Toyota Prius 2010 Betriebsanleitung

ILLUSTRATION

ON-VEHICLE INSPECTION

1. INSPECT THROTTLE BODY ASSEMBLY

(a) Check for throttle control motor operating sound.

(1) Turn the power switch on (IG).

(2) When depressing the accelerator pedal, check the operating sound of the motor. Make sure that no friction

noises are emitted from the motor. If any friction noise exists, replace the throttle body assembly.

(b) Set the vehicle to the inspection mode .

speed is within the specified range when the A/C is switched off.

Standard:

Condition

Engine Idle Speed

A/C switched off

950 to 1050 rpm

NOTICE:

x Be sure to perform this step with all accessories off.

x Make sure that park (P) is selected.

REMOVAL

1. REMOVE NO. 1 ENGINE UNDER COVER

2. DRAIN ENGINE COOLANT (for Engine)

3. REMOVE NO. 2 CYLINDER HEAD COVER

4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

(a) Disconnect the mass air flow meter connector.

(b) Release the 2 clamps.

5. REMOVE INLET AIR CLEANER ASSEMBLY

(a) Separate the hose from the hose clamp.

(b) Separate the wire harness clamp from the inlet air cleaner assembly.

6. REMOVE AIR CLEANER CASE

(a) Remove the air cleaner filter element.

(b) Separate the hose from the 3 hose clamps.

7. REMOVE AIR CLEANER HOSE ASSEMBLY

(a) Loosen the hose clamp and separate the ventilation hose.

(b) Unlock the hose clamp and remove the air cleaner hose assembly.

8. REMOVE THROTTLE BODY ASSEMBLY

(a) Disconnect the throttle body connector and the 2 water by

pass hoses.

(b) Remove the 2 bolts, 2 nuts and throttle body assembly.

INSPECTION

1. INSPECT THROTTLE BODY ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Text in Illustration

Component without harness connected

(Throttle Body)

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (M-) - 2 (M+)

20°C (68°F)

0.3 to 100 Ω

If the result is not as specified, replace the throttle body assembly.

INSTALLATION

1. INSTALL THROTTLE BODY ASSEMBLY

(a) Install a new gasket onto the intake manifold.

(b) Install the throttle body assembly with the 2 bolts and 2 nuts.

Torque:

10 N·m (102 kgf·cm, 7ft·lbf)

2. INSTALL AIR CLEANER HOSE ASSEMBLY

(a) Install the air cleaner hose assembly and lock the hose clamp.

(b) Connect the ventilation hose.

3. INSTALL AIR CLEANER CASE

(a) Install the air cleaner case with the 3 bolts.

Torque: 7.0 N·m (71 kgf·cm, 62in·lbf)

(b) Install the hose to the 3 hose clamps.

4. INSTALL INLET AIR CLEANER ASSEMBLY

(a) Install the inlet air cleaner assembly with the 3 bolts.

Torque:

7.0 N·m (71 kgf·cm, 62in·lbf)

(b) Connect the wire harness clamp to the inlet air cleaner assembly.

5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

(a) Install the air cleaner cap sub

assembly with the 2 clamps.

(b) Tighten the hose clamp.

6. ADD ENGINE COOLANT (for Engine)

7. INSPECT FOR COOLANT LEAK (for Engine)

8. INSTALL NO. 2 CYLINDER HEAD COVER

9. INSTALL NO. 1 ENGINE UNDER COVER

10. PERFORM INITIALIZATION

NOTICE:

Be sure to perform this procedure after reassembling the throttle body assembly, removing and reinstalling any

throttle body component or replacing the ECM.

(a) Disconnect the cable from the negative (-) battery terminal. Wait at least 60 seconds and reconnect the cable.

(b) Connect the Techstream to the DLC3 and clear the DTCs .

(d) Start the engine without operating the accelerator pedal and check that the MIL is not illuminated and that

the idle speed is within the specified range when the air conditioning is switched off after the engine is warmed

up.

Standard:

Condition

Engine Idle Speed

A/C switched off

950 to 1050 rpm

NOTICE:

x If the accelerator pedal is operated, perform the above steps again.

x Be sure to perform this step with all accessories off.

x Make sure that park (P) is selected.

(e) Perform a road test and confirm that there are no abnormalities.

Andere Handbücher für Prius 2010

Inhaltsverzeichnis

Andere Toyota Automobil Handbücher

Toyota

Toyota Avalon 2001 Bedienungsanleitung

Toyota

Toyota Corolla 2006 Bedienungsanleitung

Toyota

Toyota FORTUNER 2021 Bedienungsanleitung

Toyota

Toyota 2009 Avalon Bedienungsanleitung

Toyota

Toyota 2009 4Runner Bedienungsanleitung

Toyota

Toyota Corolla 2004 Bedienungsanleitung

Toyota

Toyota RAV4 2002 Bedienungsanleitung

Toyota

Toyota Corolla 2020 Bedienungsanleitung

Toyota

Toyota YARIS LIFTBACK 2009 Bedienungsanleitung

Toyota

Toyota Previa Bedienungsanleitung

Toyota

Toyota RAV4 2000 Bedienungsanleitung

Toyota

Toyota 2006 Hilux Mk6 Bedienungsanleitung

Toyota

Toyota RAV4 1999 Bedienungsanleitung

Toyota

Toyota 2006 Land Cruiser Bedienungsanleitung

Toyota

Toyota CAMRY 2007 Bedienungsanleitung

Toyota

Toyota Tundra guide Bedienungsanleitung

Toyota

Toyota LandCruiser 70 Series Bedienungsanleitung

Toyota

Toyota Prius c 2012 Bedienungsanleitung

Toyota

Toyota 2014 COROLLA Bedienungsanleitung

Toyota

Toyota Corolla guide Bedienungsanleitung

Toyota

Toyota Tundra guide Bedienungsanleitung

Toyota

Toyota Corolla 2001 Bedienungsanleitung

Toyota

Toyota COROLLA 2010 - Bedienungsanleitung

Toyota

Toyota RAV4 1997 Bedienungsanleitung

Beliebte Automobil Handbücher anderer Marken

CITROËN

CITROËN DS4 DSign Bedienungsanleitung

Lexus

Lexus 2015 CT 200h Bedienungsanleitung

Cadillac

Cadillac CTS 2008 Bedienungsanleitung

Mercedes-Benz

Mercedes-Benz M-class ML 55 AMG Bedienungsanleitung

Porsche

Porsche Boxster S Bedienungsanleitung

GMC

GMC 2010 Savana 1500 Cargo Bedienungsanleitung

KIAM

KIAM SPORTAGE 2014 Stücklistenhandbuch

GMC

GMC 2013 Terrain Montageanleitung

GMC

GMC T-Series 1999 Bedienungsanleitung

Mercury

Mercury 1998 Mystique Bedienungsanleitung

Mercury

Mercury 2007 Mariner Bedienungsanleitung

Mazda

Mazda 2007 Mazdaspeed 3 Leitfaden

Mazda

Mazda 2014 CX-5 Bedienungsanleitung

GMC

GMC Chevrolet Express 2022 Bedienungsanleitung

GMC

GMC 1997 Jimmy Bedienungsanleitung

Chevrolet

Chevrolet 2012 Malibu Bedienungsanleitung

Cadillac

Cadillac 2010 Escalade Bedienungsanleitung

Skoda

Skoda FABIA RS - ANNEXE 118 Bedienungsanleitung