Toshiba TLP-560 Bedienungsanleitung

Quick Start Reference Sheet

Toshiba TLP-560

Revision A

DR-TSH3 – 10/8/02 SP Controls reserves the right to modify specifications without notice at any time.

NOTE: This document is intended only as a quick reference for installation – please read the following

SP Controls Application Note for a complete description of this projector driver prior to installation.

I. Driver Features

1. Input Selection Mapping

Selection 1: COMPUTER

Selection 2: VIDEO

Selection 3: S-VIDEO

Selection 4: VIDEO

2. Hidden Function Mapping

Selection 1: ADJ -

Selection 2: ADJ +

Selection 3: ADJUST LEFT

Selection 4: ADJUST RIGHT

Off: MENU / SELECT

Volume Up: ADJUST UP

Volume Down: ADJUST DOWN

3. Other Driver Features

Power Status Feedback Method None (RS-232 Power Polling Unavailable)

Control Wiring Option IR Emitter

II. Wiring Specifications

NOTE: For a wiring diagram, please see the following Application Note

1. RS-232:

Wire the Panel RS-232 port to a male DB9 as follows:

RX to 2

TX to 3

GND to 5

Connect this male DB9 to the Toshiba adapter cable and connect to projector port labeled CONTROL

2. Infrared Emitter:

Wire the Panel IR/Serial port to a female 1/8" Mini as follows:

IR/SER to tip

GND to ring

Direct wiring to the IR Emitter is not recommended as it makes removal of the Panel for service more

difficult.

Attach to any projector IR port using the Panel’s IR Emitter (included with the Panel).

Note that the emitter glows red when IR is emitted so wiring can be verified.

Projector Driver Application Note

Toshiba TLP-560

Revision A

DR-TSH3 – 10/8/02 SP Controls reserves the right to modify specifications without notice at any time.

This document describes the SmartPanel Projector Driver for the Toshiba TLP-560 projector. For

information on configuring and using the Panel, see the SmartPanel Configuration and Installation Guide.

I. PROJECTOR CONTROL

A. Volume and Power Control

Volume control on the Toshiba is relative. Absolute volume control for this model is possible with use of

SP Controls’ optional Audio Follow Video Pre-Amplifier.

B. Input Selection Mapping

The following table specifies the factory preset input mapping for this Driver. The Configuration Utility

can be used to customize these settings your installation. NOTE: Inputs 2 and 4 select the same

Projector Input.

Selection 1: COMPUTER

Selection 2: VIDEO

Selection 3: S-VIDEO

Selection 4: VIDEO

Input choices available with this Driver are RGB,

VIDEO/S-VID, and CAMERA. The VIDEO/S-VID

port can be used as either an RCA video input

OR an S-Video input but not both.

C. Hidden Function Mapping

The following table specifies the factory preset hidden function mapping for this Driver. The

Configuration Utility can be used to customize these settings your installation.

Selection 1: ADJ -

Selection 2: ADJ +

Selection 3: ADJUST LEFT

Selection 4: ADJUST RIGHT

Off: MENU / SELECT

Volume Up: ADJUST UP

Volume Down: ADJUST DOWN

Hidden functions names are based on Toshiba documentation. Adjust controls navigate through

onscreen menus. Hidden functions are accessed by pressing the indicated key while the holding the On

key down.

The hidden functions available for the Toshiba with this Driver are as follows. Note that the functions

available will vary depending on the model of projector you are controlling:

MENU / SELECT

ADJUST LEFT

ADJUST RIGHT

ADJUST UP

ADJUST DOWN

AUDIO MUTE ON

AUDIO MUTE OFF

ALL MUTE ON

ALL MUTE OFF

FREEZE ON

ADJUST +

ADJUST –

Picture in Picture ON

Picture in Picture OFF

FREEZE OFF

Projector

Ready

Warm-up

OFF

Volume

INPUT 1

INPUT 2 INPUT 3 INPUT 4

Projector

Ready

Warm-up

OFF

Volume

ADJUST

DOWN

MENU / SELECT

ALL MUTE

OFF ADJUST

LEFT ADJUST

RIGHT

ALL MUTE

SmartPanel Projector Driver Application Note Toshiba TLP-560

D. Relays

The following table specifies the factory preset

settings for the low-current relays found on the rear

of the SmartPanel. The Configuration Utility can

be used to customize these settings your installation.

Relay 1 ON Maintained

Relay 2 ON Momentary

Relay 3 OFF Momentary

Selection Momentary; not Binary

E. Other Presets

The following table specifies other default factory settings for this Driver that affect is control of the

Projector.

Power Status Feedback Method None (see note 1)

Control Wiring Option IR Emitter

Control for the Toshiba with this Driver is via RS-232 and IR Emitter. The projector does not have a wired

remote port. Power polling is not available for this projector.

The following table specifies settings for the Panel’s configurable timers. For more information on the

inactivity shutdown feature and the lockout timer see the SmartPanel Configuration and Installation

Guide.

Lockout Timer 74 seconds (see note 3)

Inactivity Shutdown Disabled

RELAYS

PWR

MAINT.

PWR

MOM.

PWR

OFF

MOM.

SELECTION

(EXT. SWITCHER CTRL)

4321

500mA MAX. CURRENT

SmartPanel Projector Driver Application Note Toshiba TLP-560

II. CONTROL WIRING

PROJECTOR CONTROL

RS232 IR/SERIAL

GND

CTS

RTS

+12V

GND

IR/SER

SENSE

RS-232 to

RS-232C CONTROL

Toshiba PS/2 Mouse Adaptor Cable

(included with Projector)

1/8" Mini

Female

IR Emitter (included with Panel)

IR Emitter to

any projector IR

window

Male DB9 12345

6789

This section specifies how RS-232 and the Infrared Emitter

should be wired to the Toshiba projector.

A. RS-232 should be connected to the Toshiba control port

labeled RS-232C CONTROL. Connection should be as

follows:

1. Wire the Panel to a male DB9 as shown:

RX to 2

TX to 3

GND to 5

2. Connect this male DB9 to the Toshiba custom cable

(adapts DB9 to mini-DIN).

3. Connect the Toshiba custom cable to the projector port

labeled RS-232C CONTROL.

B. The Infrared Emitter (squirt) should be wired to any

Toshiba infrared port. Connection should be as

follows:

1. Wire the Panel to a female 1/8" Mini as shown; wire

IR/SER to tip and GND to ring. Direct wiring to the IR

Emitter is not recommended as it makes removal of the

Panel for service more difficult.

2. Attach to any projector IR port using the Panel’s IR

Emitter (included with the Panel).

Note that the emitter glows red when IR is emitted so wiring

can be verified.

SmartPanel Projector Driver Application Note Toshiba TLP-560

III. TROUBLESHOOTING

Additional tips can be found in the SmartPanel Configuration and Installation Guide.

The Panel does not do anything at all.

When power is applied to the Panel it should run through a brief power on self-test, during which all of

the Panel lights will turn on and off in sequence. If you do not see this self-test, make sure power is

connected correctly and that polarity is correct.

Only some of the projector controls work.

The Panel controls the Toshiba through RS-232 and IR. If only a subset of the controls is working,

verify that both types of control wiring are correctly wired.

The Panel keeps turning itself off even though the projector is on.

The Panel turns itself off when power verification indicates that the projector is off. Check to make

sure that any third-party power current sensor is correctly calibrated and wired to the Panel.

When I try to turn the projector on, the warming indicator (red LED) blink.

The projector is in the default configured lockout state, and the Panel is waiting for its internal lockout

timer to expire. This feature protects the projector’s bulb. Be sure to let your client know about this

behavior.

IV. TECHNICAL NOTES

1. The Toshiba projector does not allow power verification by RS-232 polling. A third party power

current sensor is recommended.

2. Control of this projector is through RS-232 and Infrared.

3. The lockout timer specifies the amount of time allowed between sending POWER OFF and POWER

ON to the projector (the delay allows the projector bulb to cool before re-powering). This delay can

be configured using the Configuration Utility; however, adjusting the lockout timer delay is

strongly discouraged as rapid re-powering causes undue wear on the projector’s bulb. Disabling

the lockout delay will cause potentially confusing Panel behavior.

V. REVISION HISTORY

1. Revision A (October, 2002)

Inhaltsverzeichnis

Andere Toshiba Projektor Handbücher

Toshiba

Toshiba TLP-510U Bedienungsanleitung

Toshiba

Toshiba TLP-MT7E Bedienungsanleitung

Toshiba

Toshiba TLP-X4500 Bedienungsanleitung

Toshiba

Toshiba TDP-S9 Montageanleitung

Toshiba

Toshiba TDP-S3 Bedienungsanleitung

Toshiba

Toshiba TLP-511U Bedienungsanleitung

Toshiba

Toshiba TDP-TW300U Bedienungsanleitung

Toshiba

Toshiba X100U - TLP XGA LCD Projector Bedienungsanleitung

Toshiba

Toshiba TDP-P5-US Bedienungsanleitung

Toshiba

Toshiba TLP-MT3E Bedienungsanleitung

Toshiba

Toshiba TDP-D1 Bedienungsanleitung

Toshiba

Toshiba TDP-MT200 Bedienungsanleitung

Toshiba

Toshiba TDP-SP1U - SVGA DLP Projector Bedienungsanleitung

Toshiba

Toshiba TLP-XD2000U Bedienungsanleitung

Toshiba

Toshiba TDP-TW420 Bedienungsanleitung

Toshiba

Toshiba TDP-T40 Bedienungsanleitung

Toshiba

Toshiba TDP-MT5 Bedienungsanleitung

Toshiba

Toshiba TDP-TW420 Bedienungsanleitung

Toshiba

Toshiba TLP-710U Bedienungsanleitung

Toshiba

Toshiba TDP-T3 Bedienungsanleitung

Toshiba

Toshiba TLP-X4500U Bedienungsanleitung

Toshiba

Toshiba TDP-S35U Bedienungsanleitung

Toshiba

Toshiba TLP X2500 Bedienungsanleitung

Toshiba

Toshiba TDP-PX10 Bedienungsanleitung

Beliebte Projektor Handbücher anderer Marken

iEmmet

iEmmet MP-312 Bedienungsanleitung

Epson

Epson VS400 Bedienungsanleitung

Sony

Sony VPL-HS10 Marketing Specifications & Features Bedienungsanleitung

Sony

Sony VPL-HW65ES Service-Handbuch

Philips

Philips LC1341 Referenzhandbuch

NEC

NEC NP600S EDU Bedienungsanleitung

BenQ

BenQ SH753P Bedienungsanleitung

Eiki

Eiki EK-623U series Bedienungsanleitung

Epson

Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 705HD Bedienungsanleitung

Christie

Christie LHD700 Bedienungsanleitung

Navitar

Navitar FX Bedienungsanleitung

InFocus

InFocus LitePro 560 Bedienungsanleitung

Sony

Sony SRX-R815P Bedienungsanleitung

Vivitar

Vivitar DP1500 X Bedienungsanleitung

Asus

Asus ZenBeam Latte Bedienungsanleitung

Epson

Epson PowerLite 810p Bedienungsanleitung

BOXLIGHT

BOXLIGHT CP-322i/CP-634i Bedienungsanleitung