•The machine must be in position and placed on its rest pads
•To offload the machine, a 6000 lb. forklift with 6’ extension is required.
•The machine must be leveled (refer to installation and service manual).
•The machine must be wired (refer to the installation and service manual).
•The machine must have air hooked up if power drawbar is installed (see the
installation and service manual).
•The machine must be cleaned. Remove all grease from the way surfaces.
Space & Weight
•Floor area = 102.3”x 96.6”
•Height = 96.75”
•Footprint = 24” x 43.3125”
•Net (approx.) Weight = 4100 lbs.
•Shipping (approx.) Weight = 4400 lbs.
•Pallet Size = 76” x 76”, 8” thick
•Allow clearance at the rear of the mill to open and
work on the electrical box.
•A solid and level foundation to maintain
approximately 4100 lbs plus the weight of the
workpiece (maximum total 5500 lbs) is required.
Six leveling screws are provided.
Electrical
•Machine is only available in the 208 VAC
configuration (200 to 240V is acceptable). A
separate 208V, 35 amps, 60 Hz, 3 phase circuit is
required. For shops with 440 VAC, a step-down
transformer to 208 VAC must be used. The
transformer must be sized to carry a load of 35
amps minimum.
•Machine tool must be earth grounded.
Air (for optional Power Drawbar)
•¼” NPT connection
•Air pressure not to exceed 100 psi
•17.5 SCFM or 2.5 CFM at 90 psi
