TLA CTS-5-CA Bedienungsanleitung

Tuning-Set CTS-5-CA

Manual

V1.40

Tuning-Set CTS-5-CA

Good/bad indicator

LC-display

Strobo-display

On/off slide switch

Inbuilt condenser

microphone

Socket for external

microphone

Sensitivity slide switch

Socket for net adapter

< >

>1< TUNE ->

< > S

SELECT NOTE

SELECT NOT

AUTOMATICALLY

>2< PITCH ->

< > S

SELECT PITCH

AUTOMATICALLY

>3< CENT-MEAS ->

< > S

SELECT CENT

S E

THEN

< >

SELECT NOTE

SELECT CENT

AUTOMATICALLY

>4< TEMP.HIST->

< > S

SELECT

HISTORICAL

TEMPERAMENT

S E

< >

SELECT CENT

REFERENCE

>5< STRETCHING->

< > S

SELECT PIANO

STRETCHING

>6< MEMORY ->

S E

MEMORY MODE

(STORAGE OF A

TEMPERAMENT

ORAPIANO

STRETCHING)

SELECT

TRANSPOSER

< > S

S A

+AUDIBLE TONE ON OR OFF

PRESSED KEY DURING SWITCH ON TUNING SET

S SET LANGUAGE:

ENGLISH; GERMAN; FRENCH; ITALY

ASETUP'S:

ILLUMINATION ON/OFF;

TIMER ON/OFF;

FIRST MODE AFTER TURN ON THE DEVICE;

A+E SET BASIC ADJUSTMENT

Diagram for modes of operation CTS-5-C

BARGRAPH

INDICATION

>7< PIANYZER ->

MAKE AN

INDIVIDUAL

PIANO

TUNING

>6< MEMORY ->

S A

< >

DIAGRAM FOR MEMORY MODE TUNING SET CTS-5-CA

INDICATION:

" go ahead by tapping S + A ! "

SELECT STRETCHING OR

TEMP:HIST

< >

SET PITCH a-1

< >

SELECT NOTE

< >

SET CENT VALUE

DEVICE WRITES CENT VALUE TO STORE AND

SWITCHES ON SEMITONE STEP HIGHER

S E

< >

>1< TUNE ->

< > S

SELECT NOTE

SELECT NOT

AUTOMATICALLY

>2< PITCH ->

< > S

SELECT PITCH

AUTOMATICALLY

>3< CENT-MEAS ->

< > S

SELECT CENT

S E

THEN

< >

SELECT NOTE

SELECT CENT

AUTOMATICALLY

>4< TEMP.HIST->

< > S

SELECT

HISTORICAL

TEMPERAMENT

S E

< >

SELECT CENT

REFERENCE

>5< STRETCHING->

< > S

SELECT PIANO

STRETCHING

>6< MEMORY ->

S E

MEMORY MODE

(STORAGE OF A

TEMPERAMENT

OR A PIANO

STRETCHING)

SELECT

TRANSPOSER

< > S

S A

+AUDIBLE TONE ON OR OFF

PRESSED KEY DURING SWITCH ON TUNING SET

S SET LANGUAGE:

ENGLISH; GERMAN; FRENCH; ITALY

ASETUP'S:

ILLUMINATION ON/OFF;

TIMER ON/OFF;

FIRST MODE AFTER TURN ON THE DEVICE;

A+E SET BASIC ADJUSTMENT

Diagram for modes of operation CTS-5-CA

BARGRAPH

INDICATION

>7< PIANYZER ->

MAKE AN

INDIVIDUAL

PIANO

TUNING

--------- c - 5

------------ g# - 5

--------- c - 4

--------- c - 3

--------- c - 2

--------- c - 1

--------- c

--------- C

--------- C - 1

--------- E - 2

--------- a - 1 (PITCH)

--------- C

--------- D

--------- A

--------- G

--------- F

--------- E

--------- B

---- C#

---- Bb

---- G#

---- F#

---- D#

CTS-5-CA NOTE INDICATION

Manual for Tuning Set CTS-5-CA

Contents:

1Initial Operations................................................................................................................................2

1.1 Power............................................................................................................................................2

1.1.1 Battery change........................................................................................................................ 2

1.2 Switching on the Tuning Set......................................................................................................3

1.3 Selection of language for operator guidance ...........................................................................3

1.4 Introduction to the diagram for modes of operation................................................................3

1.5 Erasing all inputs.........................................................................................................................4

1.6 Timer switch.................................................................................................................................4

1.7 Sensivity adjustment of the built in microphone amplifier .....................................................5

2Operating Examples ..........................................................................................................................5

2.1 Tuning, equal temperament, standard pitch 440 Hertz............................................................5

2.1.1 Automatic note adjustment ..................................................................................................... 5

2.1.2 Audible tone on/off.................................................................................................................. 6

2.1.3 Bargraph Display .................................................................................................................... 6

2.2 Presetting of the concert pitch...................................................................................................6

2.3 Measuring the concert pitch of an instrument .........................................................................7

2.4 Measuring a tone's cent deviation.............................................................................................7

2.5 Piano tuning.................................................................................................................................7

2.6 Presetting of historical tempereaments....................................................................................9

2.7 Memory.........................................................................................................................................9

2.7.1 Operating scheme for memory mode.................................................................................... 11

2.8 Combining individual modes ...................................................................................................11

3For all those who wish to learn more about Tuning Set …..........................................................12

3.1 The equal temperament............................................................................................................12

3.2 The "cent" unit...........................................................................................................................12

3.3 The target frequency genaration of CTS 5-C ..........................................................................12

3.4 The "cent"-values of the historical temperaments.................................................................13

3.4.1 The "cent"- relation function.................................................................................................. 13

3.4.2 The transposer...................................................................................................................... 13

3.4.3 The adjustment of "cent relation function" and transposer ................................................... 14

3.5 The "cent"- settings for piano tuning......................................................................................14

3.6 The PIANYZER - how to make an individual piano tuning ....................................................15

3.6.1 How to create a stretching by the analysis of a piano (ANALYZER) .................................... 15

3.6.2 How to produce a piano stretching by entering of support values (Piano Editor) ................. 17

3.6.3 Sample diagram of an piano stretching generated by the PIANYZER.................................. 17

3.6.4 Control scheme for using the PIANYZER ............................................................................. 19

3.7 Special settings.........................................................................................................................20

4Technical data Tuning Set CTS-5-C ...............................................................................................21

1 Initial Operations

Congratulations on the purchase of your Tuning Set CTS-5. It will make the tuning of all kinds of

musical instruments much easier. Part 1 of these operating instructions contains general

information about the Tuning Set. Part 2 gives examples on how to learn the most important

functions, and part 3 is for those of you who want to know all about this Tuning Set.

1.1 Power

The Tuning Set is equipped with 4 rechargeable NiMH batteries (1.2 Volt 2000 mAh). The

operating period with one battery charge lasts approx. 12 hours. When the batteries are low, the

indicator "LOW BAT" appears in the LC-display. In order to avoid deep discharge of the

batteries, the device will automatically shut off. The battery can be recharged with the supplied

plug-in transformer. The batteries are fully recharged after approx. 14 hours. When the plug-in

transformer is connected, the yellow charge control LED is lit. When the batteries are fully

charged, the transformer will not automatically shut down. Therefore, the tuning device should

be disconnected after the charge. The instrument can be operated without risk during the

recharging process.

Should the operating period with one battery charge decrease at some point to much less than

8 hours, the following may have occurred:

1. The battery set is defect. Measure to be taken: Install new batteries.

2. The plug-in transformer is defect. Measure to be taken: Replace the transformer.

(7.5 Volt (min) 400 mA DC stabilized, hollow plug 5 x 2 mm plus outside)

3. The Tuning Set is defect. Measure to be taken: The charger and Tuning Set should be sent

in for maintenance.

If you constantly use the device with the plug-in transformer connected, it is advisable to

remove the batteries to avoid permanent-charging damage.

1.1.1 Battery change

Please use only rechargeable NiMh batteries. Non-Rechargeable Batteries are leaking

when the AC adapter is plugged in. The acid will destroy the device.

Remove back cover.

Replace batteries and pay attention to the

correct polarity.

1.2 Switching on the Tuning Set.

Switch on the Tuning Set with the slide switch on the

right side of the Tuning Set. For approx. one second

you see the program version, and then the following

indication:

Should one of the next two indications appear, please go to the next paragraph.

1.3 Selection of language for operator guidance

Your Tuning Set can converse with you in English, French, German or Italien. Select the

desired language as follows:

1. Turn off the Tuning Set.

2. While with the left hand depressing and holding the key

"S", switch on the Tuning Set. Continue depressing the

key "S" until you see this indicator.

With the "< >" key you can select your desired language. Confirm it with the "E" key.

From then on the operator guidance language displayed by the Tuning Set is in the language

you have selected. Switching the Tuning Set on or off does not change the language.

1.4 Introduction to the diagram for modes of operation

The Tuning Set is basically operated with the keys "<", ">", and "E". With the basic keys you can

find your way through the included Diagram for Modes of Operation, like on a 'city map'. You are

now, after turning on the Tuning Set, in the upper left hand corner, shown by the big black

arrow.

With the keys "<" and ">" you can move to the left and right, and select one of the following

modes:

>1< TUNING Tuning with the strobe display

>2< PITCH Mode for standard pitch adjustment

>3< CENTMESS Measuring or adjustment of a tone in cent

>4< TEMPERATURE Mode for historical temperaments

>5< STRETCHING Mode for tuning pianos

>6< MEMORY Storage of one piano tuning or one historical temperament

>7< PIANYZER Create an individual piano tuning

With the key "E" you can move downward on the diagram. The selected mode is activated. If

you press the key "E" again, you will enter the next user level or you will move upward, and are

leaving the activated mode.

Selecting the wrong key or mode will not damage the Tuning Set. The stored temperatures and

stretchings are protected and cannot be erased or changed by depression of a wrong key. In

order to become acquainted with the Tuning Set, please play and experiment with the keys to

your heart's content.

To quickly familiarize yourself with the Tuning Set, follow the examples given in part 2 on a

musical instrument, and closely stick to the guidance.

>1< STIMMEN ->

>1< TUNING ->

>1< ACCORDER ->

>1< ACCORDARE->

LANGUAGE

English

Don't try to memorize the key sequences in the examples. Try to understand the operation of

the Tuning Set by tracing the example steps on the diagram.

Note the arrow in the lower, right hand corner of the LC-Display:

When this arrow appears, the keys ">" and "<"are

used for mode selection. You are then at the highest

operating level of the diagram for operation modes.

The text in the display then shows you what you may do with the keys "<" and ">", after you

have depressed the key "E":

>1< TUNING Select a tone

>2< PITCH Select the standard pitch

>3< CENTMESS Measuring or adjustment of a tone in cent

>4< TEMPERATURE Select a historical temperament

>5< STRETCHING Select a piano stretching

>6< MEMORY Storage of one piano tuning or one historical temperament.

>7< PIANYZER Create an individual piano tuning

Pressing the key "E" makes the arrow disappear. The Tuning Set is now in the selected mode.

With the keys "<" and ">" you can now carry out your previously selected mode.

By pressing the key "E" again you enter the next user mode.

If the arrow will reappear, you have left the mode. With the keys "<" and ">" you may select a

new mode of operation. The input or adjustment made within a mode will remain intact after you

exit the mode.

A special case ist the mode number 6 (MEMORY). This mode you only can leave by tapping

both keys "S" and "E".

All inputs or adjustments made in the operation modes will not be erased by turning the Tuning

Set on or off. One exception is the standard pitch, which automatically resets to a1 after the

Tuning Set is turned on.

1.5 Erasing all inputs

Should you have stumbled in your first walking trials, and put in a non desired setting, you may

return to the original settings contained in the Tuning Set upon delivery:

Standard pitch: 440 Hz

Temperature: Equal Temperament

Stretching: None

Transpose Function and Cent Relate Function: Off

Operate as follows:

Turn off the Tuning Set. Simultaneously depress keys "A"

and "E" with the left hand until you have switched on the

Tuning Set with your right hand. Continue holding the keys

until the LC-Display indicates:

1.6 Timer switch

A timer was installed in the Tuning Set, to save battery power. If you don't use the set for twenty

minutes, it will automatically turn off. Before shutdown it will set off several short accoustical

signals. This allows you to prevent shutdown by depressing one of the five keys. If the Tuning

Set automatically turned off, you may restart it with the on/off lever on the right side by switching

it off and on. You may turn off the timer completely (see chapter 3.7).

<1> TUNE ->

Inhaltsverzeichnis

Andere TLA Tuner Handbücher

TLA

TLA CTS-5-C Bedienungsanleitung

Beliebte Tuner Handbücher anderer Marken

Tunersys

Tunersys WS16 1 Bedienungsanleitung

Arcam

Arcam DT91 Bedienungsanleitung

Magnum

Magnum MD 102T Bedienungsanleitung

HDHomeRun

HDHomeRun 20121008 Bedienungsanleitung

Crestron

Crestron C2N-TXM Bedienungsanleitung

Eico

Eico HFT-92 Bedienungsanleitung

MFJ

MFJ MFJ-928 Bedienungsanleitung

NAD

NAD C 445 Bedienungsanleitung

Sony

Sony ST-SA5ES Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SC-FM1 Bedienungsanleitung

Antique Automobile Radio

Antique Automobile Radio 283501B Bedienungsanleitung

Monacor

Monacor PA-1200R Bedienungsanleitung

Technics

Technics ST-X301L Bedienungsanleitung

Manhattan

Manhattan 176156 Bedienungsanleitung

Marantz

Marantz ST-15S1 Bedienungsanleitung

Korg

Korg HA-40 Bedienungsanleitung

Harman Kardon

Harman Kardon TU915 Bedienungsanleitung

Teac

Teac T-1D Bedienungsanleitung