Victaulic FireLock 912 Service-Handbuch

I-912_1

FireLock®Low-Profile Sprinkler Outlet-T

STYLE 912

I-912INSTALLATION INSTRUCTIONS

www.victaulic.com

REV_A

The Style 912 FireLock®Low-Profile Sprinkler Outlet-T is designed for direct connection of sprinkler heads and is FM Approved up to

300 psi/2068 kPa and VdS and LPCB Approved up to 16 Bar/232psi at ambient temperatures that are typical for fire protection systems.

PRODUCT DATA

Nominal Size

inches/Actual mm

Hole

Diameter

Approximate

Weight Each

Run x Branch FPT†

+0.06/+1,5

–0.00/–0,0 V W Y Z lbs/kg

1x½⁄ 1.00 0.90 3.72 1.50 0.67

33.7 15.0 24.0 25.4 22.9 94.6 38.1 0.30

1 ¼ x½⁄ 1.17 1.10 4.12 1.50 0.74

42.4 15.0 24.0 29.8 27.9 104.7 38.1 0.33

1 ½ x½⁄ 1.29 1.22 4.32 1.50 0.76

48.3 15.0 24.0 32.8 31.0 109.8 38.1 0.34

† Style 912 Low-Profile Sprinkler Outlet-T products are designed with female threads to ISO 7-Rp ½

(Rp ½ BSPP per BS21) and can accommodate only male sprinkler threads.

FOR SPRINKLER USE ONLY. DO NOT USE AS A BRANCH OUTLET.

WARNING

Read and understand all instructions before attempting to install any Victaulic piping products.•

Wear safety glasses, hardhat, and foot protection.•

Depressurize and drain the piping system before attempting to install, remove, adjust, or maintain any Victaulic piping products.•

Failure to follow these instructions could result in serious personal injury and/or property damage.

I-912_2

FireLock®Low-Profile Sprinkler Outlet-T

STYLE 912

I-912

INSTALLATION INSTRUCTIONS

www.victaulic.com

REV_A

PIPE PREPARATION

NOTICE

Victaulic hole cutting tools are recommended for proper hole•

preparation.

1. Cut a ⁄-inch/24.0-mm hole on the centerline of the pipe.

¼ inch/6 mm

Exaggerated for clarity

2. Ensure that a ¼-inch/6-mm area around the hole is clean, smooth,

and free from indentations and/or projections that could affect

gasket sealing (refer to the sketch above). Remove any burrs and

sharp or rough edges from the hole that might affect assembly,

proper seating of the locating collar, flow from the outlet, or gasket

seating.

INSTALLATION

1. Make sure the gasket is seated fully in the gasket pocket. DO NOT

LUBRICATE THE GASKET.

2. Remove the flange nut and bolt from one side of the Style 912

assembly. Thread the remaining flange nut loosely onto the bolt

(flange nut should be flush with end of bolt) to allow for the

“swing-over” feature.

3. Install the outlet housing onto the pipe by centering the locating

collar in the hole. To check for proper engagement, slide the outlet

housing back and forth while pushing down. A properly positioned

outlet housing can be moved only a small amount in any direction.

3a. Rotate the lower housing around the pipe, while holding the outlet

housing in place to make sure the locating collar remains seated

properly in the hole.

4. Insert the other track bolt into the lower housing and outlet

housing. Thread the flange nut onto the bolt finger-tight. Make sure

the track heads of the bolts seat properly in the bolt holes.

I-912_3

FireLock®Low-Profile Sprinkler Outlet-T

STYLE 912

I-912INSTALLATION INSTRUCTIONS

www.victaulic.com

REV_A

5. Tighten the flange nuts evenly to an approximate torque value of

20 ft-lbs/27.1-N•m to ensure proper gasket compression. NOTE:

To avoid over-tightening the flange nuts, use a wrench with a

maximum length of 8 inches/200mm. DO NOT over-tighten the

flange nuts.

The outlet housing, near the gasket, should not make metal-to-metal

contact with the pipe. In addition, a small bolt pad gap is expected

between the outlet housing and the lower housing, as shown above.

WARNING

DO NOT over-tighten the flange nuts. Over-tightening the•

flange nuts can over-compress the gasket and distort the outlet

housing and lower housing. Over-tightening does not enhance

product performance.

Failure to follow this instruction could cause product failure,

resulting in serious personal injury and/or property damage.

I-912

FireLock®Low-Profile Sprinkler Outlet-T

STYLE 912

I-912INSTALLATION INSTRUCTIONS

For complete contact information, visit www.victaulic.com

I-912 5372 REV A Z000912000 UPDATED 11/2008

WCAS-7HHHTM

Andere Victaulic Steuereinheit Handbücher

Victaulic

Victaulic FireLock NXT 776 Series Bedienungsanleitung

Victaulic

Victaulic 769N FireLock NXT Series Bedienungsanleitung

Victaulic

Victaulic KOIL-KIT 799 Series Bedienungsanleitung

Victaulic

Victaulic FireLock NXT 769 Series Bedienungsanleitung

Victaulic

Victaulic I-869E-3D Bedienungsanleitung

Victaulic

Victaulic 867-7UF Bedienungsanleitung

Victaulic

Victaulic 768N FireLock NXT Series Bedienungsanleitung

Victaulic

Victaulic FireLock 758 Series Bedienungsanleitung

Victaulic

Victaulic 751 FireLock Series Bedienungsanleitung

Victaulic

Victaulic 5-Year Rebuild Kit Bedienungsanleitung

Victaulic

Victaulic 751 Series Bedienungsanleitung

Victaulic

Victaulic 795 Series Bedienungsanleitung

Victaulic

Victaulic 769N FireLock NXT Series Bedienungsanleitung

Victaulic

Victaulic FireLock 247 Series Bedienungsanleitung

Victaulic

Victaulic KOIL-KIT 799 Series Bedienungsanleitung

Victaulic

Victaulic FireLock NXT 769 Series Bedienungsanleitung

Victaulic

Victaulic 867-4UF Bedienungsanleitung

Victaulic

Victaulic 725S Series Bedienungsanleitung

Victaulic

Victaulic FireLock NXT 768 Series Bedienungsanleitung

Victaulic

Victaulic FireLock 758-LPA Series Bedienungsanleitung

Victaulic

Victaulic FireLock I-756 Series Bedienungsanleitung

Victaulic

Victaulic Vic-300 MasterSeal 761 Series Bedienungsanleitung

Victaulic

Victaulic 751 FireLock Series Bedienungsanleitung

Victaulic

Victaulic 317 Series Bedienungsanleitung

Beliebte Steuereinheit Handbücher anderer Marken

Festo

Festo Compact Performance CP-FB6-E Stücklistenhandbuch

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung

JS Automation

JS Automation MPC3034A Bedienungsanleitung

JAUDT

JAUDT SW GII 6406 Series Kurzanleitung

Spektrum

Spektrum Air Module System Bedienungsanleitung

BOC Edwards

BOC Edwards Q Series Bedienungsanleitung

KHADAS

KHADAS BT Magic Bedienungsanleitung

Etherma

Etherma eNEXHO-IL Bedienungsanleitung

PMFoundations

PMFoundations Attenuverter Bedienungsanleitung

GEA

GEA VARIVENT Bedienungsanleitung

Walther Systemtechnik

Walther Systemtechnik VMS-05 Bedienungsanleitung

Altronix

Altronix LINQ8PD Montageanleitung

Eaton

Eaton Powerware Series Bedienungsanleitung

WAGO

WAGO 750-407/040-000 Bedienungsanleitung

Sony

Sony CCU-590 Bedienungsanleitung

Graco

Graco 25D614 Bedienungsanleitung

Task Force Tips

Task Force Tips YE-RF-900 Programmierhandbuch

Shini

Shini SPV-U Series Bedienungsanleitung