each use, it is necessary to check for leaks and looseness
49. Check for leaks even if your unit was assembled for you by someone else.
Do NOT operate if a gas leak is present. Gas leaks may cause a fire or explosion.
50. You must follow all instructions in the“Checking for Leaks”section before
operating. To prevent fire or explosion hazard when testing for a leak:
51. Always perform a leak test before lighting the product and each time the
cylinder is connected for use.
52. No smoking. Do NOT use or permit sources of ignition in the area while
conducting a leak test.
53. Conduct the leak test outdoors in a well-ventilated area.
54. Do NOT use matches, lighters, or a flame to check for leaks.
55. The use of alcohol, prescription or non-prescription drugs may impair the
consumer’s ability to properly assemble or safely operate the appliance. Strong
odors, colds, sinus congestion, etc. may prevent the detection of propane. Use
caution and common sense when testing for leaks.
56. Do NOT use product until any and all leaks are corrected.
57. If you are unable to stop a leak, disconnect the LP gas supply. Call a gas
appliance serviceman or your local LP gas supplier.
58. Do NOT store or use gasoline or other flammable liquids or vapors
within 25 feet (7.62 m) of this appliance.
59. Do NOT use in an explosive atmosphere. Keep product area clear and
free from combustible materials, gasoline and other flammable vapors and liquids.
Minimum clearance from sides and back of unit to combustible
construction is 36 inches (91.4 cm). Do NOT use this appliance under any type of
overhang or roof.
60. It is essential to keep the product’s valve compartment, burners and
circulating air passages clean.
Inspect product before each use.
61. Do NOT alter product in any manner. Any alteration will void your warranty.
