Valcom VIP-148AL-IC Bedienungsanleitung

1 947823

ISSUE 1

VIP-148AL-IC InformaCast® Compliant

IP Talkback Horn

Installation

Mounting (Network Interface)

The Network Interface is designed for wall or

shelf mounting and must be within 300 feet of

the network switch.

Shelf: Provided with the Network Interface are

four rubber pads. Peel the pads from the carrier

backing and place at the four corners of the

bottom of the unit.

Wall: Using the hardware provided, secure the

Network Interface to the wall.

Mounting (Horn)

The horn should be mounted 15 to 20 feet

above the floor to allow for best sound

distribution. The unit can be mounted to a wall,

a beam or an electrical box.

NOTE: For ease of installation, the base can be

attached to the speaker before or after the base

is mounted.

Loosen position adjustment knob

Insert the ball of the base into the socket of

the speaker

Tighten the position adjustment knob

These horns should be mounted 15 to 20 feet

above the floor to allow for best sound

distribution. The units can be mounted to a wall,

a beam or an electrical box.

A “C” clamp is provided with the horns to allow

mounting to a beam. When using the “C” clamp

for mounting, remove the signal cable from the

ball mount. Reinstall an RJ45 connector on the

signal cable after mounting, using the T568B

pinout scheme. See Figure 1.

The base has holes punched for a

double-gang square box, but by punching

out additional knockout holes, the base can

be mounted to a single-gang or octagon

box See Figure 2.

Mount the base to wall studs using the two

holes provided. Knockout holes are

provided for punch out should additional

holes be desired. See Figure 3.

The horns may be rotated or moved up and

down to obtain the desired position by

loosening the position adjustment knob at

the bottom of the unit approximately one

turn. Make required adjustments, retighten

knob.

Figure 1. Mounting to a Beam with a “C” Clamp

2 947823

Figure 2. Mounting to an Electrical Backbox

Figure 3. Mounting to a Wall Stud

Interconnections

The only method of powering a VIP-148AL-IC

IP Paging Horn is via a Power over Ethernet

(PoE) switch or power injector meeting the

802.3af specification.

Make all required signal connections before

connecting to Ethernet switch or power injector

meeting the 802.3af specification.

Signal Connections

Audio output connection is made from the Signal

Output. The RJ-45 connector on the horn is

connected directly to the RJ-45 Signal Output

socket on the Network Interface. If additional

length is required, any standard T568B

extension may be used. See Figure 4.

Network Connection

As shown in Figure 4, the Network Interface has

one RJ-45 network connector on the front panel.

Use a standard Ethernet patch cable to connect

the NETWORK connector of the Network

Interface to an 802.3af compliant PoE port

(100m maximum distance).

Status Indicator Lights

The IP Link has 2 status indication lights located

on network jack.

Green LED: (Link) Indicates Ethernet

connection when illuminated.

Yellow LED: (Activity) Indicator flashes to

indicate network activity.

Setup

The VIP-148AL-IC will automatically acquire an

IP address (using DHCP) and connect to the

InformaCast server when connected to the

network and powered up. Information specific to

your application will need to be programmed into

the InformaCast server. Refer to the

InformaCast documentation for further

information.

3 947823

TECHNICAL ASSISTANCE

Assistance in troubleshooting is available from

the factory. Call (540) 563-2000 and press 1 for

Technical Support or via email at

[email protected].

When requesting assistance, you should include

all available information. It is strongly suggested

that you go to the website and review the

information at www.valcom.com/informacast.

Valcom equipment is not field repairable.

Valcom, Inc. maintains service facilities in

Roanoke, VA.

Should repairs be necessary, attach a tag to the

unit clearly stating your company name,

address, phone number, contact person and the

nature of the problem. Send the unit to:

Valcom, Inc.

Repair & Return Dept.

5614 Hollins Road

Roanoke VA. 24019

VALCOM LIMITED WARRANTY

Valcom, Inc. warrants its products only to the original purchaser, for its own use, to be free from defects in materials and workmanship under

conditions of normal use and service for a period of one year from the date of shipment. This Limited Warranty obligation shall be limited to the

replacement, repair or refund of any such defective device within the warranty period, provided that:

1. inspection by Valcom, Inc. indicates the validity of the claim;

2. the defect is not the result of damage, misuse or negligence after the original shipment;

3. the product has not been altered in any way or repaired by others and that factory sealed units are unopened (a service charge plus parts

and labor will be applied to units defaced or physically damaged);

4. freight charges for the return of products to Valcom are prepaid;

5. all units 'out of warranty' are subject to a service charge. The service charge will cover minor repairs (major repairs will be subject to

additional charges for parts and labor).

This Limited Warranty is in lieu of and excludes all other warranties, expressed or implied and in no event shall Valcom, Inc. be liable

for any anticipated profits, consequential damages, loss of time or other losses incurred by the buyer in connection with the purchase,

operation, maintenance, installation, removal or use of the product. The maximum liability of Valcom under this warranty is limited to

the purchase price of the specific Product covered by the warranty.

Disclaimer. Except for the Limited Warranty provided herein, the product is provided “as-is” without any warranty of any kind whatsoever

including, without limitation, any WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR NON-INFRINGEMENT.

This warranty specifically excludes damage incurred in shipment. In the event a product is received in damaged condition, the carrier should be

notified immediately. Claims for such damage should be filed with the carrier involved in accordance with the F.O.B. point.

Headquarters:

Valcom, Inc.

5614 Hollins Road Roanoke, VA 24019-5056

Phone: (540) 563-2000 FAX: (540) 362-9800

4 947823

RJ45 NETWORK

CONNECTION

SIDE

STANDARD

RJ45 PATCH CABLE

(T568B)

Typical 568B

RJ-45 Jack

RJ-45

CAT 3/5/6

CALL IN SWITCH

NORMAL OPEN

MOMENTARY CLOSED

(OPTIONAL)

VM-186

RJ45

WHITE/GREEN

GREEN

WHITE/BROWN

BROWN

BLUE

WHITE/BLUE

BLUE

WHITE/ORANGE

ORANGE

WHITE/GREEN

GREEN

WHITE/BROWN

BROWN

WHITE/BLUE

BLUE

WHITE/ORANGE

ORANGE

HORN

*The Maximum Recommended Distance

From the IP Link to the Horn is 350’.

RJ45 NETWORK

CONNECTION

SIDE

HORN SIGNAL CONNECTION

HORN

Figure 4. Audio Connections

Andere Valcom Horn Handbücher

Valcom

Valcom V-1090- BG Bedienungsanleitung

Valcom

Valcom FLEXHORN V-1090 Bedienungsanleitung

Valcom

Valcom InformaCast VIP-480L-IC Bedienungsanleitung

Valcom

Valcom PagePac V-5331215A Bedienungsanleitung

Valcom

Valcom VIP-9831AL Bedienungsanleitung

Valcom

Valcom Flexhorn VIP-490AL-IC Bedienungsanleitung

Valcom

Valcom V-1048B Bedienungsanleitung

Valcom

Valcom PagePac V-5331210 Bedienungsanleitung

Valcom

Valcom V-1090 Flexhorn Bedienungsanleitung

Valcom

Valcom V-1048M Bedienungsanleitung

Valcom

Valcom V-1030C Bedienungsanleitung

Valcom

Valcom V-1039A Bedienungsanleitung

Valcom

Valcom V-9925A Bedienungsanleitung

Valcom

Valcom V-1030C Bedienungsanleitung

Valcom

Valcom VIP-148AL Bedienungsanleitung

Valcom

Valcom V-9947A Bedienungsanleitung

Valcom

Valcom VIP-148AL-SA Syn-Apps Bedienungsanleitung

Valcom

Valcom IP Solutions VIP-9880 Bedienungsanleitung

Valcom

Valcom V-1050C Bedienungsanleitung

Valcom

Valcom VIP-480AL-SA Bedienungsanleitung

Valcom

Valcom VIP-480AL-IC Bedienungsanleitung

Valcom

Valcom V-1050C Bedienungsanleitung

Valcom

Valcom V-1030M Bedienungsanleitung

Valcom

Valcom V-1038 Bedienungsanleitung

Beliebte Horn Handbücher anderer Marken

Elk Products

Elk Products 45 Bedienungsanleitung

Cooper Wheelock

Cooper Wheelock DB3 Series Bedienungsanleitung

Altec Lansing

Altec Lansing 811B HF HORN Bedienungsanleitung

RF Elements

RF Elements UltraHorn CC Series Bedienungsanleitung

Edwards Signaling

Edwards Signaling 869DSTR-G1 Series Montageanleitung

Electro-Voice

Electro-Voice HPT94 Bedienungsanleitung

Toa

Toa LE-M124 Bedienungsanleitung

EAW

EAW MR-102B Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR MH30 Bedienungsanleitung

Pequod

Pequod TWISTER 3.1 Bedienungsanleitung

United Pacific

United Pacific 46151 Bedienungsanleitung

Wolo

Wolo OCEAN ALERT 170 Bedienungsanleitung

Vixen Horns

Vixen Horns VXO8315B/4114B Bedienungsanleitung

Altec

Altec 151A PAGING HORN Bedienungsanleitung

aidapt

aidapt VM953 Programmierhandbuch

auna

auna MEG1-HY Bedienungsanleitung

ACR Electronics

ACR Electronics ACR-EM-1A - REV Y Montageanleitung

Behringer

Behringer Eurosound Megaphone XT Bedienungsanleitung