9
(PC-39G) with eight (8) 5/8" x 1 1/4" (16 mm x 32 mm) splice bolts and
hex nuts.
At post locations 4, 5, and 6, bolt the rail panel and wood blockout to
the wood post using a 5/8" x 18" (16 mm x 460 mm) post bolt, a hex
nut, and a round washer. The washer is installed between the wood post
and the nut.
At post location 3, splice the 12'6" (3.81 m) rail panel (PC-39G) to the
12'6" (3.81 m) rail panel (PC-30G) with eight (8) 5/8" x 1 1/4"(16 mm x
32 mm) splice bolts and hex nuts. Bolt the rail panels and wood blockout
to the wood post using a 5/8" x 18" (16 mm x 460 mm) post bolt, a hex
nut, and a round washer. The washer is installed between the wood post
and the nut.
At post locations 1 and 2, bolt rail panel to the wood posts using a
5/8" x 10" (16 mm x 255 mm) post bolt, a hex nut, and a round washer.
The washer is installed between the wood post and the nut.
The wood offset block should be secured to prevent it from
rotating . This can be done by toe nailing the block to the post or
the post to the block using 16d hot-dipped galvanized nails. The
nails should be installed approximately 3" (75mm) from the top
of the post or block, one on each side.
25'0" (7 .62 m) PANEL OPTION:
At post location 7, splice and post bolt the 25'0" (7.62 m) rail panel
(PC-69G) to the run of guardrail with hardware provided by the standard
guardrail supplier.
At post locations 4, 5, and 6, bolt the 25'0" (7.62 m) rail panel
(PC-69G) and wood blockouts to the wood posts using a 5/8" x 18"
(16 mm x 460 mm) post bolt, a hex nut, and a round washer. The washer
is installed between the wood post and the nut.
At post location 3, splice the 25'0" (7.62 m) rail panel (PC-69G) to the
12'6" (3.81 m) rail panel (PC-30G) with eight 8 5/8" x 1 1/4"(16 mm x 32
mm) splice bolts and hex nuts. Bolt the rail panels and wood blockout to
the wood post using a 5/8" x 18" (16 mm x 460 mm) post bolt, a hex
nut, and a round washer. The washer is installed between the wood post
and the nut.
At post location 2, bolt the backup rail panel (PC-3G) to the HBA Top
Post using a 5/8" x 2" (16 mm x 50 mm) post bolt, a hex nut, and a round
washer. The washer is installed between the post and the nut. Do not
attach the rail to the post.
At post location 1, bolt the rail panel to the HBA Top Post using a
5/8" x 2" (16 mm x 50 mm) post bolt, a hex nut, and a round washer.
The washer is installed between the post and the nut.
The wood offset block should be secured to prevent it from rotating. This
can be done by toe nailing the block to the post or the post to the block
using 16d hot-dipped galvanized nails. The nails should be installed
approximately 3" (75mm) from the top of the post or block, one on each
side.
