TRENDnet TEW-631BRP Bedienungsanleitung
TEW-631BRP
Quick Installation Guide
Table of Contents
Table of Contents
Version 07.06.2006
English ......................................................................................................
Troubleshooting ........................................................................................
1
1
2
3
5
1. Before You Start
2. Hardware Installation .........................................................................
3.
.................................................................................
Configure the Wireless Router ...........................................................
Package Contents
1. Before You Start
English
1
TEW-631BRP
Quick Installation Guide
User's Guide CD-ROM
1 x 4dBi Detachable Antenna
1 x RJ-45 Ethernet Cable (Yellow)
Power Adapter (5V, 2.5A)
Installation Requirements
Application
A computer with a wired or wireless network adapter properly installed.
Broadband Internet
Installed Cable or DSL Modem
Web Browser: Internet Explorer (5.0 or higher)
HD
DATA
English
2
2. Hardware Installation
4. Connect the AC Power Adapter to
the TEW-631BRP and then to a
power outlet.
5. Verify that the following panel lights
are on: Power, LAN, WAN and
WLAN.
3. Connect one end of a RJ-45 cable
to the TEW-631BRP's WAN port.
Connect the other end of the cable
to your modem.
Note: Gather all information related to your Internet Connection before you
start. If necessary, contact your Internet Service Provider (ISP).
1. Verify that you have an Internet
connection when connecting your
computer directly to the Cable or
DSL modem.
2. Connect one end of the yellow
RJ-45 cable to one of the
TEW-631BRP's LAN ports.
Connect the other end of the cable
to the computer's Ethernet port.
Then connect the 4dBi detachable
antenna.
Cable/DSL Modem
Internet
English
3
3. Configure the Wireless Router
Note: It is recommended that you configure the Wireless Router from a wired
computer.
2. Enter the User Name and
Password, and then click Log In.
User Name: Admin
By default, there is no password.
1. Open your web browser, type
http://192.168.1.1 in the
Address bar, and press Enter.
3. Click Basic, click Internet,click
setup wizard and then click
Launch Internet Connection
Setup Wizard.
5. Select your Time Zone and then
click Next.
4. Enter the same password in both
fields and then click Next.
By default, there is no password.
English
4
9. Click OK.
Your installation is now complete.
For detailed information regarding the TEW-631BRP's configuration and
advanced settings, please refer to the Troubleshooting section, User's Guide
CD-ROM, or TRENDnet's website at http://www.trendnet.com.
8. Click Reboot the Device.
6. Select the proper Internet
Connection type and then click
Next.
7. Configure the settings based on
information provided by your ISP.
Then click Next.
5
Troubleshooting
Q1:
A1:
I typed http://192.168.1.1 in my Internet Browser's Address Bar, but an error
message says “The page cannot be displayed.” How can I get into the
TEW-631BRP's web configuration page?
First, check your hardware settings again by following the instructions in
Section 2. Second, make sure the LAN and WLAN lights are lit. Third, make sure
your TCP/IP settings are set to Obtain an IP address automatically (see the
steps below).
1. Go into the Control Panel and double-
click the Network Connections icon,
right-click the Local Area Connection
icon and then click Properties.
2. Click Internet Protocol (TCP/IP) and
then click Properties. Then click on
Obtain an IP address automatically.
Fourth, press on the factory reset button for 15 seconds.
I am not sure what type of Internet Account Type I have for my Cable/DSL
connection. How do I find out?
Contact your Internet Service Provider's (ISP) support service for the correct
information.
I went through the Internet Connection Setup Wizard, but I can not get onto
the Internet. What should I do?
First, verify that you can get onto the Internet with a direct connection into your
modem. Second, contact your ISP and verify all the information that you have in
regards to your Internet connection settings is correct. Third, power cycle your
modem and router. Unplug the power to the modem and router. Wait 30
seconds, and then reconnect the power to the modem. Wait for the modem to fully
boot up, and then reconnect the power to the router.
Q2:
A2:
Q3:
A3:
6
Q4:
A4:
All the settings are correct, but I can not make a wireless connection to the
Modem. What should I do?
First, make sure that the WLAN switch on the back of the router is set to on.
Second, double check that the WLAN light on the Router is lit. Third, power cycle
the TEW-631BRP. Unplug the power to the TEW-631BRP. Wait 15 seconds, then
plug the power back in to the TEW-631BRP. Fourth, log into the TEW-631BRP
(see Section 3). Click on Basic and then Wireless. Make sure Enable Wireless
is checked. Fifth, contact the manufacturer of your wireless network adapter and
make sure the wireless network adapter is configured with the proper SSID. The
preset SSID of the Access Point is TRENDnet.
If you still encounter problems or have any questions regarding the TEW-631BRP,
please contact TRENDnet's Technical Support Department.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may
cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de
alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al
mencionado puede producir daños fisicos y/o daños al equipo conectado. El adaptador
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria
existente en el pais o zona de instalación.
Copyright ©2006. All Rights Reserved. TRENDnet.
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDnet’s website at http://www.trendnet.com
TRENDnet Technical Support
US Canada
24/7 Tech Support
Toll Free Telephone: 1(866) 845-3673
Europe (Germany France Italy Spain Switzerland UK)
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
Worldwide
Telephone: +(31) (0) 20 504 05 35
Toll Free Telephone: +00800 60 76 76 67
.
. . . . .
20675 Manhattan Place
Torrance, CA 90501
USA
Andere Handbücher für TEW-631BRP
5
Inhaltsverzeichnis
Andere TRENDnet WLAN-Router Handbücher
TRENDnet
TRENDnet TEW-656BRG Bedienungsanleitung
TRENDnet
TRENDnet TEW-711BR Bedienungsanleitung
TRENDnet
TRENDnet TEW-212APBO Bedienungsanleitung
TRENDnet
TRENDnet TEW-432BRP - Wireless Router Bedienungsanleitung
TRENDnet
TRENDnet TEW-811DRU Bedienungsanleitung
TRENDnet
TRENDnet TEW-812DRU Bedienungsanleitung
TRENDnet
TRENDnet TEW-656BRG Bedienungsanleitung
TRENDnet
TRENDnet TEW-716BRG Bedienungsanleitung
TRENDnet
TRENDnet TEW-638PAP Betriebsanleitung
TRENDnet
TRENDnet TEW-731BR Bedienungsanleitung
TRENDnet
TRENDnet TEW-805UB Bedienungsanleitung
TRENDnet
TRENDnet TEW-691GR Bedienungsanleitung
TRENDnet
TRENDnet TEW 632BRP - Wireless Router Bedienungsanleitung
TRENDnet
TRENDnet TEW-657BRM Bedienungsanleitung
TRENDnet
TRENDnet TEW-432BRP - Wireless Router Bedienungsanleitung
TRENDnet
TRENDnet N600 Bedienungsanleitung
TRENDnet
TRENDnet TEW-711BR Bedienungsanleitung
TRENDnet
TRENDnet TEW-450APB - Wireless Super G Access Point Bedienungsanleitung
TRENDnet
TRENDnet TEW-828DRU Bedienungsanleitung
TRENDnet
TRENDnet TEW-812DRU Bedienungsanleitung
