Treasure Cove VIBRA-PHONE 280 Bedienungsanleitung

Thank you for choosing the New Vibra-Phone 280

made by Treasure Products, Inc. Now you’re

ready to enjoy the freedom of never having to

wear headphones again!

The New Vibra-Phone 280 takes the output from

the headphone jack of your metal detector and

converts that sound into vibration. This will allow

you to feel your detectors signaling instead of

having to hear it.

It’s designed for those that have difficulty hearing

tones and whistles or are just tired of wearing

headphones.

Note: The Vibra-Phone is not waterproof and

should not be submersed or exposed to water.

Sound to Vibration Converter

Battery Installation

Battery Type

Uses one standard 9-volt battery.

Opening battery compartment

To open the battery compartment, push down

slightly on the ridged area of the battery cover with

your thumb, and slide the cover away from the body.

Connecting battery

Connect a standard 9-volt battery to the battery clip

and insert it into the battery compartment.

Closing the battery compartment

To close the compartment, replace the battery

compartment cover and slide it back in position until

it aligns with the main body.

Operating Instructions

Connection

The cord on the Vibra-Phone plugs directly into the

regular headphone jack of your detector. The

sound that you would normally hear in your

headphones is directed into the Vibra-Phone where

it is converted into vibration.

Power on

Rotate the ‘Sensitivity’ knob

clockwise from the position shown

in image. The unit is now ON.

Power off

Rotate the ‘Sensitivity’ knob

counterclockwise until it clicks and

is in the position shown in image.

The unit is now OFF.

Adjustments

Sensitivity Knob

The sensitivity is adjusted by rotating the

‘Sensitivity’ knob. For maximum sensitivity,

rotate knob to the full clockwise position.

For detectors with a ‘Threshold Sound’, adjust the

sensitivity up until you feel the vibration from the

threshold, then back it off until the vibration stops.

Pulse Width Pot

This adjusts the length, or ‘Pulse Width’ of

vibration you feel. Adjust the ‘Pulse Width’ pot by

using a standard slot screwdriver.

If your detector has a short sharp tone when a

target is detected, you may have difficulty feeling

it when it is converted to vibration. In this case,

adjust the pot clockwise to increase the length of

the vibration you will feel. Once you’ve adjusted

the pot to your liking, you should not have to

change this adjustment again.

Made in USA

Treasure Products Inc.

www.TreasureProducts.com

Vibra is a registered trademark of Treasure Products Inc.

Use only high-quality batteries such as

alkaline or nickel metal hydride (NiMH).

280

Vibra-Phone

Continued on back

Note: Weak or nonexistent vibrations

may indicate a low battery.

Placement for Use

Strap Mount (Recommended): Use the Hook &

Loop Cinch Strap to tightly wrap the Vibra-Phone to

the pole of your detector, or any other location where

you can best feel the unit vibrate (See images below).

Alternative Placement

• Place it in your pocket for easy carrying.

• Hold it in free hand for quick sensitivity adjustments.

Note: May require adapter

(See back page of manual)

Limited Warranty

What does this warranty cover?

Treasure Products warrants that its products are free

from defects in material and workmanship under

normal use for a period of one (1) year from the date

of purchase. Warranty extends only to original

purchaser and is not transferable.

What is not covered by this warranty?

This warranty does not cover any accessories, or any

consumables, as to which there shall be no warranty

or replacement. This warranty does not cover

conditions or damages caused by accidents,

alterations or misuse. In addition, damage due to

normal wear and tear is not covered by this warranty.

What is needed to keep the warranty in service?

You must provide proof of purchase as a condition of

receiving warranty service. Your dated sales receipt,

showing the date of purchase of your product is your

proof of the purchase date.

What will be done to correct the problem?

Treasure Products will repair or replace, at Treasure

Products’ sole discretion, any defective,

nonconforming, or malfunctioning product or any

component thereof.

How do you get service?

If you require warranty service, contact Treasure

Products prior to sending your product in for service.

You can find contact information on our website at

www.treasureproducts.com > support > contact.

This limited warranty gives you specific legal rights,

and you may also have other rights which vary from

state to state.

• • •

Designed and manufactured by Treasure Products.

Vibra is a registered trademark of Treasure Products.

022020A2

Product Care

• Remember to always turn the ‘Sensitivity’ knob

to the OFF position when not in use to conserve

the battery life.

• When the Vibra-Phone is off there is no drain

on the battery. However, if stored for long

periods of time, we recommend that the battery

be removed to prevent damage to the unit due to

a potential battery leak.

• • •

Other Equipment by Treasure Products, Inc.

Vibra-Tector - Pulse Induction Metal Detector

Vibra-Probe - Pinpointer Metal Detector

E-Z Swing - Metal Detector Harness

VIBRA-PHONE 280 SPECIFICATIONS

• Manufacturer: Treasure Products, Inc.

• Model: Vibra-Phone 280 (Rev A)

• Communication: Vibration

• Pulse Width: Adjustable

• Sensitivity: Adjustable

• Overall Length: 5 inches (13 cm)

• Weight: 4 oz. (141 grams)

• Power Source: One standard 9 volt

• 9-volt Battery: Included

• Mounting Strap: Included

• Stereo to Mono Adapter: Included

• Warranty Period: 1 year

• Origin: Made in the USA

Note: This unit is not waterproof. Do not

submerge body or expose to water.

Specifications and features are subject to

change without prior notification.

Mono Adapter

Note: Some detectors may require the use of

the included Stereo to Mono Adapter for the

Vibra-Phone 280 to function properly.

If your detector is producing sound, yet

there is no vibration from the Vibra-Phone,

then you will want to use the included Stereo

to Mono Adapter.

Simply plug the adapter onto the end of the

Vibra-Phone Cable. Be sure the plug is fully

seated into the adapter.

Inhaltsverzeichnis

Andere Treasure Cove Medienkonverter Handbücher

Treasure Cove

Treasure Cove Vibra-Phone 280 Bedienungsanleitung

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung