Travis Industries 864 HO NB Bedienungsanleitung

864 HO NB Dancing-Fyre Burner

Installation Instructions (sku: 96900141)

Page 1 of 11 17601701 — 2/27/14 © Travis Industries, Inc.

Table of Contents

Compatibility.............................................................................................................................................................. 1

Packing List ............................................................................................................................................................... 1

Installation Tips.......................................................................................................................................................... 1

Installation Warnings ................................................................................................................................................. 2

Burner Installation...................................................................................................................................................... 2

Log Installation........................................................................................................................................................... 7

Ember Placement................................................................................................................................................. 11

Rock Wool Placement.......................................................................................................................................... 11

Compatibility

864 HO NB

Packing List



(2) 8-32 x 3/8" Screws

Front & Rear Andiron Brackets (Optional)

Log Set with Embers and Rock Wool

12-ounce Bag of Embers

Installation Tips

If using propane (LP), convert the appliance before installing the burner.

Dancing-Fyre Burne

Floor Fireback

Left, Rear, and Right Firebacks

Rear Log Stand (solid)

Air Deflector

(perforated)

Grate

Pilot

Shield

Left Log

Stand

Burne

Skirt

864 HO NB Dancing-Fyre Burner

Installation Instructions (sku: 96900141)

Page 2 of 11 17601701 — 2/27/14 © Travis Industries, Inc.

Installation Warnings

The logs are fragile, especially after being exposed to heat.

Make sure the gas control valve is OFF and the heater is cool before servicing.

Failure to position the parts in accordance with these diagrams or failure to use only parts

specifically approved with this appliance may result in property damage or personal injury.

The burner must be correctly positioned before installing the logs. Make sure the burner is

fully seated and the pilot is properly aligned.

Burner Installation

NOTE FOR OLDER 864 HO NB UNITS

Older units were shipped with front and side burner skirts pre-installed. Remove these skirts before

proceeding.

Remove the 7 screws holding the front and side burner skirts in place. The skirts may be discarded (keep

the screws).

Make sure to replace the 4 screws (2 each side) that held the side burner skirts in place (plugging the holes

in the valve tray).

NOTE FOR OLDER UNITS WITH SIT PILOT ASSEMBLY

If you have an older unit with a SIT pilot assembly (see picture to

the right), you will need to replace the 2-way pilot hood with a SIT

3-way pilot hood (order part # 250-02205).

Side Burner Skirt

Front Burner Skirt Side Burner Skirt

864 HO NB Dancing-Fyre Burner

Installation Instructions (sku: 96900141)

Page 3 of 11 17601701 — 2/27/14 © Travis Industries, Inc.

1. Remove the 3 existing screws from the firebox floor.

2. Install the burner skirt with the 3 screws removed earlier.

Figure 1: Burner skirt installed, showing location of screws

3. Install the firebacks as shown below.

a) Remove the clips from the firebox ceiling near the front (both sides). The side fireback clips have a

keyhole slot and can be removed by loosening the screw and sliding the clip out.

b) Place the rear fireback.

864 HO NB Dancing-Fyre Burner

Installation Instructions (sku: 96900141)

Page 4 of 11 17601701 — 2/27/14 © Travis Industries, Inc.

c) While holding the rear fireback, place the side firebacks.

d) Replace the clips removed in step (a) to secure the firebacks.

a) Assemble the floor fireback by installing (2) 8-32 x 3/8" screws in the main part of the fireback.

4. Install the floor fireback.

864 HO NB Dancing-Fyre Burner

Installation Instructions (sku: 96900141)

Page 5 of 11 17601701 — 2/27/14 © Travis Industries, Inc.

5. Install the burner. Make sure it is fully seated (pushed to the right) and level with the fireback floor.

6. Install the grate.

7. Install the pilot shield into the burner.

NG Only

Install the air deflector as shown.

864 HO NB Dancing-Fyre Burner

Installation Instructions (sku: 96900141)

Page 6 of 11 17601701 — 2/27/14 © Travis Industries, Inc.

8. Place the rear log stand onto the burner, as shown below.

a) Bend the 3 tabs on the rear log stand.

b) Place the rear log stand at the back of the burner.

9. Bend up the two tabs labeled “1” on the log plate.

10. Place the left log plate on the burner as shown.

864 HO NB Dancing-Fyre Burner

Installation Instructions (sku: 96900141)

Page 7 of 11 17601701 — 2/27/14 © Travis Industries, Inc.

Andiron Installation

The optional andirons should be installed before installing the logs. See the directions below for

installation.

1 Remove the grate from the

firebox. Remove and discard

the two andiron prongs (see

step “a” to the right).

NOTE: The nuts do not need to

be removed, they can be

loosened to remove the prongs.

2 Attach the andiron brackets

(shipped with the burner) to the

grate (see step “b”).

3 Attach the andirons the andiron

brackets using the screws

included with the andirons (see

step “c”).

5/32 Hex

Wrench

11/32" Nutdriver

864 HO NB Dancing-Fyre Burner

Installation Instructions (sku: 96900141)

Page 8 of 11 17601701 — 2/27/14 © Travis Industries, Inc.

Log Installation

1. Place the rear log on the rear log stand. Make sure the pins insert into the holes in the bottom of the log.

2. Place the left log as shown below.

NG units:

Slide the log forward.

LP units:

Slide the log backward.

864 HO NB Dancing-Fyre Burner

Installation Instructions (sku: 96900141)

Page 9 of 11 17601701 — 2/27/14 © Travis Industries, Inc.

3. Place the right log so the two holes in the bottom of the right log fit over the two pins on the pilot shield.

The indentation in the log (shown below) allows the pilot flame to exit freely.

4. Place the log chunks as shown below.

Log rests on pilot

shield

Log abuts grate

864 HO NB Dancing-Fyre Burner

Installation Instructions (sku: 96900141)

Page 10 of 11 17601701 — 2/27/14 © Travis Industries, Inc.

5. Place the left twig as shown below. The left twig has a hole on the bottom that fits over the pin on the

rear log.

6. Place the right twig as shown below. The right twig has a hole on the bottom that fits over the pin on the

rear log.

Andere Handbücher für 864 HO NB

Inhaltsverzeichnis

Andere Travis Industries Brenner Handbücher

Travis Industries

Travis Industries B29 Bedienungsanleitung

Travis Industries

Travis Industries DVL Ember-Fyre Bedienungsanleitung

Travis Industries

Travis Industries 564 HO DancingFyre Bedienungsanleitung

Travis Industries

Travis Industries 864 HO NB Bedienungsanleitung

Travis Industries

Travis Industries 864 HO NB Bedienungsanleitung

Travis Industries

Travis Industries DVS GSR Bedienungsanleitung

Travis Industries

Travis Industries Fire Garden 94900460 Bedienungsanleitung

Travis Industries

Travis Industries 564 HO DiamondFyre Bedienungsanleitung

Travis Industries

Travis Industries Fire Garden 94900430 Bedienungsanleitung

Travis Industries

Travis Industries DVL GSR Insert Bedienungsanleitung

Travis Industries

Travis Industries 616 GSR Driftwood Log Set 2 Bedienungsanleitung

Travis Industries

Travis Industries DVS GSR Insert Bedienungsanleitung

Beliebte Brenner Handbücher anderer Marken

Riello

Riello RS 28/M Kurzanleitung

True Induction

True Induction TI4B Bedienungsanleitung

Weishaupt

Weishaupt WG20 Series Bedienungsanleitung

Carolina Cooker

Carolina Cooker M116672 Bedienungsanleitung

Riello

Riello RX 500 S/PV Bedienungsanleitung

Unigas

Unigas HTP2000 Bedienungsanleitung

baltur

baltur BT 250 DSG 4T Bedienungsanleitung

muenkel design

muenkel design round burner Bedienungsanleitung

baltur

baltur BT 14 DSGW Bedienungsanleitung

artisan

artisan Art-SB1 Leitfaden

AESYS

AESYS TurboFire II Bedienungsanleitung

Riello

Riello RG1RKD Kurzanleitung

IKEA

IKEA GRILLSKÄR Bedienungsanleitung

RUSTA

RUSTA SAREK Bedienungsanleitung

PROPOINT

PROPOINT 8933657 Bedienungsanleitung

baltur

baltur TBL 1000 ME Referenzhandbuch

Riello Burners

Riello Burners P 200 P/G Kurzanleitung

WLD-TEC

WLD-TEC powerjet Bedienungsanleitung