Transtector ALPU Lite Bedienungsanleitung

Warning Thank you for your recent purchase of our surge protection solution.

Your satisfaction with our product and service is important to us.

If you have any questions, comments, or concerns, please contact us

at 800.882.9110 or visit our website at www.smithspower.com.

We look forward to continuing to serve your protection needs.

Installation Instructions

800.882.9110 | 208.772.8515 | www.smithspower.com

Unit must be properly grounded prior to use. Failure to do so will result

in voided warranty and possible equipment damage.

ALPU Lite

ALPU-L130

Installation Instructions

800.882.9110 | 208.772.8515 | www.SmithsPower.com

ALPU Lite

ALPU-L130

WALL MOUNT INSTALLATION INSTRUCTIONS

1. Cable openings must be oriented towards the ground.

2. Open lid of unit to access wall mount holes (see Figure 1).

3. Use quantity 2 to 4 M3.5 (or #6) fasteners to secure to the desired surface. If using

only 2 fasteners, install per the following pairs (1,1), (2,2), or (3,3). (See Figure 2

for fastener congurations).

4. Do not torque fasteners greater than 1 Nm (8.8 in-lbf) ±10%.

POLE MOUNT INSTALLATION

INSTRUCTIONS

1. Cable openings must be oriented

towards the ground.

2. Slide hose clamp or tie wrap through

two slots on back of unit (see Figure 3).

3. Align channel in unit with pole and

secure with hose clamp. Do not over-

tighten hose clamp as this may cause

damage to plastic bars in hose clamp

region of the unit.

Figure 1 - Wall mount installation Figure 2 - Fastener conguration

Figure 3 - Pole mount installation

Figure 4 - Cable installation

ICON INFORMATION

1. There are three icons visible when the unit is open (see Figure 5). The icon

located in center denotes orientation of the unit.

2. The icon with the up arrow indicates unprotected signal entry, while the icon with

down arrow indicates protected signal transmitted out.

Figure 5 - Icon information

CABLE INSTALLATION

INSTRUCTIONS

WARNING! - Ground lug must

be secured as indicated below to

ensure proper product performance.

1. Secure ground lug with M5 (#10)

screw (provided as installed with

unit). Torque to 1 Nm (8.8 in-lbf)

±10% (see Figure 4).

2. Verify that each cable is aligned

with the opening directly below its

respective connection point when

closing the lid.

3. Lid should snap closed.

1402-042 Rev B

Dieses Handbuch passt für folgende Modelle

Andere Transtector Überspannungsschutz Handbücher

Transtector

Transtector TSJ X6 Series Bedienungsanleitung

Transtector

Transtector CB Series Bedienungsanleitung

Transtector

Transtector ALPU Fit Bedienungsanleitung

Transtector

Transtector CPX Bedienungsanleitung

Transtector

Transtector ALPU-EXLT Bedienungsanleitung

Transtector

Transtector I2R 75K Series Bedienungsanleitung

Transtector

Transtector I2R SPV1000 3-40 Bedienungsanleitung

Transtector

Transtector CPX Series Bedienungsanleitung

Transtector

Transtector APEX Series Bedienungsanleitung

Transtector

Transtector ALPU Series Bedienungsanleitung

Transtector

Transtector ALPU HT Bedienungsanleitung

Transtector

Transtector ALPU-ALVR Bedienungsanleitung

Beliebte Überspannungsschutz Handbücher anderer Marken

ELAC

ELAC ProteK PR91-W Bedienungsanleitung

Tsubaki

Tsubaki TSM4000M1 Bedienungsanleitung

QVS

QVS PP134C Bedienungsanleitung

CyberPower

CyberPower CSP604T Bedienungsanleitung

Davis Instruments

Davis Instruments Radio Surge Protector Bedienungsanleitung

M-system

M-system MGA-100 Bedienungsanleitung

CyberPower

CyberPower CSP706T Bedienungsanleitung

CyberPower

CyberPower B300WRC1 Bedienungsanleitung

M-system

M-system MGD-24 Bedienungsanleitung

Leviton

Leviton 51120-3R Bedienungsanleitung

Panamax

Panamax MAX 5400-EX Bedienungsanleitung

CyberPower

CyberPower B1006T Bedienungsanleitung

OBO Bettermann

OBO Bettermann ÜSM-20-230I1PE65 Bedienungsanleitung

Minuteman

Minuteman MMS7120RCT Bedienungsanleitung

Leviton

Leviton 52412-DS3 Bedienungsanleitung

Savio

Savio LZ-07 Bedienungsanleitung

Siemens

Siemens HNM3M120 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric LITOL LTM-125RF Bedienungsanleitung