleitung
TK-STAR
TK-STAR TK911 Bedienungsanleitung
TK-STAR
TK-STAR GPS TRACKER Bedienungsanleitung
TK-STAR
TK-STAR GTSTAR Bedienungsanleitung
TK-STAR
TK-STAR TK905 Bedienungsanleitung
TK-STAR
TK-STAR TK4000 Bedienungsanleitung
TK-STAR
TK-STAR Ephy Bedienungsanleitung
TK-STAR
TK-STAR LK106 Bedienungsanleitung
TK-STAR
TK-STAR LK106 Bedienungsanleitung
TK-STAR
TK-STAR TK306 Bedienungsanleitung
TK-STAR
TK-STAR PET TRACKER Bedienungsanleitung
TK-STAR
TK-STAR TK909 Bedienungsanleitung
TK-STAR
TK-STAR GPS TRACKER Bedienungsanleitung
TK-STAR
TK-STAR TK909 Bedienungsanleitung
TK-STAR
TK-STAR MINI GPS TRACKER Bedienungsanleitung
TK-STAR
TK-STAR TK906 Bedienungsanleitung
TK-STAR
TK-STAR TP-GPS806 Bedienungsanleitung
TK-STAR
TK-STAR TK110 Bedienungsanleitung
