Toro 170-DH Bedienungsanleitung

Printed in the USA

2001 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

170-DH and 190-DH

Lawn Tractor

Model No. 74570—Serial No. 220000001 and Up

Model No. 74590—Serial No. 220000001 and Up

Form No. 3327-598

Installation Instructions

Loose Parts

Note: Use the chart below to verify all parts have been shipped.

Description Qty. Use

Steering Wheel

Lock washer

Nut

1Install the steering wheel.

Seat

Bolt

Flat Washer

Spring Washer

Install the seat.

Trailer Hitch

Bolt

Washer

Nut

Attach the trailer hitch.

Collector Cover

Grass Collector—Partially Assembled

Grass Bag

Fastener Package

Arrow Decal

Assemble the grass collector.

Key 2 Used in the ignition and Key Choiceswitch.

Operator’s Manual

Engine Operator’s Manual 1

1Read before operating tractor.

Installing the Steering Wheel

1. Position the front wheels straight ahead.

2. Remove the logo cover by releasing the 3 latches from

the back side with a screwdriver.

3. Line up the center spoke toward the seat and position

the steering wheel onto the shaft spline (Fig. 1).

4. Secure the steering wheel with a lockwasher and nut

(Fig. 1).

5. Torque the steering wheel nut to 50 ft-lb. (37 N.m).

6. Snap the logo cover into place (Fig. 1).

2307

Figure 1

1. Center spoke

2. Shaft spline

3. Lock washer

4. Nut

5. Logo cover

Installing the Seat

1. Remove the plastic cover from the seat and discard it.

2. Loosen the two bolts on the tractor seat hinges.

3. Set the seat in place and secure it with the two bolts,

spring washers, and flat washers (Fig. 2).

4. Connect the safety switch to the seat (Fig. 2).

Figure 2

1. Safety switch 2. Bolt and washers

Attaching the Trailer Hitch

1. Line up the holes in the trailer hitch with the holes in

the tractor frame.

2. Attach the hitch with two bolts, washers, and nuts

(Fig. 3).

Figure 3

1. Trailer hitch

2. Bolt 3. Washer and nut

Assembling the Grass

Collector

1. Tilt the front tube of the partially assembled collector.

Align the upper holes with the holes on the upper tube.

Loosely fasten the tubes together with the upper bolts

(Fig. 4).

2. Place the collector on the rear tractor supports (refer to

the Operator’s Manual, Installing the Grass Collector)

and align the collector frame with the tractor fenders.

Tighten the upper bolts (Fig. 4).

3. Stretch the bag and put it over the rear handle (Fig. 4).

4. Insert the bottom tube into the bag (Fig. 4).

Figure 4

1. Cover

2. Upper bolts

3. Front tube

4. M5 bolts and nuts

5. Left and right supports

6. Screws

7. Lower brace

8. Corner supports

9. Bottom tube

10. Bag

11. Dumping lever

12. Rear handle

5. Insert the corner supports under the top tube. Fasten

the corner supports to the top and bottom tubes using

the M5 bolts and nuts from under the collector cover

(Fig. 4).

6. Fasten the bottom tube to the front tube with M5 bolts

and nuts (Fig. 4).

7. Tilt the left and right supports rearward. Place the

lower brace on the outside of the bag and secure it to

the left and right supports with the screws (Fig. 4).

8. Place the cover on the grass collector. Align the cover

with the rear fender by adjusting the rear tractor

supports until there is a proper seal between the cover

and the collector. Tighten the rear tractor support bolts.

9. Remove the grass collector from the tractor. Tighten

all screws securely.

10.Use the plastic extrusions on the bag edges to fix the

bag to the frame tube.

11. Insert the dumping lever through the hole of the cover

and secure it with the M5 x 12 screw and M5 nut

(inside the tube) (Fig. 4).

12.Install the grass collector to the tractor (refer to the

Operator’s Manual, Installing the Grass Collector).

When the grass collector is properly positioned, place

the triangle symbol decal directly opposite the triangle

symbol on the rear of the tractor.

Checking the Oil Level

The tractor is shipped from the factory with oil in the

engine crankcase; however, it may be necessary to add oil.

Refer to the Operator’s Manual, Engine Oil Specifications

for oil type, viscosity, and crankcase capacity. Add only

enough oil to raise the level to the “FULL” mark on the

dipstick.

Activating the Battery

1. Remove the battery from the tractor; refer to the

Operator’s Manual, Removing the Battery.

2. Remove the filler caps from the top of the battery.

Danger

Battery electrolyte contains sulfuric acid which is

a deadly poison if consumed, and it causes severe

burns.

•Do not drink electrolyte and avoid contact with

skin, eyes or clothing. Wear safety glasses to

shield your eyes and rubber gloves to protect

your hands.

•Fill the battery where clean water is always

available for flushing the skin.

•Follow all instructions and comply with all

safety messages on the electrolyte container.

3. Slowly pour electrolyte into each cell until the level is

up to the lower part of the tube.

4. Leave the filler caps off and connect a 3 to 4 amp

battery charger to the battery posts. Charge the battery

at a rate of 2 amperes or less for 4 hours (12 volts). Do

not overcharge the battery. Install the filler caps after

the battery is fully charged.

Charging the battery produces gasses that can

explode.

Never smoke near the battery and keep sparks

and flames away from the battery.

Warning

5. Install the battery in the chassis; refer to the Operator’s

Manual, Installing the Battery.

Filling the Fuel Tank

Add fuel to the fuel tank; refer to Filling the Fuel Tank in

the Operator’s Manual.

Checking the Tire Pressure

Check front and rear tires for proper inflation; refer to the

Operator’s Manual, Tire Pressure for recommended

inflation pressure.

Lubrication

Make sure all of the necessary points on the tractor are

lubricated; refer to Greasing and Lubrication in the

Operator’s Manual.

Inserting the Keys into the

Ignition and Key Choice

Switches

The Key Choice switch is located on the right side of seat

bracket below the seat.

Checking the Safety System

Refer to the Operator’s Manual, Testing the Safety

System.

Test Driving the Tractor

Make sure all electrical and mechanical systems are

operating properly. See the Operator’s Manual for proper

control function.

Andere Handbücher für 170-DH

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Toro Rasenmäher Handbücher

Toro

Toro 74437 Bedienungsanleitung

Toro

Toro 20323 Bedienungsanleitung

Toro

Toro Z Master 8000 Series Bedienungsanleitung

Toro

Toro 71429 Bedienungsanleitung

Toro

Toro 30864A Bedienungsanleitung

Toro

Toro 74416 Bedienungsanleitung

Toro

Toro Groundsmaster 5900 Kurzanleitung

Toro

Toro 78360 Bedienungsanleitung

Toro

Toro 71228 Bedienungsanleitung

Toro

Toro Super Recycler 20797 Bedienungsanleitung

Toro

Toro Z Master Professional 5000 Series Handbuch

Toro

Toro 29641 Bedienungsanleitung

Toro

Toro 73552 Handbuch

Toro

Toro 3674 Bedienungsanleitung

Toro

Toro GrandStand 74534TE Bedienungsanleitung

Toro

Toro Super Recycler 20783 Bedienungsanleitung

Toro

Toro 39692 Bedienungsanleitung

Toro

Toro Z Master Professional 3000 Series Bedienungsanleitung

Toro

Toro 30555 Bedienungsanleitung

Toro

Toro 21472 Bedienungsanleitung

Toro

Toro TimeMaster 21199HD Bedienungsanleitung

Toro

Toro Super Recycler 20036 Bedienungsanleitung

Toro

Toro ProLine 44410TE Bedienungsanleitung

Toro

Toro Z Master Commercial 3000 Bedienungsanleitung

Beliebte Rasenmäher Handbücher anderer Marken

RHINO

RHINO 1958 Bedienungsanleitung

Wolf Garten

Wolf Garten Compact plus 40 B Bedienungsanleitung

Cub Cadet

Cub Cadet LTX 1045 Bedienungsanleitung

GGP ITALY SPA

GGP ITALY SPA CR/CS 434 SERIES Bedienungsanleitung

Challenge

Challenge CH18V2 Betriebsanleitung

TALEN TOOLS

TALEN TOOLS AVR HGM30 Bedienungsanleitung

DEWEZE

DEWEZE ATM-725 Bedienungsanleitung

Weed Eater

Weed Eater 180083 Bedienungsanleitung

Husqvarna

Husqvarna Poulan Pro PP185A42 Bedienungsanleitung

Better Outdoor Products

Better Outdoor Products Quick Series Bedienungsanleitung

Cub Cadet

Cub Cadet 23HP Z-Force 60 Betriebsanleitung

MTD

MTD 795, 792, 791, 790 Bedienungsanleitung

Dennis

Dennis FT 610 Bedienungsanleitung

MTD

MTD 126-220-000 Bedienungsanleitung

Stihl

Stihl RMA 443 PV Bedienungsanleitung

Yard-Man

Yard-Man 3700-0 Bedienungsanleitung

AIRFORCE

AIRFORCE F-15 Gen 3 Bedienungsanleitung

MTD

MTD 050 thru 062 Bedienungsanleitung