Topper WOW RO System Bedienungsanleitung
INSTALLATION & USER MANUAL
for
Undercounter WOW RO Systems
23880 Madison Street, Torrance, CA 90505 - (310) 375-5000 - www.wowwater.com
V13-2.12.18
Powered by
Scan with QR Reader App
Visit our website: www.wowwater.com
Place Data Label Here
2
The WOW RO System operates by removing contaminants from water at the molecular level. By
using your household water pressure to squeeze your water against a special membrane, water
molecules are separated from impuries. Rejected dissolved solids are automacally rinsed down
the drain leaving only high-quality, delicious water for you to use.
1. The WOW RO System will replenish approximately 1.5 gallons (5.7 L) in 35–90 minutes, de-
pending on your incoming water pressure, quality and temperature. This appliance is designed
with a self-regulang ush feature that limits the reject water to approximately 2 gallons (7.6 L)
for every gallon (liter) of treated water. Your appliance will perform beer and last longer with
heavy use. We encourage you to water house plants, provide water for pets, cook, mix drinks,
ll baeries, etc., with treated water. Cauon: The working capacity of this appliance depends
on the pressure and temperature of the water supply. This appliance is not guaranteed to
work properly with water pressure less than 20 psi (1.4 bar) and water temperature less than
40°F (4°C).
Introduction to The WOW RO System
General Information
2. The storage tank will store 1.5 gallons (5.7 L) of water.
3. The WOW RO System can be connected to a variety of appliances, including your automac ice
maker, cold water dispenser in the refrigerator door, coee maker, water cooler and other
commercial applicaons.
4. The WOW RO System is designed to be connected to cold water only.
Cauon: Never run hot water through your appliance.
5. The ow of water through your treated water faucet will not be as strong as your sink faucet.
6. The WOW RO System is made of safe, non-toxic, health and environment-friendly materials.
BPA Free.
Warning: Do not allow your appliance to freeze.
Figure 1: Installation Diagram
3
Introducon to The WOW RO System .......................................................................................2
General Informaon...................................................................................................................2
Secon 1-Installaon & Start-up Procedures...........................................................................5
Avoid Common Mistakes............................................................................................................6
Pre-installaon Checklist............................................................................................................7
Installaon Tool List ...................................................................................................................7
Installaon Kit Contents .............................................................................................................8,9
Part Inspecon ...........................................................................................................................10
Proper Placement of Filters........................................................................................................10
Installing Filter Cartridges ..........................................................................................................11
Connecng the System...............................................................................................................12
Start-up Procedure.....................................................................................................................13
Secon 2-Connecng Addional Appliances to WOW RO System .........................................14
Connecng to Mulple Appliances ............................................................................................15
Refrigerator/Ice-maker/Coee-maker/Cooler setup ................................................................16-21
Secon 3– When More Water is Needed .................................................................................22
Adding Extra Storage Tanks........................................................................................................23
Modular Expandability ...............................................................................................................24
Secon 4-Plumbing the Sink......................................................................................................25
Install Drain Saddle Assembly ....................................................................................................26
Prepare Sink for RO Faucet Installaon .....................................................................................27
Install Incoming Water Supply Valve..........................................................................................28
Secon 5-Maintenance..............................................................................................................29
Changing Filters ..........................................................................................................................30
Recommended Filter Replacement............................................................................................31
WOW RO System Appliance.......................................................................................................32
Sanizing Water-on-Water ........................................................................................................33
Notes ..........................................................................................................................................34
Secon 6-Troubleshoong ........................................................................................................35
Troubleshoong Tables..............................................................................................................36,37
Owner Informaon....................................................................................................................38
2 Year Limited Warranty ...........................................................................................................39
Contents
4
Figure 1: Installaon Diagram
5
Secon 1
Installaon & Start-up Procedures
6
AVOID COMMON MISTAKES !
Review the most common missed steps made BEFORE starng. This will ensure an easy and
successful installaon.
1. Prepare and install all service components such as RO faucet, drain, and valve before
installing WOW RO System (Pages 26-28).
2. Fully pre-ll lter cartridges according to Step 3 (Page 11) to remove all air before
aaching to system.
3. When installing pre-lled lters to system, you MUST make sure they are properly
aached and engaged to the stop tabs per Step 3 (Figure 3, Page 11) instrucons.
Filters are labeled PRE, POST and RO. Ensure each lter matches posion on RO unit
manifold.
4. If replacing an exisng RO unit under the sink, you MUST ensure an independent iso-
laon valve is used between the WOW RO System and any added outlets. Without an
isolaon valve, the WOW RO System will not start. Refer to Secon 2 for connecng
addional appliances.
5. Before beginning Start-up Procedures (Step 5, Page 13) make sure all tube connecons
match the Figure 1 diagram on Page 4.
6. Make sure unit is ONLY connected to a cold water supply (Page 7).
7. If your connecons to and from WOW RO System have a leak (even one drop), the sys-
tem will not work. Repair leak (see Troubleshoong if necessary) and repeat Start-up
Procedures (Step 5, Page 13).
8. To avoid air-gap overowing onto counter, air-gap return line must never have loops or
sags in tubing.
9. If you are not using WOW’s RO installaon kit, it is crical that installers use correct
color coded tubing (See installaon kit contents, Page 8) to ensure easy trouble
shoong or add-on appliance follow-up.
10..If replacing an exisng RO unit, make sure you replace all old tubing with new color
coded tubing.
Installation Steps and Start-Up Procedures
7
Installation Steps and Start-Up Procedures
Warning: Installaon of this appliance must conform with state and local plumbing codes,
laws, regulaons, and the instrucons provided with this appliance. Failure to install as in-
structed will void the product warranty.
Pre-Installaon Checklist
• Look under sink to idenfy where the unit will rest.
• To idenfy hot from cold, turn on hot water at the sink unl hot water is owing. Touch
pipes below and mark cold from hot.
• Idenfy desired locaon for new faucet and mark sink for drilled hole, unless hole is pre-
exisng.
• Review tool kit supplies needed (Table 1).
• Open box and conrm 3 lter cartridges (PRE, POST & RO), 1 RO unit (tank & manifold)
and installaon kit (if purchased *).
* If installaon kit is not purchased, you will need:
3— 4’ x 1/4” tubing
1— 3/8” drain saddle (sized for air-gap or non air-gap)
1— 3/8” tubing if air-gap is desired
1— Feed water adapter
1— 1/4” WOW RO emergency shut-o valve
1— Faucet with appropriate connector to 1/4” tubing
Step 1
Recommended Tool List Professional Installers “Must Have” Tool List
Relton drill 1-1/4” assembly (HST-20)
(porcelain sinks)
2 pressure gauges adapted to 1/4” tube
Greenlee 1/2” to 1-1/4” punch
(stainless steel sinks)
Conducvity or TDS meter
1” to 1-1/4” Carbide drill bit or hole saw Tubing cuer or sharp knife
7/16” open-end wrench
1/2” open-end wrench
9/16” open-end wrench
5/8” open-end wrench
Medium-sized (#2) Phillips screwdriver
Table 1:
Recommended Tool List
8
Installation Kit Contents
A
B
CD
E
F
G
H
I
G
9
A. Non air-gap faucet
B. Air-gap faucet
C. Non air-gap faucet hardware
D. Air-gap faucet hardware
E. Drain saddle—(1/4”)
F. Drain saddle—(3/8”)
G. 1/4” WOW RO emergency shut-o valve
H. Feed water adapter
I. Tubing for install connecons:
•Black 3/8” - Air-gap return line to 3/8”drain saddle
•Black 1/4” - Air-gap drain feed to faucet/D port to non air-gap
drain saddle
•Red 1/4”
•Blue 1/4”
Installation Kit Legend
10
Installation Steps and Start-Up Procedures
Inspect Unit Parts from Box
Cartridge Inspecon:
•Remove red cap on pre-lter and post-lter.
• Conrm that external large O-Ring is in place.
• Conrm that 2 smaller O-Rings are in place (located in center).
•Remove red cap on RO-membrane.
• Conrm that large external O-Ring is in place.
• Conrm that medium O-Ring is in place.
• Conrm that 2 small O-Rings are in place (located in center).
• If any O-Rings are missing, please call our service center: (866) 790-8911 ext: 4
Step 2
Cauon:
Cartridges must line up with tank
cutouts when present
Newer systems may not have cutouts
Proper Placement of Filters
Figure 2:
Inhaltsverzeichnis
Beliebte Wassersystem Handbücher anderer Marken
Spirotech
Spirotech SPIROVENT SUPERIOR S250 Bedienungsanleitung
Culligan
Culligan Aqua-Cleer Aqua-Cleer Advanced Drinking Water... Bedienungsanleitung
A.O. Smith
A.O. Smith Dura-Max AJH - 1000A - P Bedienungsanleitung
Microline
Microline T.F.C.-4 Handbuch
Eureka Forbes
Eureka Forbes Aquaguard Select Bedienungsanleitung
Cetetherm
Cetetherm AquaEfficiency Bedienungsanleitung
