Unique UGP-470L Bedienungsanleitung
470L / 16.6 cu. ft.
SOLAR POWERED
DC FRIDGE
OWNER’S GUIDE
UGP-470L
serial number:
TABLE OF CONTENTS
03 Important safety notes
07 Installation
08 DC power connection
11 Operation
15 Energy saving tips
16 Troubleshooting
18 Appliance information
18 Notes
19 Contact us
19 Limited warranty
back Technical specifications
3
IMPORTANT SAFETY NOTES
Congratulations! You have purchased one of the most ecient re-
frigeration products available on the market today. The Unique 470L
solar powered DC fridge is designed to provide years of ecient
trouble-free operation. The design is optimized for energy savings
with an ecient DC compressor and thick insulation.
Before using the appliance, read through this manual carefully
including all the information on safety, installation, operation, and
cleaning. These guidelines do not cover every possible condition or
situation that may occur. Be safe using common sense and caution
when installing, operating and cleaning this appliance. If you are un-
sure about any of these instructions or warnings, contact your local
product dealer or Unique O-Grid Appliances for assistance.
IMPORTANT: After transit where the fridge has been
on its side or back, ensure that the fridge is in a level,
upright position for 12 hours to allow compressor fluids
to redistribute evenly before use.
4
• To allow the interior to cool down properly, run the fridge for at
least 4 hours empty before adding food.
• This fridge is designed to operate on 12 or 24 volts DC ONLY. DO
NOT CONNECT THIS FRIDGE TO AN AC (alternating current)
POWER SOURCE.
• This fridge is designed for domestic use only! It is intended for the
storage of edible/consumable food and drinks. It is not intended
for commercial or industrial use.
• Never use excessive force on the handle to open the door.
• If the room/ambient temperature approaches the fridge’s oper-
ating temperature, the fridge may not function corrently. If the
room/ambient temperature exceeds 100˚F (38˚C) the fridge may
not function correctly.
• A DC powered fridge has a lower cooling capacity than typical AC-
powered appliances. Because the compressor is small, the fridge/
freezer runs more eciently but lacks the ability to cool larger
warm loads as quickly as typical AC-powered appliances.
IMPORTANT SAFETY NOTES continued
5
These warnings are provided in the interest of your safety. Please
ensure that you understand them all before installing or using this
fridge. Your safety is of paramount importance. If you are unsure
about any of these meanings or warnings, contact your local prod-
uct dealer or Unique O-Grid Appliances for assistance.
PRIOR TO INSTALLATION:
At delivery, please check that the fridge is complete and has not
been damaged during transport. It is not advised to connect an ap-
pliance that has been damaged, especially damage to the electrical
supply cable or refrigerant circuit. In the event of damage please
contact your local product dealer or Unique O-Grid Appliances for
assistance.
GENERAL SAFETY
• Before cleaning or repositioning the fridge/freezer, always discon-
nect from the electrical power supply.
• Service the fridge/freezer only if you are a trained or authorized
refrigeration technician.
• This appliance contains refrigerant R-134a and a polyolester com-
pressor oil in its refrigerant circuit. Take utmost care when handling
your fridge so as to not cause damage to the refrigerant circuit
with consequent possible leakage.
• Do not use other electrical appliances (such as ice cream makers)
inside of the refrigerating appliance.
CHILD SAFETY
• Do not allow children to play in, on or around the fridge. It is not
a toy. THERE IS A DANGER OF SUFFOCATION IF A CHILD BE-
COMES TRAPPED INSIDE.
• When the appliance is not in use, secure or remove the doors to
prevent children from playing inside the cabinets.
• DANGER OF SUFFOCATION - Keep children away from all
packaging material.
INSTALLATION
• This appliance is heavy. Care should be taken when moving it.
• This appliance operates on 12 or 24 Volts DC (Direct Current) only!
• Under no circumstances should this appliance be directly connect-
ed to an AC (Alternating Current) power source.
• Be sure that the appliance does not stand on the electrical sup-
IMPORTANT SAFETY NOTES continued
6
IMPORTANT SAFETY NOTES continued
ply cable. Also, be sure the electrical cable is not squeezed or bent
when the appliance is being installed or moved.
• Installation work and adjustments on the appliance must be carried
out by qualified personnel only. Work performed by persons with
inadequate technical knowledge may adversely eect the perfor-
mance of the appliance, causing damage to the equipment, and
void the warranty.
• It is dangerous to make alterations or attempt to modify this prod-
uct in any way. Product alterations will void the warranty.
DURING USE
• This appliance is designed for domestic use only, specifically for the
storage of food and drinks. This appliance is not designed for com-
mercial or industrial use.
• Do not store any containers with flammable vapors or liquids in
or around the appliance, such as organic solvents, spray cans, gas
cans, etc. Danger of explosion!
CLEANING
• Before cleaning always turn the fridge/freezer o and disconnect it
from the electrical power supply.
• Allow inside of fridge/freezer to fully thaw, then wash the inside
and outside of the appliance with luke warm water and a mild soap
or detergent. Abrasive or corrosive cleaning agents, steel wool,
scouring sponges, or chemical cleaning agents should not be used
under any circumstances.
SERVICING
• This product should be serviced by an authorized technician and
only genuine spare parts should be used.
• Under no circumstances should you attempt to repair the appliance
yourself. Repairs carried out by inexperienced persons may cause
injury or serious malfunctioning of the appliance. Unauthorized
work may void the warranty.
DISPOSING OF THE APPLIANCE
• When disposing of your fridge, use an authorized disposal site. The
refrigerant must be completely drained and collected by an au-
thorized technician for recycling prior to disposal. Check with your
local Environmental Agency for recommendations on recycling this
appliance in your area. Remove the electrical connection wiring and
also ensure that the lid is removed to prevent children from being
trapped inside - DANGER OF SUFFOCATION!
7
INSTALLATION
UNPACKING AND CLEANING
Remove all packaging and securing tapes from the appliance.
To avoid injury and causing damage to the appliance, be extremely
cautious when using sharp or pointed tools to complete this task.
Keep children away from the packaging material - DANGER OF SUF-
FOCATION! Wash the inside and outside of the appliance with luke
warm water and a mild soap or detergent. Abrasive or corrosive
cleaning agents, steel wool, scouring sponges, or chemical cleaning
agents should not be used under any circumstances. A sponge, soft
brush or towel is recommended. After cleaning, thoroughly rinse and
dry. You may want to leave the doors open allowing the compart-
ments to ventilate for 20-30 minutes to get rid of residual odors.
Check with your local Environmental Agency for recommendations
on recycling packaging materials in your area.
POSITIONING THE APPLIANCE
The area in which the fridge is to be installed must be relatively cool,
dry, and suitably ventilated. The area must be protected against any
inclement weather (rain, snow) and excessive surface dust. To ensure
proper function, the appliance must be placed horizontally on a flat,
firm, and stable surface resting level on all four supports. The floor
must be strong enough to support a fully loaded cabinet. Use wood
or metal shims to level the fridge if necessary.
Do not place the fridge close to heat sources (heater, stove, boiler,
chimney, etc.), and avoid prolonged exposure to direct sunlight. This
appliance uses the exterior walls to transfer heat from the inside of
the cabinet. Ensure that there is adequate space between the fridge
and neighboring walls or large objects. A minimum spacing of 3
inches (7.5 cm) is highly recommended. This will provide sucient
airflow around the appliance resulting in more ecient operation and
longer appliance lifetime. Always keep the air vent openings of the
compressor housing cover free from dust and obstructions.
8
DC POWER CONNECTION
IMPORTANT: After transit where the fridge has been on
its side or back, ensure that the fridge is in a level, up-
right position for 12 hours to allow compressor fluids to
redistribute evenly before use.
THIS FRIDGE MUST NEVER BE CONNECTED DIRECTLY
TO ANY AC (alternating current) POWER SOURCE!
THE FRIDGE MUST ONLY BE CONNECTED TO A 12V OR 24V DC
POWER SOURCE, SUCH AS A SOLAR
BATTERY SYSTEM OR CHARGE CONTROLLER.
THE FRIDGE WILL AUTOMATICALLY OPERATE ON EITHER 12V OR
24V DC. THE USER DOES NOT NEED TO MAKE ANY ADJUSTMENT.
ATTENTION: Polarity is important in wiring this DC appliance. Be
sure that the positive terminal of the battery or charge controller
coincides with the positive wire to the compressor, and the nega-
tive terminal of the battery or charge controller coincides with the
negative wire to the compressor. The leads should be connected
using cable shoes and screwed connections. Joined leads should be
avoided.
+ to + and - to -
positive to positive / negative to negative
(red wire) / (black wire)
9
DC POWER CONNECTION continued
IN-LINE FUSE
A 15A in-line fuse is provided with this fridge in order to protect the
wiring. For 12V operation, use a 15A fuse, and for 24V operation
use a 7.5A fuse. A standard automobile fuse is recommended and
the fuse should be wired to the positive (“+”) side of the system
close to the positive battery terminal.
A 15A fuse is provided with this fridge/freezer.
If using 24V as operating voltage, you must provide a 7.5A fuse.
OPERATING VOLTAGE FUSE
12 V 15 A
24 V 7.5 A
ELECTRICAL DIAGRAM
10
DC POWER CONNECTION continued
ATTENTION
If a longer connection cable is necessary, the cable cross section
(or gauge) must be equal to or greater than the cable sizes recom-
mended on the following table. Be careful that the input voltage at
the appliance does not drop below the cut-out voltage of the com-
pressor.
LOW VOLTAGE DISCONNECT
The compressor electronics includes a low voltage disconnect fea-
ture. If the input voltage to the appliance falls below 9.6V (in 12 V
mode) or 21.3V (in 24 V mode), the compressor will shut-o. Once
the voltage increases above 10.9V (in 12V mode) or 22.6V (in 24V
mode), the compressor will resume normal operation.
This feature is designed to protect the system battery from experi-
encing too low a depth of discharge.
CABLE SIZE 12V CABLE
LENGTH
24V CABLE
LENGTH
AREA AWG
mm2/inch Gauge m ft m ft
2.5 / 3/32”12 2.5 8 5 16
4 / 5/32”12 4 13 8 26
6 / 15/64”10 6 19.5 12 39
10 / 25/64”8 10 32.8 20 65.6
12 V OPERATION 24 V OPERATION
CUT-IN 9.6 V 21.3 V
CUT-OUT 10.9 V 22.7 V
Inhaltsverzeichnis
Andere Unique Kühlschrank Handbücher
Unique
Unique UGP 22 DV Bedienungsanleitung
Unique
Unique UGP 22 Bedienungsanleitung
Unique
Unique CB2426 Bedienungsanleitung
Unique
Unique Classic UGP-510L W AC Bedienungsanleitung
Unique
Unique UGP-470L1 Bedienungsanleitung
Unique
Unique UGP 3 SM Leitfaden
Unique
Unique UGP 6C Konfigurationshandbuch
Unique
Unique Classic UGP-230L Bedienungsanleitung
Unique
Unique Classic UGP-385L CR Bedienungsanleitung
Unique
Unique UGP-330L W AC Bedienungsanleitung
Unique
Unique UGP-80L1 W Bedienungsanleitung
Unique
Unique UGP-275L B AC Bedienungsanleitung
Unique
Unique UGP-260L1 Bedienungsanleitung
Unique
Unique UGP 15 Montageanleitung
Unique
Unique UGP 8 Bedienungsanleitung
Unique
Unique UGP 13 Montageanleitung
Unique
Unique UGP 6C CR Bedienungsanleitung
Unique
Unique UGP-108L1 Bedienungsanleitung
Unique
Unique UGP-10 Montageanleitung
Unique
Unique UGP-275L W Bedienungsanleitung
Beliebte Kühlschrank Handbücher anderer Marken
Bonnet Neve
Bonnet Neve SKYVIEW PLUS Bedienungsanleitung
Zanussi Electrolux
Zanussi Electrolux ZERB 8441 Bedienungsanleitung
Sharp
Sharp SJ-BA31IEXW2-EU Bedienungsanleitung
CORBERO
CORBERO CC2300MCW Bedienungsanleitung
KitchenAid
KitchenAid 2205264 Bedienungsanleitung
Stengel
Stengel KU 1101 A++ Bedienungsanleitung
