TV One Magenta MultiView 9D Bedienungsanleitung
QSG-DA9-V1.00
Apr 2019
MultiView 9D Cat5 Distribution
Amplifier
Quick Start Guide V1.00
In this guide
About your Multiview D9................................................................................ 1
Cabling .......................................................................................................... 1
Multiple devices ........................................................................................... 1
Quick start ........................................................................................................ 2
Troubleshooting and FAQs ............................................................................ 3
No video signal or poor video quality at the transmitter local port or
at the receiver .............................................................................................. 3
Poor audio quality ....................................................................................... 3
Serial communication doesn’t work correctly. ........................................ 3
Cabling .............................................................................................................. 4
Contact us......................................................................................................... 5
QSG-DA9 1
About your Multiview D9
The Magenta MultiView Series System extends video signals over
ordinary Category 5 cable. All models use a transmitter-to-receiver
setup.
This device is not intended for, nor does it support, distribution through
an Ethernet network. Do not connect this device to any sort of
networking or telecommunications equipment.
Cabling
This device is compatible with Cat5/5e/6 data cabling as well as skew
free CAT5/5e cabling manufactured for video applications. Note that
some skew free Cat5 is specific to a particular vendor and is not
compatible with our products.
Please ensure any skew free CAT5 cable is non-proprietary prior to
purchase/ installation.
CAT6 cable, due to the manufacture method, can exhibit much greater
skew than standard CAT5/5e and may require skew compensation
beyond what the standard product offers. Please contact Magenta
Research for assistance.
CAT5/5e/6 cabling for the Magenta MultiView™ Series must be pinned
to the TIA-EIA T568B wiring specification. We recommend that all CAT5
cables be pre-terminated and tested. Cables terminated on-site or in an
existing infrastructure should be tested before use to ensure
compliance with the TIA-EIA T568B specification. Using incorrectly
terminated CAT5 cables can damage your device.
Multiple devices
The MultiView 9D 1x9 Distribution Amp utilizes industry standard CAT5
cabling to connect a MultiView transmitter and receivers.
Additional 9D 1x9 Distribution Amps may be cascaded via the UTP
THRU output or any other output if necessary.
2 tvONE
Quick start
1. Connect the RJ-45 cable from a MultiView transmitter unit or other
MultiView 9D 1x9 Video Distribution Amp into the port labeled UTP
IN.
2. Connect RJ-45 cables from MultiView receiver units into the ports
labeled OUTPUTS.
3. The port labeled UTP THRU may be used to cascade to other
MultiView 9D 1x9 Video Distribution Amps or can be used with a
MultiView receiver.
4. Connect the power supply to the unit.
5. Connect the included ground cable to the rear gold thumbscrew and
the other end to a suitable earth ground. The grounding is required
in instances where LCD monitors are used that do not provide a
ground via the DC power adapter. Failure to connect the ground
cable may result in loss of video signals.
QSG-DA9 3
Troubleshooting and FAQs
In most cases, nearly every issue with the MultiView Series can be resolved
by checking the CAT5 termination and making sure that it’s pinned to the
TIA/EIA 568B wiring specification. However, there may be other problems
that cause the system to not perform as it’s designed. Below are solutions to
the most common installation errors.
No video signal or poor video quality at the transmitter
local port or at the receiver
1. Check that all units are powered.
2. Ensure EQ adjustment on receiver is set correctly.
3. Make sure the CAT5 cable is terminated correctly perthe TIA/EIA
568B wiring specification.
4. Is the display device powered on and functioning?
5. Check to ensure display settings (resolution, refresh rate, etc) are
compatible with input signal.
Poor audio quality
1. Powered speakers are required. Make sure speaker power is ON.
2. Check input source levels from the source device. Make sure the
audio source is not overdriven or underdriven.
3. Audio is summed left and right for “A” versions. If using a single
channel, both audio inputs must be connected at the transmitter
end for full audio gain. Audio is line level.
4. SA serial//audio units support full stereo line level. A high frequency
noise may be heard if the Cat5 cable from the transmitter is
disconnected, or the transmitter is not powered up. This is normal
and will disappear once a complete link connection is made.
Serial communication doesn’t work correctly.
1. Are the serial devices connected properly? Are the serial parameters
correct for source/destination devices?
2. When using RS-232 transmitters or receivers in daisy chains, Cat5
switches, 9D Cat5 distribution amps, or Multi-output transmitters,
the serial signal is a unidirectionally broadcast mode only. In this
4 tvONE
mode, all other MultiView™ CAT5 Video System devices must be the
simplex serial type.
Cabling
Contact us
tvone.com
Information in this document is subject to change without notice. No part of this publication
may be reproduced, stored in a retrieval system, or transmitted in any form or any means
electronic or mechanical, including photocopying and recording for any purpose other than
the purchaser's personal use without the written permission of tvONE.
Copyright © 2019 tvONE™. All rights reserved.
Registered in the U.S. Patent and Trademark Office.
Inhaltsverzeichnis
Andere TV One Verstärker Handbücher
TV One
TV One 1T-DA-726 3G Bedienungsanleitung
TV One
TV One 1T-DA-654 Bedienungsanleitung
TV One
TV One 1T-VGA-412 Bedienungsanleitung
TV One
TV One 1T-DA-672 Bedienungsanleitung
TV One
TV One 1T-DA8CVB Bedienungsanleitung
TV One
TV One 1T-DA-726 HD Bedienungsanleitung
TV One
TV One 1T-DA8CVB Bedienungsanleitung
TV One
TV One TASK 1T-DA-552 Bedienungsanleitung
TV One
TV One 1T-VGA-412 Bedienungsanleitung
TV One
TV One 1T-DA-652 Bedienungsanleitung
TV One
TV One 1T-DVI-512 Bedienungsanleitung
TV One
TV One 1T-DVI-512 Bedienungsanleitung
TV One
TV One 1T-DA-682 Bedienungsanleitung
TV One
TV One 1T-DA-124 Bedienungsanleitung
TV One
TV One 1T-DA-672 Bedienungsanleitung
TV One
TV One PD-760SVA Bedienungsanleitung
TV One
TV One 1T-VGA-412 Bedienungsanleitung
TV One
TV One 1T-DA-124 Bedienungsanleitung
TV One
TV One 1T-DA-462 Bedienungsanleitung
TV One
TV One 1T-DA-552 Bedienungsanleitung
