Toro 2770 Bedienungsanleitung

Part No. 111-3987 Rev A

R3240T 4WD WIDE AREA MOWER

Model No: 02770-Serial No. from 310000001

Operator’s Manual

Original Instructions (EN)

Date: 21.09.10

ATTENTION

THIS SYMBOL MEANS

BE ALERT!

YOUR SAFETY IS INVOLVED

READ THIS MANUAL BEFORE USING THE R3240T MOWER.

IT IS ESSENTIAL THAT OPERATORS STUDY IT FOR THEIR

OWN SAFETY.

ALL OPERATORS SHOULD SEEK AND OBTAIN PROFESSIONAL AND

PRACTICAL INSTRUCTIONS ON THE SAFE USE OF THE MOWER.

THESE SERVICES ARE AVAILABLE THROUGH TORO APPROVED

COMMERCIAL DEALERS.

1.5 1.5

CONTENTS

CONTENTS Page No.

SAFETY PRECAUTIONS 1.7 - 1.17

Training 1.7

Preparation 1.8

Operation 1.9 - 1.10

Slopes 1.9

Handling and storage of uids 1.11

Maintenance and storage 1.12

Decals 1.13 - 1.18

EC CONFORMITY INFORMATION 1.19 - 1.20

Noise / Vibration levels 1.19

EC Declaration of Conformity 1.20

INTRODUCTION 1.21

SPECIFICATIONS 1.22 - 1.26

Engine 1.22

Transmission system 1.22

Cutterdeck drive system 1.23

Cutterdeck lift system and steering 1.23

Hydraulic system 1.23

Vehicle specications 1.24

Operator controls 1.25

Instrumentation 1.25

Weight and dimensions 1.26

Recommended lubricants and hydraulic uids 1.26

Cutterdeck 1.26

OPERATING THE MOWER 1.27 - 1.43

Safety Notice 1.27

Operator presence controls 1.27

Identication of control panel components 1.28

Braking system 1.29

Throttle control 1.29

Travel 1.29

Work/transport modes 1.30

Transport latches 1.30

Differential lock 1.31

Travel control pedals 1.31

Forward travel speed backstop lever 1.32

Operator platform latching mechanism 1.32

Adjustable steering column 1.33

Folding the R.O.P.S 1.34

Operator seat 1.35

Warning systems 1.36

Audible warning horn 1.36

Ignition key 1.37

Engine pre-heat indicator light 1.37

1.6 1.6

CONTENTS

CONTENTS Page No.

Fuel level gauge 1.37

Hour meter 1.37

Transmission neutral indicator light 1.38

Cutterdeck drive switch indicator light 1.38

Parking brake indicator light 1.38

Hydraulic return lter indicator light 1.38

Hydraulic transmission lter indicator light 1.38

Transmission system ‘Work’ mode indicator light 1.38

Cutterdeck position control 1.39

Cutterdeck drive engagement 1.39

Starting the engine 1.40

Stopping the engine 1.41

General operating hints 1.41

Cutterdeck general information height of cut adjustment - Front cutterdeck 1.42

Cutterdeck general information height of cut adjustment - LH & RH cut-

terdecks 1.43

MAINTENANCE 1.44 - 1.60

Maintenance 1.44 - 1.45

Engine 1.46

Running in period 1.46

Running in period - at rst 50 hours 1.46

Daily and before use 1.47 - 1.50

Every 50 hours 1.51

Every 250 hours 1.52

Every 500 hours 1.53 - 1.54

Cutterdecks 1.55

Cutterblades - Cutterblade Removal 1.56

Cutterblades 1.57

Raising the mower off the ground 1.58

Towing the mower 1.59 - 1.60

GRASS CUTTING FAULTS 1.61

TROUBLE SHOOTING 1.62 - 1.65

ELECTRICAL CIRCUIT DIAGRAM 1.66 - 1.68

TRANSMISSION/BRAKE HYDRAULIC CIRCUIT DIAGRAMS 1.69 - 1.70

HYDRAULIC CIRCUIT DIAGRAMS 1.71 - 1.72

WARRANTY 1.73

NOTES 1.74- 1.77

INTERNATIONAL DISTRIBUTION LIST 1.78

CUSTOMER INFORMATION 1.79 - 1.80

1.7 1.7

Training

Read the instructions carefully. Be familiar with the controls and the proper use of the equipment. Learn how

to stop the mower quickly in an emergency.

Never allow children or people unfamiliar with these instructions to use the mower. Local regulations may

restrict the age of the operator.

Never mow while people, especially children, or pets are nearby.

Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or

their property.

Do not carry passengers.

All drivers should seek and obtain professional and practical instruction. Such instruction should

emphasise:

The need for care and concentration when working with this machine.

The need to slow down when making tight turning manoeuvres. Failure to take adequate care can affect

stability leading to loss of control of the machine particularly when operating in transport mode.

Control of a ride-on-machine sliding on a slope will not be regained by application of the brake.

The main reasons for loss of control are:

- Insufcient wheel grip.

- Being driven too fast.

- Inadequate braking.

- The type of machine is unsuitable for the task.

- Lack of awareness of the effect of ground conditions, especially slopes.

- Incorrect load distribution.

READ THIS MANUAL BEFORE USING THE R3240T MOWER, IT IS

ESSENTIAL THAT OPERATORS STUDY IT FOR THEIR OWN SAFETY.

THE FOLLOWING PRECAUTIONS MUST BE TAKEN TO HELP PREVENT

ACCIDENTS. A CAREFUL OPERATOR WHO USES COMMON SENSE IS THE

SAFEST OPERATOR.

SAFETY PRECAUTIONS

This manual should be regarded as part of the machine, as it gives essential

information regarding machine safety, operation, maintenance and specications.

1.8 1.8

Preparation

Check that the machine complies with all applicable regulations, including those in force when used on the

public highway.

While mowing, always wear substantial footwear and long trousers. Do not operate the equipment when

barefoot or wearing open sandals. Eye protection should be worn.

Thoroughly inspect the area where the equipment is to be used and remove all objects which can be thrown

by the machine.

Never operate the machine without rst checking that the operator platform latching mechanism is fully

engaged and in good working order, refer to OPERATOR PLATFORM LATCHING MECHANISM.

Ensure that the cutterdecks are fully raised with the latches and safety locks engaged in position before

transporting the mower.

Replace faulty silencers.

Check the condition of the tyres and ensure that they are inated to the correct pressures, refer to

SPECIFICATIONS. This is particularly important if the machine is to be taken on the public highway.

Check that the mower is in good working order, paying particular attention to the brakes and steering. Also

ensure that the forward/reverse speed control pedals move freely to neutral when released.

Before use, always visually inspect to see that the blades, blade bolts and cutterblades are not worn or dam-

aged. Replace worn or damaged components.

Check the mower hydraulic system, particularly the hydraulic hoses, ttings and hose supports. Worn,

crushed or damaged hoses can burst, with risks to health and damage to the machine and surrounding turf

areas.

After refuelling and adding oil to the hydraulic oil tank ensure that the caps are replaced securely.

Check that all linkages, connections and pivot nuts are secure and that wheel nuts are torqued correctly,

refer to SPECIFICATIONS.

Before operating the machine ensure that there are no foreign objects or liquids on the platform or

pedals - ALWAYS KEEP THE OPERATOR PLATFORM CLEAN/CLEAR.

Always make sure that the folding R.O.P.S is secured in its vertical operating position before use.

SAFETY PRECAUTIONS

1.9 1.9

Operation

Do not operate the engine in a conned space where dangerous carbon monoxide fumes can collect.

Mow only in daylight or in good articial light.

Before attempting to start the engine, engage the parking brake, disengage the cutterdeck drive system and

ensure that the forward/reverse speed controls are in the neutral position.

Never operate the machine without rst checking that the operator platform latching mechanism is fully

engaged and in good working order, refer to OPERATOR PLATFORM LATCHING MECHANISM.

Stored energy devices are charged when the outer wing units are in transport position. Always operate the

relevant lift controls to provide hydraulic support for the wing units suspensions before attempting to release

the transport latches.

Slopes

Do not use on a slope of more than 14 degrees. Care should be taken when using the mower on any slope

where ground conditions are such that there may be a risk of the mower rolling over. The requirements of

89/355/EEC, as amended by 95/63/EEC ‘Provision and Use of Work Equipment Directive’ should be

considered.

Stability angles given are maximum gures for a machine equipped with a R.O.P.S and are for guidance only.

Particular conditions such as wet grass or uneven ground may not permit safe operation on the slope limits

stated.

Remember there is no such thing as a ‘safe’ slope. Travel on grass slopes requires particular care. To guard

against overturning or loss of traction when travelling or mowing on a slope:

- Exercise extreme care when changing direction on a slope.

- Do not stop or start suddenly.

- Engage drive slowly.

- Keep machine speed low.

- Avoid tight turns.

- Stay alert for humps, hollows and other hidden hazards.

- Keep away from sharp inclines and steep drops.

- A thorough risk assessment should be carried out by a competent

person before travelling or mowing on a slope.

Never park on a slope.

SAFETY PRECAUTIONS

14 Degree Slope

Ground level

Fig 1

1.10 1.10

Operation continued

Watch out for trafc when crossing or near roadways.

Use extreme caution when reversing.

Disengage the cutterdeck drive system before crossing surfaces other than grass.

When using the machine, never direct discharge of material towards bystanders or allow anyone near the

machine while in operation.

Never operate the mower with defective guards, shields or without safety protective devices in place and in

good working order.

Do not change the engine governor settings or overspeed the engine. Operating an engine at excessive speed

may increase the risk of personal injury.

Before leaving the operator’s position:

- Disengage the drive to the cutterdecks.

- Lift cutterdecks to the transport position and securely lock the safety latches

or alternatively lower cutterdecks to the ground.

- Ensure the transmission is in neutral and engage the parking brake.

- Stop the engine and remove the ignition key.

Engage the parking brake, disengage the drive to the cutterdecks, stop the engine and remove ignition key:

- Before releasing blockages.

- Before checking, cleaning or working on the mower.

- After striking a foreign object. Inspect the mower for damage and make

repairs before restarting and operating the equipment.

- If the machine starts to vibrate abnormally (check immediately).

- Before refuelling.

- Before making cutterdeck adjustments.

Disengage the drive to the cutterdecks when transporting or not in use.

Reduce the throttle setting during engine run-out.

Never work on the mower when the engine is running.

Always keep feet and hands well away from the cutterblades when making adjustments.

Never operate the mower without rst checking that the operator platform is securely latched.

Always wear the seat belt when the folding R.O.P.S is in its vertical operating position.

Never wear the seat belt when the folding R.O.P.S is NOT in its vertical operating position.

Pay particular attention when operating due to the additional weight towards the front of the machine.

SAFETY PRECAUTIONS

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Toro Rasenmäher Handbücher

Toro

Toro Groundsmaster 5900 Series Bedienungsanleitung

Toro

Toro Z Master Professional 7500-DSeries Handbuch

Toro

Toro GrandStand 74549 Bedienungsanleitung

Toro

Toro 74915 Z Master G3 Bedienungsanleitung

Toro

Toro 74944 Bedienungsanleitung

Toro

Toro 22188TE Bedienungsanleitung

Toro

Toro 74960 Bedienungsanleitung

Toro

Toro Greensmaster 120-9600 Bedienungsanleitung

Toro

Toro Groundsmaster 580-D Bedienungsanleitung

Toro

Toro 04351 Greensmaster 3050 Bedienungsanleitung

Toro

Toro 71429 Bedienungsanleitung

Toro

Toro 74234 Bedienungsanleitung

Toro

Toro 44409 Bedienungsanleitung

Toro

Toro REELMASTER 4500-D Bedienungsanleitung

Toro

Toro ProLine 30196 Bedienungsanleitung

Toro

Toro Recycler 21465 Bedienungsanleitung

Toro

Toro 73552-9900001 Bedienungsanleitung

Toro

Toro GrandStand 74549 Bedienungsanleitung

Toro

Toro 30672 Bedienungsanleitung

Toro

Toro 73470 Handbuch

Toro

Toro 20001 Bedienungsanleitung

Toro

Toro TimeCutter Z4200 Bedienungsanleitung

Toro

Toro 74176 Bedienungsanleitung

Toro

Toro 20066 Bedienungsanleitung

Beliebte Rasenmäher Handbücher anderer Marken

RHINO

RHINO 1958 Bedienungsanleitung

Wolf Garten

Wolf Garten Compact plus 40 B Bedienungsanleitung

Cub Cadet

Cub Cadet LTX 1045 Bedienungsanleitung

Craftsman

Craftsman 917.378461 Bedienungsanleitung

GGP ITALY SPA

GGP ITALY SPA CR/CS 434 SERIES Bedienungsanleitung

Challenge

Challenge CH18V2 Betriebsanleitung

TALEN TOOLS

TALEN TOOLS AVR HGM30 Bedienungsanleitung

DEWEZE

DEWEZE ATM-725 Bedienungsanleitung

Weed Eater

Weed Eater 180083 Bedienungsanleitung

Husqvarna

Husqvarna Poulan Pro PP185A42 Bedienungsanleitung

Better Outdoor Products

Better Outdoor Products Quick Series Bedienungsanleitung

Cub Cadet

Cub Cadet 23HP Z-Force 60 Betriebsanleitung

MTD

MTD 795, 792, 791, 790 Bedienungsanleitung

Dennis

Dennis FT 610 Bedienungsanleitung

AIRFORCE

AIRFORCE F-15 Gen 3 Bedienungsanleitung

MTD

MTD 126-220-000 Bedienungsanleitung

Stihl

Stihl RMA 443 PV Bedienungsanleitung

Yard-Man

Yard-Man 3700-0 Bedienungsanleitung