Travis Industries 228-30035 Bedienungsanleitung

Fireplace Thermostat Fix Kit – 228-30035

Printed 12/23/02 Page 1 of 6

Overview

This kit contains a remote that has been specially created to replace faulty modulating remotes

(SKU 99300652) It is intended as a fix for those remotes that are not working correctly.

This Remote is Non-Modulating

This remote does not have a modulating circuit. Therefore, you have two options for using this

remote:

• Option A Manually over-ride the regulator on the gas control valve. This will make the

heater operate with a high flame. If you do not insert the pin, the heater will operate at the

low flame height. Use the pin included with the modulating remote.

Twist and remove

the clear plastic

regulator cover

(be careful - it is

fragile). Remove the pin held

in this hole.

Place the pin

into this hole.

Replace the plastic cover to

secure the pin in place.

• Option B Remove the modulating regulator and replace with a stock regulator (LP or NG).

Contact Travis Industries for this part if necessary.

Fireplace Thermostat Fix Kit –228-30035

Printed 12/23/02 Page 2 of 6

Installation Instructions

FCC REQUIREMENTS

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions,, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiver.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio TV technician for help.

CANADIAN EQUIPMENT REQUIREMENTS

This digital apparatus does not exceed the (Class A/Class B) limits for radio noise emissions from digital apparatus set out

in the Radio Interference Regulations of the Canadian Department of Communications. Le present appareil numerique

n'emet pas de bruits radioelectricques depassant les limites applicables aux appareils numeriques (de la class A/de la class

B) prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des Communications du Canada.

This device complies with RSS-210 of Industry and Science Canada. Operation is subject to the following two conditions:

(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may

cause undesired operation of the device.

INSTALLATION

! Shut off power to the appliance and allow it to cool prior to installation.

! This kit must be installed by a qualified technician.

! All 110 VAC wiring must be done by a qualified electrician and shall be in compliance with local codes and the National

Electric Code ANSI/NFPA No. 70 (in the United States), or with the current CSA C22.1 Canadian Electric Code (in

Canada).

! Do not connect 110 VAC to the gas control valve or on/off switch on gas heaters or the thermostat posts on pellet heaters.

Remove the existing remote receiver and transmitter. Install the new receiver, making sure to

place it inside the heat shield (if applicable).

Place the receiver in the heat

shield (if applicable).

Receiver

Fireplace Thermostat Fix Kit –228-30035

Printed 12/23/02 Page 3 of 6

Remote Receiver Calibration

1 Remove the cover from the back of

the transmitter. Insert three "AAA"

batteries into the transmitter as

shown. Slide the code switches to

a random position on the receiver.

ON DIP

1 2 3 4

Transmitter

Dip Switches

Transmitter

AAA Battery

ON DIP

1 2 3 4

C-P

Slide the

access

cover off.

Set these dip switches to a

random position.

2 Plug in the receiver. Position the

transmitter within 1 foot of the receiver.

The LED indicator panel on the

transmitter should be flashing (if not,

remove and replace the batteries).

Press down any button on the

transmitter until the receiver "beeps".

This indicates the transmitter and

receiver are calibrated on the same

radio frequency (if it does not, remove

batteries, replace, and repeat this

process). Test operation of the remote

control.

Receiver

ROOM TEMP

°F

SETTEMP

Set

Time

Cancel

Flame

Height Fan

Speed

"Beep"

Setting the Time

ROOM TEMP

°F

SET TEMP

TIMER

MIN

TIMER

CLOCK

“UP”and “Down”Arrows

1. Press and hold the “CLOCK”button for 2

seconds.

2. The hour display will flash. Use the “Up”

and “Down”arrow buttons to set the hour.

3. Press the “CLOCK”button again.

4. The minute display will flash. Use the “Up

and “Down”arrow buttons to set the

minute.

5. Press the “CLOCK”button again.

6. The “F”or “C”display will flash. Use the

“Up”and “Down”arrow buttons to select

Fahrenheit or Celsius.

7. Press the “CLOCK”button again.

Programming is complete.

Fahrenheit or

Celcius Display

“CLOCK”Button

Hour and Minute Display

MAN

ON/

OFF

ON/

OFF

Fireplace Thermostat Fix Kit –228-30035

Printed 12/23/02 Page 4 of 6

OPERATING INSTRUCTIONS

NOTE: This kit must be installed by a qualified technician to work correctly

NOTE: On gas stoves the pilot flame must be lit, the gas control valve turned to "ON", and the on/off switch

turned to "OFF" for the remote to work correctly.

NOTE: On pellet stoves the auger must be primed for the remote to work correctly.

NOTE: The remote must be calibrated before it will work (see the instructions on the previous page). If the

remote fails to work, try unplugging the remote receiver, plugging it back in, then re-calibrate the remote.

MODES OF OPERATION:

Manual Mode

Use manual mode to turn the heater on

and off directly.

OFF

ROOM TEMP

°F

SET TEMP

TIMER

MIN

TO TURN ON AND OFF:

Use this key to toggle the

heater on and off. The

display will indicate the

status.

NOTE:

-- If the room exceeds 90°,

the heater will shut off.

-- If left on, the heater will

shut off after 6 hours.

TIMER

CLOCK

MAN

ON/

OFF

ON/

OFF

Auto Mode

Auto mode works like a

thermostat, turning the heater on

and off to meet the desired

temperature.

Auto

ROOM TEMP

°F°F

SET TEMP

MIN

THERMOSTAT MODE:

Use this key to toggle the

thermostat mode. The

display will indicate

“AUTO”when in

thermostat mode.

TO ADJUST TARGET

TEMPERATURE:

Use the arrow keys to adjust the target

temperature to the desired level.

The heater will turn on and off to keep

the room temperature near the target

temperature.

IMPORTANT NOTES:

-- The thermostat has a delay to prevent

the heater from turning on and off

repeatedly. As a result, the target

temperature may be slightly higher (2°

or 3°) than the room temperature yet

the heater does not turn on –do not

adjust the target temperature –the

heater will turn on in a few minutes.

-- The thermostat is not intended for un-

attended use. If the thermostat calls for

heat for 6 hours continuously, it will shut

off and not turn on until reset.

HINT:

If your heater turns on

and off frequently, adjust

the flame height down

slightly for a more

consistent heat output.

TIMER

CLOCK

MAN

ON/

OFF

ON/

OFF

Fireplace Thermostat Fix Kit –228-30035

Printed 12/23/02 Page 5 of 6

Timed Mode

Timed mode allows you to turn

the heater on for a pre-set period

of time.

ROOM TEMP

°F

SET TEMP

TIMER

MIN

The heater will turn on and

stay running for the number of

minutes displayed.

TIMED OPERATION:

Use the arrow keys to adjust the

target temperature to 90°.

Press the “TIMER”button - the

“- - -”will start to flash.

Use the arrow keys to set the

number of minutes you would like

the heater to stay on.

NOTE:

If the room exceeds 90°, the

heater will shut off.

TIMER

CLOCK

MAN

ON/

OFF

ON/

OFF

CHILD PROOF FEATURE:

The child proof switch allows for the

remote to be “protected”against

undesired use.

The words “Child Proof”

appear here when this features

is turned on.

AAA Battery

ON DIP

1 2 3 4

C-P

This is the “Child Proof”Switch

Slide the

access

cover off.

Child

Proof

Off

Child

Proof

ROOM TEMP

°F°F

SET TEMP

TIMER

MIN

•Child Proof •

The child proof switch disables

the buttons on the front of the

remote. Thermostat and timed

functions remain operational.

Back of

Transmitter To over-ride the

child-proof feature,

press the up and

down buttons in the

following order:

DOWN

TIMER

CLOCK

MAN

ON/

OFF

ON/

OFF

Press these buttons

Fireplace Thermostat Fix Kit –228-30035

Printed 12/23/02 Page 6 of 6

OPERATION WITH DEAD BATTERIES

If the heater is on (any mode) and the batteries go dead, the heater will turn off after 6 hours. To operate the

heater, use the switch on the heater to turn the heater on and off.

OPERATION DURING POWER OUTAGES

If a power outage occurs, the receiver will turn the heater off. Once power is restored, the remote will turn the

heater on (if the remote calls for heat) within 30 minutes. If you wish to over-ride the remote and turn the

heater on (gas stoves only), turn the on/off switch on the gas heater to "ON".

Inhaltsverzeichnis

Andere Travis Industries Kaminzubehör Handbücher

Travis Industries

Travis Industries Wilmington Face Bedienungsanleitung

Travis Industries

Travis Industries Fyre 430 Bedienungsanleitung

Travis Industries

Travis Industries 54PB Bedienungsanleitung

Travis Industries

Travis Industries 96400717 Bedienungsanleitung

Travis Industries

Travis Industries 564 EF-I Bedienungsanleitung

Travis Industries

Travis Industries Revolution 36CF Bedienungsanleitung

Travis Industries

Travis Industries Illuminations 4915 Bedienungsanleitung

Travis Industries

Travis Industries 94700882 Bedienungsanleitung

Travis Industries

Travis Industries 95900352 Bedienungsanleitung

Travis Industries

Travis Industries 96100593 Bedienungsanleitung

Travis Industries

Travis Industries Arbor Bedienungsanleitung

Travis Industries

Travis Industries Illuminations 4915 Bedienungsanleitung

Travis Industries

Travis Industries 250-00128 Bedienungsanleitung

Travis Industries

Travis Industries Fireplace Xtrordinair GreenStart Apex 42 Bedienungsanleitung

Travis Industries

Travis Industries 864 ST GS Bedienungsanleitung

Travis Industries

Travis Industries 95400424 Bedienungsanleitung

Travis Industries

Travis Industries 98500668 Bedienungsanleitung

Travis Industries

Travis Industries 96100594 Bedienungsanleitung

Travis Industries

Travis Industries 95100055 Bedienungsanleitung

Travis Industries

Travis Industries 95900388 Bedienungsanleitung

Travis Industries

Travis Industries DVL GSR Bedienungsanleitung

Travis Industries

Travis Industries 3615 HO GSR2 Cheat Sheet Bedienungsanleitung

Travis Industries

Travis Industries Olympic Bedienungsanleitung

Travis Industries

Travis Industries Rosario DVS Face Bedienungsanleitung

Beliebte Kaminzubehör Handbücher anderer Marken

Valor

Valor L2 1700K Bedienungsanleitung

Exodraft

Exodraft Xzense Bedienungsanleitung

Whalen

Whalen Ruso MNFP62BF23-6 Bedienungsanleitung

Lopi

Lopi Hearthview 864 Bedienungsanleitung

Woodstock Soapstone

Woodstock Soapstone Fireview 201 Bedienungsanleitung

EdilKamin

EdilKamin SERBATOIO 250 Kurzanleitung

Bronpi

Bronpi KIT-1 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces 22150051 Bedienungsanleitung

Superior

Superior ASD3628-TI Bedienungsanleitung

pleasant hearth

pleasant hearth OFP28WG Bedienungsanleitung

IHP

IHP Astria Series Bedienungsanleitung

Firegear

Firegear FG-H-2110SS Bedienungsanleitung

Nibe

Nibe Contura C i31 Bedienungsanleitung

kozy heat

kozy heat KZK-052 Bedienungsanleitung

SimpliFire

SimpliFire SF-WM36 Bedienungsanleitung

Bluegrass Living

Bluegrass Living BC18NR Kurzanleitung

pleasant hearth

pleasant hearth IRIS SCROLL Bedienungsanleitung

Cooke

Cooke Glass Wind Guard Bedienungsanleitung