Tempest™ Lantern Wall Mount
(sku 94800831)
Page 10 of 11 17602174 - 2/17/21 © Travis Industries, Inc.
13. Slide the wall plate cover (Figure 12 – make sure it is positioned correctly – the circular indents are on
the sides), and control cover over the post (Figure 13). Leave the cover loose so gas connections can be
made
NOTE: The images below show the Tempest Torch version of the wall plate cover. The Tempest Lantern version has
a tapered appearance but attaches in exactly the same way.
Figure 12
Figure 13
14. Attach the flex tube and fitting to the gas inlet on the lantern (use adapter included in the hardware pack.
See figure 14). Route the flex tube and the gas control assembly so it angles back and slightly
downward. Insert the gas line and control assembly through the post,. Push the gas line all the way to
through to the mounting plate (see Figure 14,15 & 16). Grasp the end of the flex tube and pull it through
as you position the head mounting brackets over the outside end of the post and line up the holes in the
head mouting brackets with the holes in the mounting post (see Figure 17 &18). Attach the lantern to the
post using the through-bolts removed in step 8 (see Figure 19).
Figure 14
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
