Transition Networks E-TBT-FRL-1007 Bedienungsanleitung

MEDIA CONVERTER TECHNICAL SPECIFICATIONS

Standards IEEE 802.3

Case dimensions 17.0" x 7.5" x 1.7" (432mm x 191mm x 43mm)

Environment Temperature: 0-50°C (32° to 122° F )

Humidity 10-90%, non condensing

Altitude 0-10,000 feet

Warranty 2 years

The 8-Port 10BASE-T to Fiber Media Converter provides eight (8) separate

and independent 10BASE-T to fiber media converters in a convenient

19-inch rack mountable chassis. NOTE: The media converter supports

10Mb/s speeds only.

8-Port 10BASE-T to Fiber

Media Converter

E-TBT-FRL-1007

USER’S GUIDE

Minneapolis, MN 55344 USA

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC

TELEPHONE NETWORK. Failure to observe this caution could result in damage to the

public telephone network.

Compliance Information

UL Listed

C-UL Listed (Canada)

CISPR/EN55022 Class A

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of

the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful

interference, in which case the user will be required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio

interference regulations of the Canadian Department of Communications.

European Regulations

Warning

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user

may be required to take adequate measures.

or by any means – graphic, electronic, or mechanical – without written permission from TRANSITION Networks Inc.

Trademark Notice

All i t d t d k d t d k th t f th i ti 7381 C

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten verstösst

gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur Angleichung der

Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen einschliesslich der

gegenseitigen Anerkennung ihrer Konformität.

10BaseT

RJ RX

Power

RJ Link FL Link

FL RX

Converter 1

10BaseT

RJ RX

RJ Link FL Link

FL RX

10BaseT

RJ RX

RJ Link FL Link

FL RX

10BaseT

RJ RX

RJ Link FL Link

FL RX

10BaseT

RJ RX

RJ Link FL Link

FL RX

10BaseT

RJ RX

RJ Link FL Link

FL RX

10BaseT

RJ RX

RJ Link FL Link

FL RX

10BaseT

RJ RX

RJ Link FL Link

FL RX

Converter 2 Converter 3 Converter 4 Converter 5 Converter 6 Converter 7 Converter 8

Transition Networks 8 Port 10BaseT to Fiber Media Converter

(1-8)

INDICATORS

(RJ, FL) Link Steady green LED

indicates port is

receiving link

signal.

(RJ, FL) RX Flashing green

LED indicates

port is receiving

data.

Power Steady green LED indicates 8-Port 10BASE-T to

Fiber Media Converter is powered by AC current.

CONNECTORS

10BASE-T RJ-45 connector

10BASE-FL TX, RX ST type connectors (SMA type available

upon request)

Power Female 3-prong AC connector

10BASE-FL CABLE SPECIFICATIONS

Fiber Optic Cable Recommended: 62.5 / 125 µm multimode fiber

Optional: 100 / 140 µm multimode fiber

85 / 125 µm multimode fiber

50 / 125 µm multimode fiber

Fiber Optic Transmitter Power: Average power: -15.0 dBm

Peak power: -12.0 dBm ±1dBm

Fiber Optic Receiver Sensitivity: Average sensitivity: -27.4 dBm

Bit error rate: ≤10-10

Maximum Cable Distance: 2000 meters (6500 feet)

10BASE-T CABLE SPECIFICATIONS

Required: Category 3; Recommended: Category 5 wire. Use either shielded twisted

pair (STP) or unshielded twisted pair (UTP). DO NOT USE FLAT/SILVER SATIN WIRE.

Category 3:

Gauge 24 to 22 AWG

Attenuation 28 dB/1000’ @ 10 MHz

Differential Characteristic Impedance 100 Ω±10% @ 10 MHz

Category 5:

Gauge 24 to 22 AWG

Attenuation 20 dB/1000’ @ 10 MHz

Differential Characteristic Impedance 100 Ω±10% @ 10 MHz

Maximum Cable Distance: 100 meters (330 feet)

10BaseT

RJ RX

Power

RJ Link FL Link

FL RX

Converter 1

In the example network installation below, the 8-Port Media Converter

provides cable connection and media conversion between a 10BASE-T

switch and remote fiber installations. Other 10BASE-T/10BASE-FL

installations are supported.

To install the 8-Port Media Converter:

1. Mount the 8-Port Media Converter in a 19-inch rack.

• Locate four (4) screws and clip-nuts if necessary (NOT included with

shipment).

• Carefully align 8-Port Media Converter with 19-inch rack rails.

• Install two (2) screws through each bracket into mounting rails.

2. Connect 10BASE-T cables.

• Locate 10BASE-T cables that comply with Ethernet™ 802.3 specifications

and that have male RJ-45 connectors installed at both ends.

• Referring to drawing above and to Configuring 10BASE-T Straight

Through/Crossover Cable Assembly on next page, be certain that the

10BASE-T cable is configured as straight through or crossover as required

for site installation. NOTE: An RJ-45 telephone cable is reverse-wired,

which is NOT the same as a crossover pinout.

3. Connect 10BASE-FL cables.

• Locate 10BASE-FL cables that comply with Ethernet™ 802.3 specifications

and that have two (2) male TX and RX connectors installed at both ends.

• Verify that the fiber products to be connected are 10BASE-FL or FOIRL

compliant. NOTE: Fiber ports on TRANSITION Networks fiber media

converters conform to 10BASE-FL or FOIRL but NOT to 10BaseFB or FDDI.

• Connect media converter TX connector to remote installation RX connector

and media converter RX connector to remote installation TX connector.

4. Connect to external AC power.

• Locate power cord included with shipment.

• Connect the power supply cable to the media converter BEFORE

connecting the power supply cable to the AC outlet.

1. Is the power LED on the media converter illuminated?

NO• Is the power cord installed properly in the media converter

and in the outlet?

• Contact Technical Support: (800) 260-1312/(800) LAN-WANS.

YES• Proceed to step 2.

2. Are the RJ Link and FL Link LEDs illuminated?

NORJ Link

• Check RJ connectors and UTP cables for proper connection

and pin assignment. (See below.) NOTE: In the installation

drawing, connections between the switch and the Media Converters

are configured as straight through; the connection between the Media

Converter and the terminal is configured as crossover.

• Refer to Tech Tips available at:

http://www.transition.com

• Contact Technical Support: (800) 260-1312/(800) LAN-WANS.

FL Link

• Verify that fiber cable is multimode (NOT single-mode).

• Check fiber cables for proper connection.

• Verify that TX and RX media converter cables are connected to

RX and TX ports, respectively, on remote 10BASE-FL device.

• Refer to Tech Tips available at:

http://www.transition.com

• Contact Technical Support: (800) 260-1312/(800) LAN-WANS.

YES• Contact Technical Support: (800) 260-1312/(800) LAN-WANS.

TROUBLESHOOTING SUGGESTIONS

If a Media Converter fails, ask the following questions:

INSTALLATION NOTES

Cable connections between a hub and the media converter must be configured as

straight through. Cable connections between the media converter and a terminal,

transceiver or NIC must be configured as crossover.

The two active pairs in a 10BASE-T network are pins 1 & 2 and pins 3 & 6. Use only

dedicated wire pairs (such as blue/white & white/blue, orange/white & white/orange)

for the active pins.

Configuring 10BASE-T Straight Through/Crossover Cable Assembly

Twisted

Pair #1

Twisted

Pair #2

Crossover Cable

Connectors for like devices

Twisted

Pair #1

Twisted

Pair #2

Straight Through Cable

Connectors for unlike devices

Switch

RX TX

Converter 1

RX TX RX TX RX TX RX TX RX TX RX TX RX TX

Converter 2 Converter 3 Converter 4 Converter 5 Converter 6 Converter 7 Converter 8

Crossview of the

UTP Cable Connector

Top

view of the RJ-45 Port

Inhaltsverzeichnis

Andere Transition Networks Medienkonverter Handbücher

Transition Networks

Transition Networks CRS2F31-100 Series Bedienungsanleitung

Transition Networks

Transition Networks CFMFF4040-100 Bedienungsanleitung

Transition Networks

Transition Networks C/PS-CF-01(SC) Bedienungsanleitung

Transition Networks

Transition Networks CFETF1011-205 Bedienungsanleitung

Transition Networks

Transition Networks SISTF10xx-111-LR(T) Bedienungsanleitung

Transition Networks

Transition Networks M/GE-ISW-SFP-01-PD Bedienungsanleitung

Transition Networks

Transition Networks C/E-R-TX-FX-01 Bedienungsanleitung

Transition Networks

Transition Networks SFMFF4040-100 Bedienungsanleitung

Transition Networks

Transition Networks CFMFF1314-280 Bedienungsanleitung

Transition Networks

Transition Networks CRMFE1011-200 Bedienungsanleitung

Transition Networks

Transition Networks J/POE-CF-01(SC) Bedienungsanleitung

Transition Networks

Transition Networks ION001-A Bedienungsanleitung

Transition Networks

Transition Networks SI-IES-111D-LRT Bedienungsanleitung

Transition Networks

Transition Networks SGPOE1013-100 Bedienungsanleitung

Transition Networks

Transition Networks METTF1011-120 Bedienungsanleitung

Transition Networks

Transition Networks CRS2F3111-100 Bedienungsanleitung

Transition Networks

Transition Networks CBFTF10XX-15X Bedienungsanleitung

Transition Networks

Transition Networks SGPAT1013-105 Bedienungsanleitung

Transition Networks

Transition Networks M/GE-xSW-SFP-01-xx-U Series Bedienungsanleitung

Transition Networks

Transition Networks 10BASE-2 Bedienungsanleitung

Transition Networks

Transition Networks CFETF1029-205 Bedienungsanleitung

Transition Networks

Transition Networks SGFEB10xx-12x Bedienungsanleitung

Transition Networks

Transition Networks C/F-SM-MM-04(LH) Bedienungsanleitung

Transition Networks

Transition Networks C/E-100BTX-FX-04(LH) Bedienungsanleitung

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung