TWIN BUSCH GmbH
Printing errors, mistakes and technical changes reserved
©by TwinBusch Germany
6
2. Overview about the wheel aligner
2.1 General
The wheel aligner was designed to measure the axle geometry and compare it with the default values of the vehicle
manufacturers. It also gives the user instructions on how to make appropriate adjustments for best steer ability and lowest tire
w e a r .
2.2 Function and properties
•Complete test: The Wheel Aligner can be used to measure the most wheel alignment
Parameters, such as front wheel toe-in, front wheel camber, caster, Kingpin inclination,
Rear wheel toe-in, rear wheel camber, thrust angle, wheelbase difference, tread
Difference, axle offset, front wheel setback and rear wheel setback, etc.
•Complete databank: wheel alignment data of over 20,000 vehicle models is stored in the system. User can also add
new data to the databank.
•Adopts the charge coupled device (CCD) with high resolution, infrared 8-beam and full
Loop measurement, accurate and stable, Bluetooth wireless communication mode, no
Data transmission influence.
•Based on the thrust line to realize the real alignment measurement.
•Front alignment test function: user can select the alignment mode flexibly. Only two
Probe rods are mounted can the emergency alignment measurement for the front wheels are performed.
•The sensor heads are individually interchangeable. After changing one of the sensor
Heads, the other three needs not to recalibrate, which makes the after-sales service
more convenient.
•Fully intelligence. The system can automatically recognize the vehicle with super-low
Chassis to perform the alignment test for this kind of vehicle and the vehicle with
enclosed housing. Aiming to the vehicle model, the system can automatically turn on the corresponding
functions of height measurement and counterweight, etc.
•The demonstration version can run all test flow, which makes user’s training more
Convenient and quick.
•Perform the special alignment test for Mercedes-Benz, BMW, Audi and Passat vehicles,
Etc.
•The units of the alignment parameters can be represented with Degree/Minute,
percentage degree, mm and Inch.
•The voice prompt function is provided during measurement, very easy to understand.
•Automatic check function for incorrect calibration is provided, which can prompt the
user to recalibrate in time.
•Client prompting function can make the client return visit in time.
