Color CCD Camera operating manual
Page 2 of 4
INTRODUCTION:
Thank you for choosing our GP020101/GP020111 CCD COLOR Camera.
VIEWSOLUTIONS hopes that both the quality and design satisfy your requirements.
Before proceeding to install or operate the GP020101/GP020111, please read and understand thoroughly the
contents of this Operation manual.
For future reference we also advise safe keeping of this manual.
CAUTIONS:
1. Power supplied without voltage stabilization and /or the voltage range maintained at ±10% 12V. DC. may cause
damage.
2. Do not expose the CCD Camera to wetness or high moisture conditions. The CCD Camera is designed and
approved for indoor use only.
If the location of the camera is outdoors or in an outdoor like environment, we recommend that you use an OUTDOOR
CAMERA HOUSING.
3. Avoid the striking of hard objects or dropping the unit.
4. Do not disassemble and /or modify the CCD Camera or any of its component parts or accessories.
VIEWSOLUTIONS can not be held responsible for equipment failure or any damage and /or trouble caused by such
action.
5. Do not install the CCD Camera near heat sources, such as radiators or heating air ducts, or in a position subject to
direct sunlight※, excessive dust, mechanical vibration or shock.
6. When installing the CCD Camera in an industrial or commercial environment (i.e. within equipment housing, near
other electronic device, etc.) Make sure to avoid any strong electromagnetic field, otherwise the video output may be
disturbed and monitor clearness compromised.
7. Do not connect any power supply directly to the VIDEO OUT terminal of the unit. This may cause damage.
8. When a cable operation system, such as video/power multiplex transmission is being used, check the
specifications or requirements of your monitor for proper connection with the video signal terminal of the camera.
9. Do not make connections and /or operate the CCD Camera with wet hands.
10. Should the CCD Camera not work properly, switch off the power and then, check that power and video terminals
are properly connected.
※Sunlight shining directly onto the camera lens can cause damage to the CCD.
CONTENT:
Using the contents figures below, check to make sure all parts are present before use
