U.S. Products FLOOD KING 120 Betriebsanleitung

IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY

1. Always use a defoamer when foaming occurs to prevent vacuum motor damage.

2. Keep machine from rain and snow, extremes in temperatures, and store in a heated

location. Use the machine indoors. Do not use outdoors.

3. Never use the machine without the pre-filter bag installed.

FLOOD KING®

120V

INFORMATION

OPERATING

INSTRUCTIONS

02-02-2010

CAUTION: DO NOT OPERATE MACHINE UNTIL YOU HAVE READ

ALL SECTIONS OF THIS INSTRUCTION MANUAL

56041549 Rev D

IMPORTANT SAFETY INSTRUCTIONS

This machine is only suitable for commercial use, for example in hotels, schools, hospitals, factories,

shops and offices other than normal residential housekeeping purposes.

When using any electrical appliance, basic precautions should always be followed, including the following:

NOTE: Read all instructions before using this machine.

WARNING!

To reduce the risk of fire, electric shock, or injury:

•Do not leave the machine unattended when it is plugged in. Unplug the unit from the outlet when

not in use and before servicing.

•To avoid electric shock, do not expose to rain or snow. Store, and use, indoors.

•Do not allow to be used as a toy. Close attention is necessary when used near children.

•Use only as described in this manual. Use only the manufacturer’s recommended attachments.

•Do not use with damaged cord or plug. If the machine is not working as it should, has been

dropped, damaged, left outdoors or dropped into water, return it to a service center.

•Protect the cord. Do not: use the cord as a handle, close a door on the cord, or pull the cord around

sharp edges or corners. Do not run the machine over the cord. Keep the cord away from heated

surfaces. To unplug, grasp the plug, not the cord.

•Do not handle the plug, the cord or the machine with wet hands.

•Extension cords must be 12/3 and no longer than 50 feet. Replace the cord or unplug immediately

if the ground prong becomes damaged.

•Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint,

hair, and anything that may reduce air flow.

•Keep loose clothing, hair, fingers, and all parts of body away from openings and moving parts.

•Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes, or

any health endangering dusts. Do not use to pick up flammable or combustible liquids such as

gasoline or use in areas where they may be present.

•Turn off all controls before unplugging.

•Connect to a properly grounded outlet only.

INSPECTION:

Carefully unpack and inspect your FLOOD KING for shipping damage. Each machine is tested and

inspected before shipping. Any damage incurred during shipping is the responsibility of the carrier. You

should notify the carrier immediately if you notice damage to the box or to the machine or parts.

MAINTENANCE:

Prior to each job, inspect the recovery tank pre-filters, the stainless steel in-line filters, the float, and the

drain hose to make sure every thing is clean and able to function properly. After each job, remove and

clean both the nylon mesh pre-strainer at the vacuum inlet and the stainless steel filters in the bottom of

the recovery tank. Unscrew the clear caps off the in-line filters (located under the recovery tank) and clean

the screens often. Pump damage may occur if the filters become clogged.

Check hose clamps regularly to make sure they are tight. The pump discharges water at high

pressure. If a hose clamp becomes loose, the hose could also come loose, or fall off of the hose barb, and

leak water into the base compartment.

Lubricate the wheels, castors, latches, and quick disconnects with an all purpose silicone spray. The

vacuums and the pumps do not require any scheduled maintenance; however the vacuum motors may

require new brushes after 1000 - 1500 hours. Clean the body with an all purpose detergent, and protect it

with an automobile interior spray protectant.

Record the serial number and model of your new flood extractor here:

Serial Number: __________________ Model: FLOOD KING-120

Purchase Date:_____________

Write the name and phone number of your distributor:

____________________________________________________________________

be sure to register your purchase to activate your warranty

SAVE THESE INSTRUCTIONS

SET-UP:

Connect the vacuum/recovery hose to the vacuum inlet hose barb on the recovery tank. Connect the

dump hose to the hose fitting on the rear of the machine. Check filters. Put the lid on the

recovery tank. Plug the machine into a grounded outlet.

VACUUM OPERATION:

A switch is provided for each vacuum motor. The machine can operate with either one, or both, vacuum

motors running.

VACUUM SHUT-OFF:

When the recovery tank is full, the float system will shut off power to the vacuum motor(s) to prevent

water from entering the motor(s). The float may not work properly if it is extremely dirty or if there is

foam in the tank. Use a defoamer any time foam is present. Once the tank has emptied sufficiently, the

vacuums will come back on automatically.

PUMP OPERATION:

Always be sure to uncap the pump-out fitting and connect the dump hose before turning the pumps on.

Failure to do so may result in blown hoses or loose fittings; water will damage motors and switches.

The two diaphram pumps on your Flood King work together. When you turn the pump switch on, both

pumps will run, and they will continue to run until you turn them off. Do not let the pumps run dry for

extended periods of time.

Recovery Tank

Access Lid

Recovery Hose

Connection Point

Latch

Castor 10” Wheel

Drain Hose

& Pump Out Hose

Connection

(on rear)

Switches

Vacuum

Cover

FLOOD KING

120 V

02/04/2010

46B

46A

46A 46B

54A

48-

FLOOD KING

PART LIST

120V

46B 1466 Hose barb/elbow

47 1468 Hose, 3/4” ID X 3”

48 152 “T,” brass

49 372 Elbow, brass, 45 degree

50 928 Louver, 3”, includes screws

51 495A Power cord, 25 ft, 12/3

52 237 Cap, with chain

53 379 Hose fitting

54 152A Washer, flat, S/S

54A 237A Washer, rubber

55 910-24.50 Axle, 24-1/2” long

56 27A Axle cap

57 2084 Wheel, 10”

58 905 Castor. 4”

59 SUBBS-13 Base, drilled, black

60 408E Vacuum motor, 3-stage

61 MA-9 Manifold, vacuum

62 1477 Gasket, under Vac Manifold

63 1056 Screen, wire filter, vac inlet

64 2013A Gasket, under vac motor

65 FP523 Cover, over vacuums

67 937 Coupling, PVC

70 801 Hinge Pin

71 2079 Hose, reinforced, 10”

72 1476 Strap, stop

73 908B Latch & strike

1 2077 Hose Barb, 1-1/2”

2 1463 Eblow, ABS, 45 degrees (3)

3 1464 Bushing, 2” slip

4 SUBVT-25 Tank, recovery

4A 2070B Lid, 6”, vac, with mounting ring

4B 1129 Gasket, for vacuum lid

5 FP521 Strainer bag, vac inlet

9 1434 Switch plate

10 FP578 Switch, SPST

11 1130 Strap, velcro

12 1518 Hose Clamp

14 1060B Hose, drain

16 1060C Plug, drain hose

17 2068 Float, switch

18 230 Retainer, cord

19 196 Clamp, cable

20 1518 Hose Clamp

21 1349 Spacer, float

22 290 Washer, flat, rubber

24 1350 Bracket, float mounting

25 2069 Filter, inlet, 60 mesh, S/S

28 1168 Nipple, PVC, 3/4 X 1-3/8”

32 1468 Hose, 3/4” ID X 22”

33 2079 Hose, 3/4” ID X 14”

34 2079 Hose, 3/4” X 13”

36 378 Hose barb, brass

43 380 Hose clamp

45 2074 Filter, in line, 50 mesh

46 2067 Pump, dump

46A N/A Hose barb. from pump

ItemPart No Description ItemPart No Description

MISCELLANEOUS PARTS

919C Vacuum InletHose, 25ft

717 Hose Cuff, for Vac Hose

956A Drain Hose, 50 ft

971 Bag, Mesh, for hoses

SPECIFICATIONS:

POWER CORD:

POWER CONSUMPTION:

RECOVERY CAPACITY:

VACUUM INTAKE HOSE:

VACUUM MOTOR(s):

WATER LIFT/CFM:

AIR WATTS:

OVERFLOW PROTECTION:

DISCHARGE PUMPS:

DISCHARGE HOSE:

DISCHARGE RATE:

FILTER SYSTEM:

One, 25 ft, 12 gauge, 3-wire with hospital grade plug

13 Amps, total

9 gallon

2 inch X 25 ft

Two, 3-stage

100 inches / 170 cfm

520 AW in operational range

Electronic float; auto off/on

Two diaphragm bilge pumps

One 3/4 inch X 50 ft

10.5 GPM

One 80 micron mesh strainer at water inlet on recovery

tank; two 60 mesh S/S filters in the recovery tank; two 50

mesh S/S screens in-line with bilge pupmps

WEIGHT: 85 pounds

FLOOD KING®

120V

NOTES:

208-772-0573 • 800-257-7982 •FAX: 208-772-0577

VISIT US AT: http://www.usproducts.com

Inhaltsverzeichnis

Andere U.S. Products Wasserpumpe Handbücher

U.S. Products

U.S. Products FLOOD KING 240V Betriebsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken

Neptun

Neptun NPHW 5500 Bedienungsanleitung

Sensidyne

Sensidyne Gilian BDX-II Montage- und Bedienungsanleitung

Draper

Draper 47808 Bedienungsanleitung

Trolla

Trolla 12820 Bedienungsanleitung

Sunfab

Sunfab SVH Series Bedienungsanleitung

WilTec

WilTec 50740 Bedienungsanleitung

Fieldmann

Fieldmann FVC 5015 EK Bedienungsanleitung

Everbilt

Everbilt EFSUB5-122HD Bedienungsanleitung

Graco

Graco Husky 3300e Bedienungsanleitung

esotec

esotec 101018 Bedienungsanleitung

Becker

Becker BASIC VASF 2.80/1-0.AC230 Bedienungsanleitung

Sykes AmeriPumps

Sykes AmeriPumps GP100M Fehlerbehebungshandbuch

DUROMAX

DUROMAX XP WX Series Bedienungsanleitung

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Bedienungsanleitung

Franklin Electric

Franklin Electric IPS Bedienungsanleitung

Xylem

Xylem e-1532 Series Bedienungsanleitung

Milton Roy

Milton Roy PRIMEROYAL Bedienungsanleitung

STA-RITE

STA-RITE ST33APP Bedienungsanleitung