TomTom 4CS03 Bedienungsanleitung
2
What’s in the box
What’s in
the box aTomTom GO
AOn/Off button
BMicrophone
CLight sensor
DSpeaker
EMemory card (micro SD card) slot
bActive Dock cUSB car charger
dUSB cable eDocumentation pack
A
B
C
D
E
Siena-USA-UG-NONLIVE.book Page 2 Thursday, June 24, 2010 2:32 PM
3
Mounting your device EN
Mount-
ing your
device Mounting your navigation device
1. Push the EasyPort™ Mount on your TomTom GO against the windshield in your car.
2. Lock the EasyPort Mount by twisting the base.
Siena-USA-UG-NONLIVE.book Page 3 Thursday, June 24, 2010 2:32 PM
4
Mounting your device
3. Lock the EasyPort Mount by twisting the base.
4. Insert the Car Charger into your device. Insert the Car Charger into the cigarette lighter
in your car.
Siena-USA-UG-NONLIVE.book Page 4 Thursday, June 24, 2010 2:32 PM
5
Mounting your device EN
5. Switch your device on by pressing the On/Off button on the top of your device.
6. You now have to answer some questions to set up your device. Tap the screen to answer
the questions.
Siena-USA-UG-NONLIVE.book Page 5 Thursday, June 24, 2010 2:32 PM
6
Mounting your device
7. To remove the Mount from your windshield, first unlock the EasyPort Mount, then gently
pull one of the tabs. The Mount comes away from the windshield.
Siena-USA-UG-NONLIVE.book Page 6 Thursday, June 24, 2010 2:32 PM
Getting started
7
EN
Getting
started Switching on and off
Install your TomTom GO navigation device
in your car following the instructions in the
installation section at the start of this book.
To switch on your navigation device, press
and hold the On/Off button until you see the
start-up screen. The first time you switch on
your device, it may take a short time to start.
Setting up
When you first switch on your device, you
have to answer a few questions to set up the
device. Answer the questions by tapping
the screen.
You are asked whether you make regular
trips to the same locations. If you tap YES,
you can enter these destinations as your
favourite destinations. Every time you
switch on your device, you can immediately
select one of these locations as your desti-
nation.
To change these destinations or select a
new destination, tap Start-up preferences in
the Preferences menu, then select Ask for a
destination.
Device not starting
In rare cases, your TomTom GO navigation
device may not start correctly or may stop
responding to your taps.
First, check that the battery is properly
charged. To charge the battery, connect
your device to the car charger. It can take up
to 2 hours to fully charge the battery.
If this does not solve the problem, you can
reset the device. To do this, press and hold
the On/Off button for 15 seconds and
release the button when your device begins
to restart.
Siena-USA-UG-NONLIVE.book Page 7 Thursday, June 24, 2010 2:32 PM
Getting started
8
Battery notes
The battery in your TomTom GO navigation
device charges when you connect it to the
car charger or to your computer.
When you connect your device to a com-
puter, you are asked if you want to connect
to the computer. If you select No and then
do not tap the screen within three minutes,
the device will automatically switch off. This
happens so that the battery can charge
faster.
Note: You should plug the USB connector
directly into a USB port on your computer and
not into a USB hub or USB port on a keyboard
or monitor.
GPS reception
When you first start your TomTom GO nav-
igation device, the device may need a few
minutes to determine your GPS position
and show your current position on the map.
In future, your position will be found much
faster, usually within a few seconds.
To ensure good GPS reception, you should
use your device outdoors. Large objects
such as tall buildings can sometimes inter-
fere with reception.
Siena-USA-UG-NONLIVE.book Page 8 Thursday, June 24, 2010 2:32 PM
Safety
9
EN
Safety Positioning the EasyClick Mount
Consider carefully where to attach the
mount in your car. The mount should not
block or interfere with any of the following:
• Your view of the road
• Any of the controls in your car
• Any of your mirrors
• The airbag
When your navigation device is in the
mount, you should be able to reach the
device easily without leaning or stretching.
The diagrams show where you can safely
attach the mount.
You can attach the mount to the wind-
screen, side window or use a Dashboard
Mount Disk to attach the mount to your
dashboard. TomTom also offers alternative
mounting solutions for your TomTom navi-
gation device. For more information about
Dashboard Mount Disks and alternative
mounting solutions, go to tomtom.com/
accessories.
Installing the Active Dock
Make sure that both the Active Dock and
your window are clean and dry.
1. Press the suction cup firmly against the
window on an area where the glass is
flat.
2. Twist the rubber grip near the base of the
Active Dock in a clockwise direction until
you hear a click.
The Active Dock is now installed.
Siena-USA-UG-NONLIVE.book Page 9 Thursday, June 24, 2010 2:32 PM
10
Planning a route
Planning
a route Planning a route with your ProductName-
Long navigation device is easy. To plan a
route, follow the steps below.
Important: For safety reasons, you should
always plan a route before you start your
journey.
1. Tap the screen to bring up the Main
Menu.
Note: The buttons on your navigation device
are shown in full colour unless a button is cur-
rently unavailable.
2. Tap Navigate to... Plan route.
3. Tap Address.
In this example, we will enter an address.
cMakingYourFirstJourney-nonLIVE.fm Page 10 Thursday, June 24, 2010 3:29 PM
11
Planning a route EN
4. Tap Street and house number.
Note: When planning a trip for the first time
your navigation device asks you to choose a
state or country. Your choice is saved and used
for all routes you plan.
You can change this setting at any time by tap-
ping the flag.
5. Start to type the name of the town where
you want to go. Tap the name when it is
shown in the list.
Tip: Instead of typing the name,
tap this button to say the address
by speaking to your navigation
device.
6. Start to type the street name. Tap the
name when it is shown in the list.
cMakingYourFirstJourney-nonLIVE.fm Page 11 Thursday, June 24, 2010 3:29 PM
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere TomTom Auto-Navigationssystem Handbücher
TomTom
TomTom BRIDGE Bedienungsanleitung
TomTom
TomTom Go 730 Bedienungsanleitung
TomTom
TomTom Mazda NB1 Bedienungsanleitung
TomTom
TomTom BRIDGE Bedienungsanleitung
TomTom
TomTom GO Bedienungsanleitung
TomTom
TomTom Blue&Me-TomTom Bedienungsanleitung
TomTom
TomTom PRO 2020 Bedienungsanleitung
TomTom
TomTom BRIDGE Bedienungsanleitung
TomTom
TomTom GO Bedienungsanleitung
TomTom
TomTom Blue&Me TomTom 2 Bedienungsanleitung
TomTom
TomTom GO Bedienungsanleitung
TomTom
TomTom 2015 BRIDGE Bedienungsanleitung
TomTom
TomTom RIDER Bedienungsanleitung
TomTom
TomTom Mazda NB1 Bedienungsanleitung
TomTom
TomTom RIDER Bedienungsanleitung
TomTom
TomTom BRIDGE Bedienungsanleitung
TomTom
TomTom Blue&Me-TomTom 2 LIVE Bedienungsanleitung
TomTom
TomTom 4PN50 Bedienungsanleitung
TomTom
TomTom GO Bedienungsanleitung
TomTom
TomTom GO Bedienungsanleitung
Beliebte Auto-Navigationssystem Handbücher anderer Marken
Sanyo
Sanyo NVM-4030 - Easy Street - Automotive GPS... Bedienungsanleitung
Kenwood
Kenwood DNN991HD Bedienungsanleitung
AvMap
AvMap Geosat 2C Bedienungsanleitung
Eonon
Eonon GE01B Bedienungsanleitung
Pioneer
Pioneer AVIC-Z920DAB Bedienungsanleitung
Nextar
Nextar M3-MX - Automotive GPS Receiver Bedienungsanleitung
Furrion
Furrion NV2200 Bedienungsanleitung
Mio
Mio MOOV 200-Series Bedienungsanleitung
Prestigio
Prestigio GeoVision 5150 Bedienungsanleitung
Hummer
Hummer 2006 H3 Bedienungsanleitung
Magellan
Magellan Maestro 4210 - Automotive GPS Receiver Konfigurationshandbuch
Garmin
Garmin StreetPilot c510 Bedienungsanleitung