13 2
TROUBLESHOOTING
Problem Check points
No reception -Check the battery status
-Check the connection and cables
-
Check the communication range
Poor reception,
static, noise
-
Change the location of the RX
-
Check the communication range
-
Check to see if unit is placed near
TV, speakers, or other electronic
devices
Unit does not
respond
-
Check the battery status
-
Check the power switch on the bottom
of the unit
-
Check the connection and cables
-
If the problem persists, please contact
technical support
Blinking GREEN
Talk LED on TX
AND
blinking GREEN
LED on RX
(when TX is
docked in RX)
-
Remove and re-insert the RF Main
Cable to restart the unit.
-
If the problem persists, please contact
technical support
TIP 2: Preserving the Batteries
CAUTION
1. When Using the Battery
Danger
(1) Misusing the battery may cause the battery to get hot, explode,
or ignite and cause serious injury. Be sure to follow the safety rules
listed below:
- Do not place the battery in fire or heat the battery.
- Do not install the battery backwards so that the polarity is reversed.
- Do not connect the positive terminal and the negative terminal of the
battery to each other with any metal object (such as a wire).
- Do not carry or store the batteries together with necklaces, hairpins, or
other metal objects.
- Do not pierce the battery with nails, strike the battery with a hammer, step
on the battery, or otherwise subject it to strong impacts or shocks.
- Do not solder directly onto the battery.
- Do not expose the battery to water or salt water, or allow the battery to get
wet.
(2) Do not disassemble or modify the battery. The battery contains safety
and protection devices which, if damaged, may cause the battery to
generate heat, explode or ignite.
(3) Do not place the battery on or near fires, stoves, or other high
temperature locations. Do not place the battery in direct sunlight, or
use/store the battery inside cars in hot weather. Doing so may cause
the battery to generate heat, explode, or ignite. Using the battery in
this manner may also result in a loss of performance and a shortened
life expectancy.
(4) Do not insert the battery into equipment designed to be hermetically
sealed. In some cases hydrogen or oxygen may be discharged from
the cell which may result in rupture, fire or explosion.
To maintain the optimum capacity of the pack, the unit has to be
fully discharged every 6 months. This can be accomplished by
leaving the unit on. Then recharge the battery to full capacity
again.
