Trek SUPERCALIBER SL Bedienungsanleitung
2024 SUPERCALIBER SL AND SLR
SERVICE MANUAL
2024 Supercaliber
1
Contents
Safety Rear axle with UDH Rear axle with SRAM
Transmission
Derailleur
Main pivot Swingarm
SLR routing with
AXS shifting
SLR routing with
mechanical shifting
SL routing with
AXS shifting
SL routing with
mechanical shifting
Frame guards
2024Supercaliber
19
Specifications
Chainline (1x only)
55mm
Chainring (1x only)
Minimum Maximum
30TRound 38TRound
Rear brake mount
160mmDirect Post Mount
OLD
RearHub: 148mm
Maximum tire size
29" x 2.4"
Notice:Measurements of actual tires may vary. Always
verify there is sufcient clearance between the tire and
the frame. Improper tire size could damage the bicycle
frame. Trekrecommends 6mm clearance above and on
the sides of the tire.
Bottom bracket
Press t BB92
Seat post
WARNING
Alwaysfollow the seatpost manufacturer’s minimum
insertion recommendation. Failure to follow the recom-
mendationcould cause damage to the seatpost and
result in injury to the rider.
Minimuminser tion: Referto seatpost manufacturer
Maximuminser tion:
S:21 5
M:225
ML:250
L:27 0
XL:330
Seattube inside diameter: 31.6mm
Seattube post clamp outer diameter: 36.2mm
Fork
WARNING
Exceedingthe recommended maximum fork length could
damage the bicycle and result in injury to the rider.
Travel
Sag
Axle to Crown
Frame/Size Axleto Crown (mm) Travel(mm)
S,M, ML, L, XL Recommended 515 110
Maximum 533 120
Recommendedsag: Refer to the suspension setup card
includedwith your bike or the suspension calculator at
Trekbikes.com/suspension-calculator.
IsoStrut IsoStrut maintenance Bushings, carriage
wiper seals, and foam
blocks
Replace bushings and
carriage wiper seals
Specications
Copyright 2023 Trek Bicycle Corporation All Rights Reserved
2024 Supercaliber
2
Safety
WARNING
Properly tighten hardware
Always tighten hardware to the specied torque.
Over-tightening hardware could deform or break the
hardware or components. Under-tightening hardware
could cause hardware or components to become loose.
Either situation could damage the bicycle and result in
injury to the rider.
WARNING
Reapply threadlocker
All reused-fasteners with pre-applied threadlocker must
be cleaned with isopropyl alcohol and have new thread-
locker applied before re-assembly. If threadlocker is not
applied, the fasteners may loosen which could damage
the bicycle and result in injury to the rider.
Scope
This manual contains parts diagrams, specications (such
as grease and torque values), instructions, and helpful
tips. It does not contain instructions for all components
(such as brake calipers). Refer to the original manufactur-
er for more information.
Legend
Apply grease
Do not apply grease
Apply threadlocker
Nm Torque
Zip tie
Additional resources
• Trek’s YouTube channel: youtube.com/trekbikes
• Trek Owner’s Manual: trekbikes.com/manuals
• RockShox SIDLUXE IsoSrut Service Manual found on
SRAM’s dealer portal.
2024 Supercaliber
3
Rear axle with UDH
1
2
3
25Nm
10Nm
4
56
1Switch lever — W573860
2Thru axle, 12x180 — W5290786
3Dropout brake mount — W5307257
4Derailleur hanger, UDH
Notice: Do not apply grease.
— W5271424
5Washer, 25mm
Notice: The washer is frame-specic. Install only the washer size specied.
6Bolt
Notice: Do not apply grease. Left-hand thread. Do not over-tighten.
Over-tightening could cause the hangar to break
For additional information about the UDH, refer to the SRAM user manual at sram.com.
2024 Supercaliber
4
Rear axle with SRAM Transmission Derailleur
1
23
10Nm
4
6
5
1Switch lever — W573860
2Thru axle, 12x180 — W5290786
3Dropout brake mount — W5307257
4SRAM Transmission Derailleur
— Refer to information on sram.com.
5Bushing
6Mounting bolt
For additional information about the Transmission derailleur, refer to the SRAM user manual at sram.com.
2024 Supercaliber
6
Swingarm
3
2
4
1
8
7
6
5
10Nm
10Nm
5Nm
7Nm
20Nm
Important: Torque 5
prior to installing
6, 7, and 8.
See page 13.
M5x18
4
3
M6x12
9Install between the main frame
and driveside of the swingarm.
Important: Do not
apply grease to the
threads.
8
M5x25
1Swingarm SM — 45582
M-XL — 45583
2IsoStrut axle bolt, M6x10mm — W5290780
— IsoStrut mounting fasteners
3Endcap fastener, M6x1mm — W582252
4Fasteners, M5x18mm, with washers, — W584485
5Main pivot bolt, M15x71mm — W5306810
6Wedge spacer — W5306811
7Washer, 5.3mm x 1mm — W5309244
8Fastener, M5x25mm — W5306809
9Spacer, 15x26x4 — W5307573
2024 Supercaliber
7
SLR routing with AXS shiing
Note: The fork must be removed to route the brake hose and IsoStrut lockout cable housing.
Important:
Route the cables as shown below.
4
8
7
5
6
1
2
Install the grommet prior
to routing the brake hose.
Cable tunnel
molded into
the frame
3
4
9
1Rear brake hose
2IsoStrut lockout cable housing
3Dropper seatpost cable housing
4Cable housing plugs — W600649
5Cable exit plug — W5256254
6Chainstay plug — W5259425
7Cable exit grommet — W5255861
8Chainstay plug — W600209
9Foam housing sleeves — W528082
2024 Supercaliber
8
SLR routing with mechanical shiing
Note: The fork must be removed to route the brake hose and IsoStrut lockout cable housing through the head tube.
1
2
3
4
5
Install the grommets prior to
routing the brake hose and
derailleur cable housing.
Important: Route the cables as shown below.
6
Cable tunnel
molded into
the frame
1Rear brake hose
2Rear derailleur cable housing
3IsoStrut lockout cable housing
4Dropper seatpost cable housing
5Cable exit grommets — W5255861
6Foam housing sleeves — W528082
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Trek Fahrrad Handbücher
Trek
Trek 8 Bedienungs- und Montageanleitung
Trek
Trek Kickster 2019 Bedienungsanleitung
Trek
Trek FUEL EX 2023 Bedienungsanleitung
Trek
Trek Alloy Rail 5 Gen 3 Bedienungsanleitung
Trek
Trek Fetch+ 4 Bedienungsanleitung
Trek
Trek Fetch+ 4 Bedienungsanleitung
Trek
Trek 8 Bedienungsanleitung
Trek
Trek MADONE SL 2022 Betriebsanleitung
Trek
Trek Bicycle Computer Bedienungsanleitung
Trek
Trek Ride Plus Bedienungsanleitung
Trek
Trek RIDE+ Bedienungsanleitung
Trek
Trek 2023 FX+ Bedienungsanleitung
Trek
Trek Domane SL Bedienungsanleitung
Trek
Trek DOMANE+AL 2023 Bedienungsanleitung
Trek
Trek RIDE+ Bedienungsanleitung
Trek
Trek FX SPORT CARBON 2022 Betriebsanleitung
Trek
Trek Lync Betriebsanleitung
Trek
Trek FUEL EXE 2023 Bedienungsanleitung
Trek
Trek ROSCOE 7 Betriebsanleitung
Trek
Trek BOONE 2022 Betriebsanleitung
