Features:
High sensitivity, CMOS OV2710 sensor
Use Hisilicon 3516C chip
Highest pixel is 2.0M, highest resolution is 1080P(1920x1080)
Optimized H.264 compression algorithm, support two code stream（main stream, sub-stream）,
support multiple mobile monitoring（iPhone,Android）
Support multiple network agreement：support RTSP/FTP/PPPOE/DHCP/DDNS/NTP/UPnP
etc;
Support ONVIF agreement
Support TUTK platform
Support manufacturer and other DNS analysis
Support pictures of alarm send E-Mail（alarm can take three consecutive pictures）
Support pictures of alarm and recordings uploaded to FTP servicer
Support pictures of timing captured to FTP servicer
Support static IP, as well as dynamic IP（DHCP）
Support CMS
Support IE, Google, Firefox browser
Built-in Web Server convenient for users to use standard IE browser ensure the previous timing
scan and setting management
Support 12 users to view at the same time（support 4 users for each code stream）
Provide motion detect（area/sensitivity available to set）alarm function
Support 10M/100M network adapt itself
Support UPNP auto port mapping
With ICR, pass the EN50155 Vibration Test.
Easy installation and angle adjustment
Cautions:
(a) In order to protect the camera, please avoid placing or using the camera under direct sunlight
(b) Please ensure that the input voltage range is within the specifications.
(c) Please do not place the camera in a location with a temperature exceeding 50ºC.
(d) Do not attempt to service the camera by yourself. Please refer all services to qualified Dealers.
Packing list:
Camera 1
Instruction Manual 1
Self Drilling Screw 4
Hex-Key 1
Connection mode:
In Figure 1, the normal connection cable to the RJ45 port and DC port.
Figure 1 Figure 2 (POE power supply)
When choosing the models with POE, as shown in Figure 2, only the cable into the RJ45 port,
note that the cable is an international standard with 48V
Operation procedures:
1. Loosen the lock screws
2. Attach the mounting base to the wall or ceiling, wherever you want to install the camera. Locate
a wall stud or ceiling joint and secure the base by the supplied mounting screws.
3. Connect the 4 ways male din jack to the female jack on the cable, when picture shown up on the
monitor.
4. Make the ball camera to the suitable position.
5. Fix the ball camera, then lock the screw .
