Tripp Lite PowerVerter APS512 Montage- und Bedienungsanleitung

Owner’s Manual

Addendum

IMPORTANT SAFETY INSTRUCTIONS.This addendum and the accompanying

manual contain information concerning the proper installation of Tripp Lite

equipment. SAVE THESE INSTRUCTIONS.

Hardwire AC Connection

Your PowerVerter is identical to the Inverter/Charger described in the accompanying owner’s manual with

the two exceptions (Hardwire Connection and Dip Switch Settings) described here.

Connection for Models with Hardwire Terminals

Remove the screws and cover plate over the hardwire terminal box. Remove the knockout covers closest to

the desired electrical source and to your equipment. Attach ½" diameter conduits (user-supplied) to the

knockouts and thread wires through. Connect the conduits to each other with the ground bond connection

supplied.

Ground

• Connect the incoming and outgoing ground

wires to the GROUND (green) terminal.

AC Input

• Connect the incoming hot wire to the input hot

(brown) terminal.

• Connect the incoming neutral wire to the input

neutral (blue) terminal.

AC Output

• Connect the outgoing hot wire to the output

hot (black) terminal.

• Connect the outgoing neutral wire to the

output neutral (white) terminal.

Tighten and affix strain relief. Replace cover plate and tighten screws.

HOT IN

NEUTRAL IN

GROUND IN

GROUND OUT

HOT OUT

“FOR USE WITH COPPERWIRE ONLY”

NEUTRAL OUT

PowerVerter®Hardwired Electrical Connections

& Dip Switch Settings

Power Inverters (120V, 60 Hz)

1111 W. 35th Street Chicago, IL 60609 USA

Customer Support: (773) 869-1234

www.tripplite.com

Warning! Consult a qualified electrician and follow all applicable electrical

codes and requirements for hardwire connection. Disconnect DC input and

AC utility supply before attempting hardwiring.

200211057 PV Owner’s Manual Addendum.qxd 11/21/2002 1:57 PM Page 1

200211057

93-2105

Dip Switch Settings

The Dip Switch settings described below replace the Dip Switch settings described in the accompanying

owner’s manual.

Using a small tool, configure your Inverter/Charger by setting the four DIP Switches (located on the front

panel of your unit; see diagram) as follows:

Select Battery Type—REQUIRED

(DIP Switch #1)

CAUTION: The Battery Type DIP Switch setting must match the type of batteries you connect, or your batteries may be degraded or damaged

over an extended period of time.

Battery Type Switch Position

Gel Cell (Sealed) Battery Up

Wet Cell (Vented) Battery Down (factory setting)

Select High AC Input Voltage Point for Switching to Battery—OPTIONAL

(DIP Switch #2)

Voltage Switch Position

145V Up

135V Down (factory setting)

Select Low AC Input Voltage Point for Switching to Battery—OPTIONAL

(DIP Switch #3)

Voltage Switch Position

105V Up

95V Down (factory setting)

Set Battery Charging Amps—OPTIONAL

(DIP Switch #4)

By setting on high charging, your batteries will charge at maximum speed. When setting on low charging,

you lengthen the life of your batteries (especially smaller ones).

Battery Charger Switch Position

High Charge Amp Up

Low Charge Amp Down (factory setting)

High Charge Am

Low Charge Amp

INPUT C/B 10A OUTPUT C/B 12A

200211057 PV Owner’s Manual Addendum.qxd 11/21/2002 1:57 PM Page 2

Andere Handbücher für PowerVerter APS512

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Tripp Lite Wechselrichter Handbücher

Tripp Lite

Tripp Lite EMS1250UL Bedienungsanleitung

Tripp Lite

Tripp Lite PV1000FC Installations- und Betriebshandbuch

Tripp Lite

Tripp Lite PowerVerter 200310080 Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter PV1800GFCI Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter APSRM4 Bedienungsanleitung

Tripp Lite

Tripp Lite PVINT375 Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter PVX700 Bedienungsanleitung

Tripp Lite

Tripp Lite RV Series Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter APS 1012 Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter APS Inverter/Charger APS1250F Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter PV 140 Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter PVINT375 Bedienungsanleitung

Tripp Lite

Tripp Lite PINV2000SWL-120 Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter PV700HF Bedienungsanleitung

Tripp Lite

Tripp Lite PV 400FC Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter APSX3024SW Bedienungsanleitung

Tripp Lite

Tripp Lite APSX2012SW Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter PV 1000HF Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter APSX6048VR Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter APSINT2012 Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter Ultra Compact PVINT300 Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter DC-to-AC Inverter/Charger... Bedienungsanleitung

Tripp Lite

Tripp Lite PowerVerter PV700HF Bedienungsanleitung

Tripp Lite

Tripp Lite PINV750 Bedienungsanleitung

Beliebte Wechselrichter Handbücher anderer Marken

Fourgroup

Fourgroup Easy Bedienungsanleitung

Velleman

Velleman PI300M Bedienungsanleitung

Sungrow

Sungrow SG350HX-US Bedienungsanleitung

WilTec

WilTec 61897 Bedienungsanleitung

SMA

SMA SUNNY BOY STORAGE 2.5 Bedienungsanleitung

Simplicity

Simplicity LANDLORD 316 Bedienungsanleitung

Santak

Santak SMAX 3000 Bedienungsanleitung

ATON

ATON RA.Store-3 Bedienungsanleitung

ZIEHL-ABEGG

ZIEHL-ABEGG FXET4AMQ Bedienungsanleitung

Tektronix

Tektronix CFG250 Bedienungsanleitung

Champion

Champion 200989 Bedienungsanleitung

Vanner

Vanner 20-500 Series Bedienungsanleitung

GE GEP Bedienungsanleitung

Astrel Group

Astrel Group Power Reducer Kurzanleitung

MULTIQUIP

MULTIQUIP GDP-5H Leitfaden

GoWISE

GoWISE PS1007 Bedienungsanleitung

Promate

Promate PM13500D ES Bedienungsanleitung

Mastervolt

Mastervolt WHISPER 3.5M3000 RPM Bedienungsanleitung