6SSC-SVN001F-EN
UnitInspection
Aftertheunitisdeliveredatthejobsite:
-Verifythat thenameplatedatamatches
the data on the sales order and bill of
lading(includingelectricaldata).
- Verify that the power supply matches
theunitnameplatespecifications.
- Inspect the unit carefully for any
shipping damage.
If any damage or material shortage is
found it must be reported immediately
to the carrier. Specify the type and
extent of the damage on the carrier's
deliveryreceiptbeforesigning.
- Notify Trane do Brasil and/or the
contractor about the damages and
actions to repair the unit. Do not
attempt to repair the unit until the
damages are inspected.
Storage
If it isnotpossible toinstall the unit after
delivery, it should be stored in a safe
location, protected from the weather
and other damages. Improper
equipment storage or handling will void
theequipmentwarranty.
Unit Inspection
Instructionsforproperinstallation
Please consider the following items
required for proper installation before
placing the unit at the mounting
location:
- The mechanical room should be
provided with proper lighting for
servicingandmaintenance.
- Make certain the floor or foundation
is level, solid, and sufficient to support
the unit and accessory weights. Level
or repair thefloor before positioning the
unit.
- Provide the units with rubber pads or
vibration isolators.
- Install the hydraulic components
required to drain the water from the
condensate tray.
- Allow minimum recommended
clearances for routine maintenance
andservice(seepage 20).
- The same clearances should be
observed in case of several units
together or condensing units.
- Provide electrical installation. The
unit haselectrical inputs on bothsides.
- Provide enough clearance to access
pipingandremovecovers.
The power supply must comply with
Standard NBR 5410, as well as local
codes and/or NEC.
- The contractor should provide and
install the refrigeration piping - both for
the liquid line and the suction line - in
order to interconnect evaporator and
condensing units.
General Safety
The Trane equipment is designed for
safe and reliable operation, as long
as units are operated according to the
applicable safety rules. The system
uses electrical and mechanical parts,
as well as gas pressures, that may
injurypeople or damage theequipment
if safety rules are not followed.
Therefore, the installation, start-up and
maintenance of thisequipment must be
performed only by qualified personnel
or personnel approved by Trane do
Brasil. Follow all safety standards
related tothe task and warningson unit
labels, and always use proper toolsand
equipment.
Hazard Identification
WARNING!!
Warnings appear at appropriate
intervals and sections throughout
this manual to warn operators
and service personnel about a
potentially hazardous situation
which MAY result in serious
injury or equipment damage if
safety rules are not met.
CAUTION:!
Cautions appear at appropriate
intervals and sections throughout
this manual to warn operators
and service personnel about a
potentially hazardous situation
which may result in damage to
the equipment and/or
environment.
