ViewSonic VS15741 Bedienungsanleitung

SD-T225

Thin Client Monitor

User Guide

Model No. VS15741

IMPORTANT: Please read this User Guide to obtain important information on installing

and using your product in a safe manner, as well as registering your product for future

service. Warranty information contained in this User Guide will describe your limited

coverage from ViewSonic Corporation, which is also found on our web site at http://

www.viewsonic.com in English, or in specic languages using the Regional selection

box in the upper right corner of our website. “Antes de operar su equipo lea cu

idadosamente las instrucciones en este manual”

Compliance Information

NOTE: This section addresses all connected requirements and statements regarding

regulations. Confirmed corresponding applications shall refer to nameplate labels

and relevant markings on unit.

FCC Compliance Statement

This device complies with part 15 of FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency

energy, and if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Warning: You are cautioned that changes or modifications not expressly approved

by the party responsible for compliance could void your authority to operate the

equipment.

Industry Canada Statement

CAN ICES-3(B)/NMB-3(B)

Following information is only for EU-member states:

The mark shown to the right is in compliance with the Waste Electrical and

Electronic Equipment Directive 2002/96/EC (WEEE).The mark indicates

the requirement NOT to dispose the equipment as unsorted municipal

waste, but use the return and collection systems according to local law.

Declaration of RoHS2 Compliance

This product has been designed and manufactured in compliance with Directive

2011/65/EU of the European Parliament and the Council on restriction of the use

of certain hazardous substances in electrical and electronic equipment (RoHS2

Directive) and is deemed to comply with the maximum concentration values issued

by the European Technical Adaptation Committee (TAC) as shown below:

Substance

Proposed Maximum

Concentration

Actual Concentration

Lead (Pb) 0.1% < 0.1%

Mercury (Hg) 0.1% < 0.1%

Cadmium (Cd) 0.01% < 0.01%

Hexavalent Chromium (Cr6+) 0.1% < 0.1%

Polybrominated biphenyls (PBB) 0.1% < 0.1%

Polybrominated diphenyl ethers (PBDE) 0.1% < 0.1%

Certain components of products as stated above are exempted under the Annex III

of the RoHS2 Directives as noted below:

Examples of exempted components are:

1. Mercury in cold cathode uorescent lamps and external electrode uorescent

lamps (CCFL and EEFL) for special purposes not exceeding (per lamp):

(1) Short length (≦500 mm): maximum 3.5 mg per lamp.

(2) Medium length (＞500 mm and ≦1,500 mm): maximum 5 mg per lamp.

(3) Long length (＞1,500 mm): maximum 13 mg per lamp.

2. Lead in glass of cathode ray tubes.

3. Lead in glass of uorescent tubes not exceeding 0.2% by weight.

4. Lead as an alloying element in aluminium containing up to 0.4% lead by weight.

5. Copper alloy containing up to 4% lead by weight.

6. Lead in high melting temperature type solders (i.e. lead-based alloys containing

85% by weight or more lead).

7. Electrical and electronic components containing lead in a glass or ceramic other

than dielectric ceramic in capacitors, e.g. piezoelectronic devices, or in a glass or

ceramic matrix compound.

iii

Cautions and Warnings

1. Read these instructions completely before using the equipment.

2. Keep these instructions in a safe place.

3. Heed all warnings and follow all instructions.

4. Sit at least 18” / 45cm from the Thin Client Monitor.

5. Always handle the Thin Client Monitor with care when moving it.

6. Never remove the rear cover. This Thin Client Monitor contains high-voltage

parts. You may be seriously injured if you touch them.

7. Do not use this equipment near water. Warning: To reduce the risk of fire or

electric shock, do not expose this apparatus to rain or moisture.

8. Avoid exposing the Thin Client Monitor to direct sunlight or another heat source.

Orient the Thin Client Monitor away from direct sunlight to reduce glare.

9. Clean with a soft, dry cloth. If further cleaning is required, see “Cleaning the

Display” in this guide for further instructions.

10. Avoid touching the screen. Skin oils are difficult to remove.

11. Do not rub or apply pressure to the LCD panel, as it may permanently damage

the screen.

12. Do not block any ventilation openings. Install the equipment in accordance with

the manufacturer’s instructions.

13. Do not install near any heat sources such as radiators, heat registers, stoves, or

other devices (including amplifiers) that produce heat.

14. Place the Thin Client Monitor in a well ventilated area. Do not place anything on

the Thin Client Monitor that prevents heat dissipation.

15. Do not place heavy objects on the Thin Client Monitor, video cable, or power

cord.

16. If smoke, an abnormal noise, or a strange odor is present, immediately switch

the Thin Client Monitor off and call your dealer or ViewSonic. It is dangerous to

continue using the Thin Client Monitor.

17. Do not attempt to circumvent the safety provisions of the polarized or grounding-

type plug. A polarized plug has two blades with one wider than the other. A

grounding type plug has two blades and a third grounding prong. The wide blade

and the third prong are provided for your safety. If the plug does not fit into your

outlet, consult an electrician for replacement of the outlet.

18. Protect the power cord from being tread upon or pinched, particularly at the plug,

and the point where if emerges from the equipment. Be sure that the power outlet

is located near the equipment so that it is easily accessible.

19. Only use attachments/accessories specified by the manufacturer.

(Continued on next page)

20. Use only with the cart, stand, tripod, bracket, or table specified by

the manufacturer, or sold with the equipment. When a cart is used,

use caution when moving the cart/equipment combination to avoid

injury from tipping over.

21. Unplug this equipment when it will be unused for long periods of time.

22. Refer all servicing to qualified service personnel. Service is required when the

unit has been damaged in any way, such as: if the power-supply cord or plug is

damaged, if liquid is spilled onto or objects fall into the unit, if the unit is exposed

to rain or moisture, or if the unit does not operate normally or has been dropped.

Contents

Compliance Information

FCC Compliance Statement...................................................................................i

Industry Canada Statement....................................................................................i

Declaration of RoHS2 Compliance........................................................................ii

Cautions and Warnings ........................................................................................ iii

Product Registration..............................................................................................2

For Your Records ..................................................................................................2

Getting Started

Package Contents .................................................................................................3

Quick Installation ...................................................................................................4

Additional Software Installation (Optional).............................................................4

Wall Mounting (Optional).......................................................................................5

Using the Thin Client Monitor

Setting the Timing Mode........................................................................................6

OSD and Power Lock Settings..............................................................................6

Adjusting the Screen Image ..................................................................................7

Main Menu Controls ..............................................................................................8

Main Menu Explanation.........................................................................................8

Landscape/Portrait Modes...................................................................................10

To Raise and Lower the display ..........................................................................10

Client System

Client Power Control............................................................................................11

Quick Connection ................................................................................................11

Desktop Mode .....................................................................................................16

Client Network IP Setting.....................................................................................24

Start Local Firmware Update...............................................................................25

Other Information

Specifications ......................................................................................................29

Cleaning the Thin Client Monitor .........................................................................31

Troubleshooting...................................................................................................32

Customer Support ...............................................................................................33

Limited Warranty ................................................................................................34

Macintosh and Power Macintosh are registered trademarks of Apple Inc.

Microsoft, Windows, and the Windows logo are registered trademarks of Microsoft

Corporation in the United States and other countries.

ViewSonic, the three birds logo, OnView, ViewMatch, and ViewMeter are registered

trademarks of ViewSonic Corporation.

VESA is a registered trademark of the Video Electronics Standards Association.

DPMS, DisplayPort, and DDC are trademarks of VESA.

Disclaimer: ViewSonic Corporation shall not be liable for technical or editorial errors

or omissions contained herein; nor for incidental or consequential damages resulting

from furnishing this material, or the performance or use of this product.

In the interest of continuing product improvement, ViewSonic Corporation reserves

the right to change product specifications without notice. Information in this

document may change without notice.

No part of this document may be copied, reproduced, or transmitted by any means,

for any purpose without prior written permission from ViewSonic Corporation.

Product Registration

To fulfill possible future product needs, and to receive additional product information

as it becomes available, please visit your region section on ViewSonic’s website to

For Your Records

Product Name:

Model Number:

Document Number:

Serial Number:

Purchase Date:

SD-T225

ViewSonic Thin Client Monitor

VS15741

SD-T225_UG_ENG Rev. 1A 03-07-14

Product disposal at end of product life

ViewSonic respects the environment and is committed to working and living green.

Thank you for being part of Smarter, Greener Computing.

Please visit ViewSonic website to learn more.

USA & Canada: http://www.viewsonic.com/company/green/recycle-program/

Europe: http://www.viewsoniceurope.com/uk/support/recycling-information/

Taiwan: http://recycle.epa.gov.tw/recycle/index2.aspx

Getting Started

Important! Save the original box and all packing material for future shipping needs.

NOTE: The word “Windows” in this user guide refers to Microsoft Windows operating

system.

Package Contents

Your Thin Client Monitor package includes:

• Thin Client Monitor

• Power cord

• D-Sub cable

• Compliance Information Brochure

• Quick Start Guide

• ViewSonic Optical Disk

- User Guide

- INF/ICM files*

- Registration information

- Additional software (Optional)

NOTE: The INF file ensures compatibility with Windows operating systems, and

the ICM file (Image Color Matching) ensures accurate on-screen colors. ViewSonic

recommends that you install both the INF and ICM files.

Quick Installation

1. Connect video cable

2. Connect power cord (and AC/DC adapter if required)

3. Turn ON Thin Client Monitor

Additional Software Installation (Optional)

1. Load the ViewSonic Optical Disk on your CD/DVD drive.

2. Double click on the "Software" folder and choose an application, if desired.

3. Double click on the Setup.exe file and follow the on-screen instructions to

complete the simple installation.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ViewSonic Monitor Handbücher

ViewSonic

ViewSonic VP2130b-1 VS10773 Bedienungsanleitung

ViewSonic

ViewSonic LCD DISPLAY VS13390 Bedienungsanleitung

ViewSonic

ViewSonic VE710b-1 Bedienungsanleitung

ViewSonic

ViewSonic VA2333-LED Bedienungsanleitung

ViewSonic

ViewSonic ViewPanel VG170m Bedienungsanleitung

ViewSonic

ViewSonic Q71 - Optiquest - 17" CRT Display Bedienungsanleitung

ViewSonic

ViewSonic Optiquest Q191wb Kurzanleitung

ViewSonic

ViewSonic VG500b-1 Bedienungsanleitung

ViewSonic

ViewSonic VX1940W - 19" LCD Monitor Bedienungsanleitung

ViewSonic

ViewSonic Q201WB - Optiquest - 20" LCD Monitor Bedienungsanleitung

ViewSonic

ViewSonic VP920B - ThinEdge - 19" LCD Monitor Bedienungsanleitung

ViewSonic

ViewSonic VX2265wm - FuHzion - 22" LCD Monitor Bedienungsanleitung

ViewSonic

ViewSonic VG2438Sm Bedienungsanleitung

ViewSonic

ViewSonic VA700 Bedienungsanleitung

ViewSonic

ViewSonic PD1631 Bedienungsanleitung

ViewSonic

ViewSonic VP2771 Bedienungsanleitung

ViewSonic

ViewSonic VX910 - 19" LCD Monitor Bedienungsanleitung

ViewSonic

ViewSonic VA930-1 VLCDS24020-1W Bedienungsanleitung

ViewSonic

ViewSonic E70B Bedienungsanleitung

ViewSonic

ViewSonic LDS135-151 Bedienungsanleitung

ViewSonic

ViewSonic ViewPanel VE170 Bedienungsanleitung

ViewSonic

ViewSonic VS11444 Bedienungsanleitung

ViewSonic

ViewSonic VA2709M Bedienungsanleitung

ViewSonic

ViewSonic VX2780J-2K Bedienungsanleitung

Beliebte Monitor Handbücher anderer Marken

Linear Acoustic

Linear Acoustic LQ-1000 Bedienungsanleitung

AOC

AOC I2579V Bedienungsanleitung

Gateway

Gateway FPD1520 Bedienungsanleitung

Furuno

Furuno Mu 120c Bedienungsanleitung

Asus

Asus VB171D - 17" LCD Monitor Bedienungsanleitung

Dell

Dell S2230MX Gebrauchsanweisung

Philips

Philips 107C64 Bedienungsanleitung

Dell

Dell S2409WFP Bedienungsanleitung

EverFocus

EverFocus EN-7517E Bedienungsanleitung

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Bedienungsanleitung

Dell

Dell Precision 7680 Bedienungsanleitung

LG 50PM1M - - 50" Plasma Panel Bedienungsanleitung

Bosch

Bosch DDU 9 Bedienungsanleitung

Acer

Acer A231HL Bedienungsanleitung

Philips

Philips 86BDL4152T Bedienungsanleitung

NEC

NEC AccuSync LCD5V Bedienungsanleitung

Emay

Emay SleepO2 Bedienungsanleitung

IBM

IBM 6360 Montageanleitung