Toshiba MK6025GAS Bedienungsanleitung

TOSHIBA AMERICA INFORMATION SYSTEMS

STORAGE DEVICE DIVISION

IRVINE, CALIFORNIA

MK6025GAS (HDD2189)

2.5-INCH HARD DISK DRIVE

USER MANUAL

CONTENTS

Introduction..............................................................................1

Setup ........................................................................................2

Using the HDD .........................................................................4

Troubleshooting.......................................................................5

Specifications ..........................................................................6

Drive Connectors.....................................................................8

INTRODUCTION – MK6025GAS (HDD2189)

General Features

•2.5" sized drive

•60 Gigabytes

•9.5mm High

•12ms Average Seek Time

•ATA-2,3,4,5,6 Interface

•Supports high transfer rates of 100 MB/sec

•8MB Buffer

•Rotational speed of 4,200rpm

•MTTF 300,000 Hours

SETUP – MK6025GAS (HDD2189)

Caution: Your Hard Disk Drive is a precision device and even a small drop onto any surface can cause

damage. Electronstatic discharge can also damage the drive. You should ground yourself prior to handling the

drive.

Master/Slave Settings

Your Toshiba Hard Disk Drive can be configured as either a "Master" or "Slave" unit. Master configuration is used

for all single drive applications, and master or slave configuration (only one of each per port) is used for two drive

applications. Use the information in the following table before setting drive as Master or Slave.

Master configuration is obtained by setting jumpers A, B, C & D open (no jumper present). Slave configuration is

obtained by setting jumpers C-D. When B-D jumper is installed, the drive is configured as cable select. If pin 28 =

Low, the drive is "Master", if pin 28 - High, the drive is "Slave".

Figure 1.HDD Jumper Locations

JUMPER P28 DRIVE

No Jumper - Master Drive

C-D Jumper - Slave Drive

B-D Jumper LOW Master Drive

B-D Jumper HIGH Slave Drive

A-B Jumper - Slave Drive

A-C Jumper - Prohibit

Installation Notes

The drive should be mounted carefully on the surface of 0.1mm or less flatness to avoid excessive

distortion.

In order to prevent short-circuit under any circumstances, a space of 0.5mm or more should be kept under

the PCB.

Space should be kept around the drive to avoid any contact with other parts, which may occur due to

shock or vibration.

The temperature of the top cover and the base must always be kept under 60C to maintain the required

reliability.

Be sure not to cover the breathing hole to keep the pressure inside the drive at a certain level

Do not apply any force to the top cover, except the screw areas on top cover. Maximum force to the

specified area is 2N.

The drive contains several parts which may be easily damaged by ESD (Electric Static Discharge). Avoid

touching the interface connector pins and the surface of PCB. Be sure to use ESD proof wrist strap when

handling drive.

The four mounting screws should be tightened equally with 0.3N-m (3kgf-cm) torque. The depth should be

3.0mm minimum and 3.5mm maximum.

Placing Hard Drive inside your Computer

•Determine mounting configuration (the drive can be mounted in either a horizontal or vertical orientation)

•Configure drive for system application.

•Configure the adapter board for the specific system application (if required).

•Install adapter board into an unused PC/AT 16 bit slot (if required).

•Install the I/F cable to the system's 44 pin connector port or adapter board. Ensure pin 1 is oriented

correctly, (pin 1 on the cable is usually identified by a red or blue strip.)

•Set correct drive type in system CMOS

•Refer to applicable manuals for software installation instructions.

Important Note: Disconnect power from your computer system before beginning installation.

Figure 2.HDD Mounting Holes

USING THE HARD DISK DRIVE – MK6025GAS (HDD2189)

Backing up Data Files

To avoid data loss, regularly back up the data files on the hard disk drive.

TROUBLESHOOTING – MK6025GAS (HDD2189)

Problem Solution

My system is not able to recognize all available capacity

on my Hard Disk Drive. What do I need to do to utilize

the complete hard drive?

There are some systems that are unable to recognize the

new larger Hard Drives on the market. 3rd party software

is available that breaks the "capacity barrier". Some

suggestions are EZ Drive by Micro House and Disk

Manager DiskGo by Ontrack. Check with your local

computer/software supplier for availability or contact the

software manufacturer.

How do I install my 2.5" Toshiba Hard Drive into my

desktop or tower system?

You will need a HDD mounting kit in order to install a

Toshiba 2.5" drive into your desktop or tower system.

Contact your local computer supplier for kit availability.

SPECIFICATIONS –MK6025GAS (HDD2189)

General

Model MK6025GAS (HDD2189)

Interface ATA-2/3/4/5/6

Functionality

Internal Drive Characteristics

Formatted Capacity 60.011GB

Rotational Speed 4200rpm

Avg. Rotational Latency 7.14/ms

Spin-up Time 4sec (typical)

Buffer 8MB

Seek Time (Average) 12

Internal Transfer Rate 201.6 ~ 307.5 Mbits/sec (max)

Host Transfer Rate 100Mbytes/sec

Number of Disks 2

Number of Read/Write Heads 4

Track Density (TPI) 88.1k

User Data Cylinders 42,480

Logical Cylinders 16,383

Logical Heads 16

Logical Sectors/track 63

Bytes per Sector 512

Logical Blocks (LBA) 117,210,240

Reliability

Preventative maintenance None

Nonrecoverable read errors 1 error per 1013 bits read

Electrical

Voltage 5V 5%

Power Consumption

Start 4.7W typ

Seek 2.6W typ

Read/Write 2.3W typ

Sleep 0.1W typ

Energy Consumption Efficiency 0.012W/GB avg

Shock

Operating 1,960m/s2(200G)(2msec)

Non-Operating 7,840m/s2(800G)(1msec)

Physical

Height 0.37" (9.5mm)

Width 2.75" (69.85mm)

Depth 3.94" (100mm)

Weight 3.46oz (98g) typ

Regulatory

The drive satisfies the following standards:

Underwriters Laboratories (UL) 1950

Canadian Standard Association (CSA) C22.2 No.220 No. 950

TUV Rheinland EN 60 950

EMC - EN50081-1 EN55022: 1988 Class B

EN60555-2: 1987+ A1

EN60555-3: 77A (Co) 38

EMC - EN50082-1 IEC 801-2: 1991

EIC 801-3: 1994

IEC 801-4: 1988

DRIVE CONNECTORS –MK6025GAS (HDD2189)

Figure 1.MK6025GAS HDD Rear View - Connectors

Interface Connector

Drive Side Connector Yamaichi GAP050K11617 or equivalent

Recommended Host Side Connector

Board Straight type: Berg 86455-044 86456-044 or equivalent

Cable Berg 89361-044 or equivalent

Recommended Cable Characteristics

Standard diameter 0.32mm (28AWG)

Characteristics impedance 100 - 132ohm

Max Length 0.46mm (max)

Capacitance 35pF (max)

* cable is not included with drive

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Toshiba Lagerung Handbücher

Toshiba

Toshiba MK7559GSM Bedienungsanleitung

Toshiba

Toshiba MK3259GSXP Bedienungsanleitung

Toshiba

Toshiba CANVIO AEROMOBILE Gebrauchs- und Pflegehandbuch

Toshiba

Toshiba MK1517GAP Bedienungsanleitung

Toshiba

Toshiba MK1001GRZB Bedienungsanleitung

Toshiba

Toshiba MK2018GAP Bedienungsanleitung

Toshiba

Toshiba MK1633GSG Konfigurationshandbuch

Toshiba

Toshiba MK2006GAL Bedienungsanleitung

Toshiba

Toshiba MK6026GAX Bedienungsanleitung

Toshiba

Toshiba 593209-D0 Gebrauchs- und Wartungshandbuch

Toshiba

Toshiba SecuRed Bedienungsanleitung

Toshiba

Toshiba STOR.E ART 4 Bedienungsanleitung

Toshiba

Toshiba DT01ACA050 Bedienungsanleitung

Toshiba

Toshiba Canvio AeroCast Bedienungsanleitung

Toshiba

Toshiba Canvio 640GB Bedienungsanleitung

Toshiba

Toshiba PX1267E-1G32 Bedienungsanleitung

Toshiba

Toshiba TRANSMEMORY U2M-004GT Bedienungsanleitung

Toshiba

Toshiba MK-150FA series Bedienungsanleitung

Toshiba

Toshiba FlashAir W-04 Anleitungen und Rezepte

Toshiba

Toshiba 288V Bedienungsanleitung

Toshiba

Toshiba STOR.E ALU 2 Bedienungsanleitung

Toshiba

Toshiba PX02SM series Bedienungsanleitung

Toshiba

Toshiba MK4019GAX Bedienungsanleitung

Toshiba

Toshiba MK1234 Kurzanleitung

Beliebte Lagerung Handbücher anderer Marken

QNAP

QNAP TS 32PXU Series Bedienungsanleitung

LaCie

LaCie RUGGED RAID Bedienungsanleitung

Freecom

Freecom CLS DOCK Bedienungsanleitung

PNY

PNY Attache P-FD64MBATT3 Bedienungsanleitung

HP StorageWorks MSL2024 Bedienungsanleitung

OLT

OLT 6x6 Maximizer Bedienungsanleitung

Transcend

Transcend JetFlash 160 Bedienungsanleitung

LaCie

LaCie RUGGED MINI Bedienungsanleitung

Thunderbolt

Thunderbolt 600 Bedienungsanleitung

Panasonic

Panasonic LB-DH8 series Handbuch

Intel

Intel RAID High Availability Bedienungsanleitung

LaCie

LaCie 12big Thunderbolt 3 Bedienungsanleitung

Spectra Logic

Spectra Logic T-Series Spectra T50e Bedienungsanleitung

Panasonic

Panasonic LKM-F931-1 Bedienungsanleitung

Tabernus

Tabernus Enterprise Erase E2400 Bedienungsanleitung

Rocstor

Rocstor COMMANDER 3F series Bedienungsanleitung

Western Digital

Western Digital Ultrastar Data60 Bedienungsanleitung

HP P9000 Bedienungsanleitung