3.0 SETTING THE NETWORK CAMERA OVER THE LAN
Steps:
Set the IP address of the camera for accessing via LAN.
Purpose:
To view and configure the camera via LAN (Local Area Network), you need to connect the network camera in the same
subnet with your PC. Then, install the SADP or iVMS-4200 software to search and change the IP of network camera.
The following figure shows the cable connection of network camera and PC:
Figure 3-1 Wiring over LAN
1. To get the IP address, you can choose either of the following methods:
yUse SADP, a software tool which can automatically detect network camera in the LAN and list the device
information like IP address, subnet mask, port number, device serial number, device version, etc., shown in
Figure 3-2.
yUse iVMS-4200 software and to list the online devices. Please refer to the user manual of client software for
detailed information.
2. Change the IP address and subnet mask to the same subnet as of your PC.
Refer to the following introductions to set IP address with SADP software:
ySearch active devices online
Search online devices automatically:
After launch the SADP software, it automatically searches the online devices every 15 seconds from the
subnet where your computer locates. It displays the total number and information of the searched devices in
the Online Devices interface. Device information including the device type, IP address, port number, gateway,
etc. will be displayed.
